Message-ID: <20190206114523.8954-3-pankaj.bansal@nxp.com>
Date:   Wed, 6 Feb 2019 06:20:40 +0000
From:   Pankaj Bansal <pankaj.bansal@....com>
To:     Andrew Lunn <andrew@...n.ch>,
        Florian Fainelli <f.fainelli@...il.com>
CC:     "netdev@...r.kernel.org" <netdev@...r.kernel.org>,
        Pankaj Bansal <pankaj.bansal@....com>
Subject: [PATCH v4 2/2] netdev/phy: add MDIO bus multiplexer driven by a
 regmap

Add support for an MDIO bus multiplexer controlled by a regmap
device, like an FPGA.

Tested on a NXP LX2160AQDS board which uses the "QIXIS" FPGA
attached to the i2c bus.

Signed-off-by: Pankaj Bansal <pankaj.bansal@....com>
---

Notes:
    V4:
    - Use IS_ENABLED macro in mdio-mux.h
    V3:
    - make the return type of uninit function to void
    - reorder the Make file change to be alphabetically sorted
    - fix the compilation error when mdio-mux-regmap is built as module
      by adding CONFIG_MDIO_BUS_MUX_REGMAP_MODULE macro in mdio-mux.h
    V2:
    - Added Kconfig entry for regmap based mdio mux
    - restrict the comment lines to 80 chars
    - use kerneldoc formatting for this function documentation.

 drivers/net/phy/Kconfig           |  14 +++
 drivers/net/phy/Makefile          |   1 +
 drivers/net/phy/mdio-mux-regmap.c | 169 ++++++++++++++++++++++++++++
 include/linux/mdio-mux.h          |  33 ++++++
 4 files changed, 217 insertions(+)

diff --git a/drivers/net/phy/Kconfig b/drivers/net/phy/Kconfig
index 3d187cd50eb0..93ef2505caba 100644
--- a/drivers/net/phy/Kconfig
+++ b/drivers/net/phy/Kconfig
@@ -87,6 +87,20 @@ config MDIO_BUS_MUX_MMIOREG
 
 	  Currently, only 8/16/32 bits registers are supported.
 
+config MDIO_BUS_MUX_REGMAP
+	tristate "regmap device controlled MDIO bus multiplexers"
+	depends on OF_MDIO && REGMAP
+	select MDIO_BUS_MUX
+	help
+	  This module provides a driver for MDIO bus multiplexers that
+	  are controlled via a regmap device, like an FPGA connected to i2c bus
+	  or spi bus or memory mapped FPGA.
+	  The multiplexer connects one of several child MDIO busses to a
+	  parent bus.  Child bus selection is under the control of one of
+	  the FPGA's registers.
+
+	  Currently, only 32 bits registers are supported.
+
 config MDIO_CAVIUM
 	tristate
 
