netdev - [PATCH v3 4/4] arm64: dts: meson: g12b: odroid-n2: add the Ethernet PHY reset line

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]

Message-Id: <20190615103832.5126-5-martin.blumenstingl@googlemail.com>
Date:   Sat, 15 Jun 2019 12:38:32 +0200
From:   Martin Blumenstingl <martin.blumenstingl@...glemail.com>
To:     linux-amlogic@...ts.infradead.org, khilman@...libre.com
Cc:     linux-kernel@...r.kernel.org, linux-arm-kernel@...ts.infradead.org,
        netdev@...r.kernel.org, linus.walleij@...aro.org, andrew@...n.ch,
        robin.murphy@....com, narmstrong@...libre.com,
        Martin Blumenstingl <martin.blumenstingl@...glemail.com>
Subject: [PATCH v3 4/4] arm64: dts: meson: g12b: odroid-n2: add the Ethernet PHY reset line

The reset line of the RTL8211F PHY is routed to the GPIOZ_15 pad.
Describe this in the device tree so the PHY framework can bring the PHY
into a known state when initializing it. GPIOZ_15 doesn't support
driving the output HIGH (to take the PHY out of reset, only output LOW
to reset the PHY is supported). The datasheet states it's an "3.3V input
tolerant open drain (OD) output pin". Instead there's a pull-up resistor
on the board to take the PHY out of reset. The GPIO itself will be set
to INPUT mode to take the PHY out of reset and LOW to reset the PHY,
which is achieved with the flags (GPIO_ACTIVE_LOW | GPIO_OPEN_DRAIN).

Acked-by: Neil Armstrong <narmstrong@...libre.com>
Tested-by: Neil Armstrong <narmstrong@...libre.com>
Signed-off-by: Martin Blumenstingl <martin.blumenstingl@...glemail.com>
---
 arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dts | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dts b/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dts
index c3e0735e6d9f..82b42c073c5e 100644
--- a/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dts
+++ b/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dts
@@ -250,6 +250,10 @@
 		/* Realtek RTL8211F (0x001cc916) */	
 		reg = <0>;
 		max-speed = <1000>;
+
+		reset-assert-us = <10000>;
+		reset-deassert-us = <30000>;
+		reset-gpios = <&gpio GPIOZ_15 (GPIO_ACTIVE_LOW | GPIO_OPEN_DRAIN)>;
 	};
 };

-- 
2.22.0