[<prev] [next>] [thread-next>] [day] [month] [year] [list]
Message-Id: <20180726174050.8923-1-jeffrey.t.kirsher@intel.com>
Date: Thu, 26 Jul 2018 10:40:44 -0700
From: Jeff Kirsher <jeffrey.t.kirsher@...el.com>
To: davem@...emloft.net
Cc: Jeff Kirsher <jeffrey.t.kirsher@...el.com>, netdev@...r.kernel.org,
nhorman@...hat.com, sassmann@...hat.com, jogreene@...hat.com
Subject: [net-next 0/6][pull request] 10GbE Intel Wired LAN Driver Updates 2018-07-26
This series contains updates to ixgbe and igb.
Tony fixes ixgbe to add checks to ensure jumbo frames or LRO get enabled
after an XDP program is loaded.
Shannon Nelson adds the missing security configuration registers to the
ixgbe register dump, which will help in debugging.
Christian Grönke fixes an issue in igb that occurs on SGMII based SPF
mdoules, by reverting changes from 2 previous patches. The issue was
that initialization would fail on the fore mentioned modules because the
driver would try to reset the PHY before obtaining the PHY address of
the SGMII attached PHY.
Venkatesh Srinivas replaces wmb() with dma_wmb() for doorbell writes,
which avoids SFENCEs before the doorbell writes.
Alex cleans up and refactors ixgbe Tx/Rx shutdown to reduce time needed
to stop the device. The code refactor allows us to take the completion
time into account when disabling queues, so that on some platforms with
higher completion times, would not result in receive queues disabled
messages.
The following are changes since commit dc66fe43b7ebdb53628dcbc1f8f15de3e000aacf:
rds: send: Fix dead code in rds_sendmsg
and are available in the git repository at:
git://git.kernel.org/pub/scm/linux/kernel/git/jkirsher/next-queue 10GbE
Alexander Duyck (2):
ixgbe: Reorder Tx/Rx shutdown to reduce time needed to stop device
ixgbe: Refactor queue disable logic to take completion time into
account
Christian Grönke (1):
igb: Remove superfluous reset to PHY and page 0 selection
Shannon Nelson (1):
ixgbe: add ipsec security registers into ethtool register dump
Tony Nguyen (1):
ixgbe: Do not allow LRO or MTU change with XDP
Venkatesh Srinivas (1):
igb: Use dma_wmb() instead of wmb() before doorbell writes
drivers/net/ethernet/intel/igb/e1000_82575.c | 12 -
drivers/net/ethernet/intel/igb/igb_main.c | 4 +-
drivers/net/ethernet/intel/ixgbe/ixgbe.h | 3 +-
.../net/ethernet/intel/ixgbe/ixgbe_ethtool.c | 42 +--
drivers/net/ethernet/intel/ixgbe/ixgbe_main.c | 300 ++++++++++++++----
5 files changed, 250 insertions(+), 111 deletions(-)
--
2.17.1
Powered by blists - more mailing lists