diff --git a/drivers/net/phy/Makefile b/drivers/net/phy/Makefile
index 5805c0b7d60e..99737128de8a 100644
--- a/drivers/net/phy/Makefile
+++ b/drivers/net/phy/Makefile
@@ -29,6 +29,7 @@ obj-$(CONFIG_MDIO_BUS_MUX)	+= mdio-mux.o
 obj-$(CONFIG_MDIO_BUS_MUX_BCM_IPROC)	+= mdio-mux-bcm-iproc.o
 obj-$(CONFIG_MDIO_BUS_MUX_GPIO)	+= mdio-mux-gpio.o
 obj-$(CONFIG_MDIO_BUS_MUX_MMIOREG) += mdio-mux-mmioreg.o
+obj-$(CONFIG_MDIO_BUS_MUX_REGMAP)	+= mdio-mux-regmap.o
 obj-$(CONFIG_MDIO_CAVIUM)	+= mdio-cavium.o
 obj-$(CONFIG_MDIO_GPIO)		+= mdio-gpio.o
 obj-$(CONFIG_MDIO_HISI_FEMAC)	+= mdio-hisi-femac.o
diff --git a/drivers/net/phy/mdio-mux-regmap.c b/drivers/net/phy/mdio-mux-regmap.c
new file mode 100644
index 000000000000..bbec43b30f3c
--- /dev/null
+++ b/drivers/net/phy/mdio-mux-regmap.c
@@ -0,0 +1,169 @@
+// SPDX-License-Identifier: GPL-2.0+
+
+/* Simple regmap based MDIO MUX driver
+ *
+ * Copyright 2018-2019 NXP
+ *
+ * Based on mdio-mux-mmioreg.c by Timur Tabi
+ *
+ * Author:
+ *     Pankaj Bansal <pankaj.bansal@....com>
+ */
+
+#include <linux/platform_device.h>
+#include <linux/device.h>
+#include <linux/of_mdio.h>
+#include <linux/module.h>
+#include <linux/phy.h>
+#include <linux/mdio-mux.h>
+#include <linux/regmap.h>
+
+struct mdio_mux_regmap_state {
+	void		*mux_handle;
+	struct device	*dev;
+	struct regmap	*regmap;
+	u32		mux_reg;
+	u32		mask;
+};
+
+/**
+ * mdio_mux_regmap_switch_fn - This function is called by the mdio-mux layer
+ *			       when it thinks the mdio bus multiplexer needs
+ *			       to switch.
+ * @current_child:  current value of the mux register (masked via s->mask).
+ * @desired_child: value of the 'reg' property of the target child MDIO node.
+ * @data: Private data used by this switch_fn passed to mdio_mux_init function
+ *	  via mdio_mux_init(.., .., .., .., data, ..).
+ *
+ * The first time this function is called, current_child == -1.
+ * If current_child == desired_child, then the mux is already set to the
+ * correct bus.
+ */
+static int mdio_mux_regmap_switch_fn(int current_child, int desired_child,
+				     void *data)
+{
+	struct mdio_mux_regmap_state *s = data;
+	bool change;
+	int ret;
+
+	ret = regmap_update_bits_check(s->regmap,
+				       s->mux_reg,
+				       s->mask,
+				       desired_child,
+				       &change);
+
+	if (ret)
+		return ret;
+	if (change)
+		dev_dbg(s->dev, "%s %d -> %d\n", __func__, current_child,
+			desired_child);
+	return ret;
+}
+
+/**
+ * mdio_mux_regmap_init - control MDIO bus muxing using regmap constructs.
+ * @dev: device with which regmap construct is associated.
+ * @mux_node: mdio bus mux node that contains parent mdio bus phandle.
+ *	      This node also contains sub nodes, where each subnode denotes
+ *	      a child mdio bus. All the child mdio buses are muxed, i.e. at a
+ *	      time only one of the child mdio buses can be used.
+ * @data: to store the address of data allocated by this function
+ */
+int mdio_mux_regmap_init(struct device *dev,
+			 struct device_node *mux_node,
+			 void **data)
+{
+	struct device_node *child;
+	struct mdio_mux_regmap_state *s;
+	int ret;
+	u32 val;
+
+	dev_dbg(dev, "probing node %pOF\n", mux_node);
+
+	s = devm_kzalloc(dev, sizeof(*s), GFP_KERNEL);
+	if (!s)
+		return -ENOMEM;
+
+	s->regmap = dev_get_regmap(dev, NULL);
+	if (IS_ERR(s->regmap)) {
+		dev_err(dev, "Failed to get parent regmap\n");
+		return PTR_ERR(s->regmap);
+	}
+
+	ret = of_property_read_u32(mux_node, "reg", &s->mux_reg);
+	if (ret) {
+		dev_err(dev, "missing or invalid reg property\n");
+		return -ENODEV;
+	}
+
+	/* Test Register read write */
+	ret = regmap_read(s->regmap, s->mux_reg, &val);
+	if (ret) {
+		dev_err(dev, "error while reading reg\n");
+		return ret;
+	}
+
+	ret = regmap_write(s->regmap, s->mux_reg, val);
+	if (ret) {
+		dev_err(dev, "error while writing reg\n");
+		return ret;
+	}
+
+	ret = of_property_read_u32(mux_node, "mux-mask", &s->mask);
+	if (ret) {
+		dev_err(dev, "missing or invalid mux-mask property\n");
+		return -ENODEV;
+	}
+
+	/* Verify that the 'reg' property of each child MDIO bus does not
+	 * set any bits outside of the 'mask'.
+	 */
+	for_each_available_child_of_node(mux_node, child) {
+		ret = of_property_read_u32(child, "reg", &val);
+		if (ret) {
+			dev_err(dev, "%pOF is missing a 'reg' property\n",
+				child);
+			of_node_put(child);
+			return -ENODEV;
+		}
+		if (val & ~s->mask) {
+			dev_err(dev,
+				"%pOF has a 'reg' value with unmasked bits\n",
+				child);
+			of_node_put(child);
+			return -ENODEV;
+		}
+	}
+
+	ret = mdio_mux_init(dev, mux_node, mdio_mux_regmap_switch_fn,
+			    &s->mux_handle, s, NULL);
+	if (ret) {
+		if (ret != -EPROBE_DEFER)
+			dev_err(dev, "failed to register mdio-mux bus %pOF\n",
+				mux_node);
+		return ret;
+	}
+
+	*data = s;
+
+	return 0;
+}
+EXPORT_SYMBOL_GPL(mdio_mux_regmap_init);
+
+/**
+ * mdio_mux_regmap_uninit - relinquish the control of MDIO bus muxing using
+ *			    regmap constructs.
+ * @data: address of data allocated by mdio_mux_regmap_init
+ */
+void mdio_mux_regmap_uninit(void *data)
+{
+	struct mdio_mux_regmap_state *s = data;
+
+	mdio_mux_uninit(s->mux_handle);
+}
+EXPORT_SYMBOL_GPL(mdio_mux_regmap_uninit);
+
+MODULE_AUTHOR("Pankaj Bansal <pankaj.bansal@....com>");
+MODULE_DESCRIPTION("regmap based MDIO MUX driver");
+MODULE_LICENSE("GPL");
+
diff --git a/include/linux/mdio-mux.h b/include/linux/mdio-mux.h
index a5d58f221939..bc358435b4b3 100644
--- a/include/linux/mdio-mux.h
+++ b/include/linux/mdio-mux.h
@@ -29,4 +29,37 @@ int mdio_mux_init(struct device *dev,
 
 void mdio_mux_uninit(void *mux_handle);
 
+#if IS_ENABLED(CONFIG_MDIO_BUS_MUX_REGMAP)
+/**
+ * mdio_mux_regmap_init - control MDIO bus muxing using regmap constructs.
+ * @dev: device with which regmap construct is associated.
+ * @mux_node: mdio bus mux node that contains parent mdio bus phandle.
+ *	      This node also contains sub nodes, where each subnode denotes
+ *	      a child mdio bus. All the child mdio buses are muxed, i.e. at a
+ *	      time only one of the child mdio buses can be used.
+ * @data: to store the address of data allocated by this function
+ */
+int mdio_mux_regmap_init(struct device *dev,
+			 struct device_node *mux_node,
+			 void **data);
+
+/**
+ * mdio_mux_regmap_uninit - relinquish the control of MDIO bus muxing using
+ *			    regmap constructs.
+ * @data: address of data allocated by mdio_mux_regmap_init
+ */
+void mdio_mux_regmap_uninit(void *data);
+#else /* IS_ENABLED(CONFIG_MDIO_BUS_MUX_REGMAP) */
+static inline int mdio_mux_regmap_init(struct device *dev,
+				       struct device_node *mux_node,
+				       void **data)
+{
+	return -ENODEV;
+}
+
+static inline void mdio_mux_regmap_uninit(void *data)
+{
+}
+#endif /* IS_ENABLED(CONFIG_MDIO_BUS_MUX_REGMAP) */
+
 #endif /* __LINUX_MDIO_MUX_H */
-- 
2.17.1

Powered by blists - more mailing lists