| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <20190822203039.15668-12-jeffrey.t.kirsher@intel.com>
Date: Thu, 22 Aug 2019 13:30:37 -0700
From: Jeff Kirsher <jeffrey.t.kirsher@...el.com>
To: davem@...emloft.net
Cc: Piotr Kwapulinski <piotr.kwapulinski@...el.com>,
netdev@...r.kernel.org, nhorman@...hat.com, sassmann@...hat.com,
Andrew Bowers <andrewx.bowers@...el.com>,
Jeff Kirsher <jeffrey.t.kirsher@...el.com>
Subject: [net-next v2 11/13] i40e: allow reset in recovery mode
From: Piotr Kwapulinski <piotr.kwapulinski@...el.com>
Driver waits after issuing a reset. When a reset takes too long a driver
gives up. Implemented by invoking PF reset in a loop. After defined
number of unsuccessful PF reset trials it returns error.
Without this patch PF reset fails when NIC is in recovery mode.
So make i40e_set_mac_type() public. i40e driver requires i40e_set_mac_type()
to be public. It is required for recovery mode handling. Without this patch
recovery mode could not be detected in i40e_probe().
Signed-off-by: Piotr Kwapulinski <piotr.kwapulinski@...el.com>
Tested-by: Andrew Bowers <andrewx.bowers@...el.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@...el.com>
---
drivers/net/ethernet/intel/i40e/i40e_common.c | 2 +-
drivers/net/ethernet/intel/i40e/i40e_main.c | 67 +++++++++++++++++--
.../net/ethernet/intel/i40e/i40e_prototype.h | 2 +
3 files changed, 63 insertions(+), 8 deletions(-)
diff --git a/drivers/net/ethernet/intel/i40e/i40e_common.c b/drivers/net/ethernet/intel/i40e/i40e_common.c
index 7af1b7477140..de996a80013e 100644
--- a/drivers/net/ethernet/intel/i40e/i40e_common.c
+++ b/drivers/net/ethernet/intel/i40e/i40e_common.c
@@ -13,7 +13,7 @@
* This function sets the mac type of the adapter based on the
* vendor ID and device ID stored in the hw structure.
**/
-static i40e_status i40e_set_mac_type(struct i40e_hw *hw)
+i40e_status i40e_set_mac_type(struct i40e_hw *hw)
{
i40e_status status = 0;
diff --git a/drivers/net/ethernet/intel/i40e/i40e_main.c b/drivers/net/ethernet/intel/i40e/i40e_main.c
index 8d6b9515b595..fdf43d87e983 100644
--- a/drivers/net/ethernet/intel/i40e/i40e_main.c
+++ b/drivers/net/ethernet/intel/i40e/i40e_main.c
@@ -14564,6 +14564,51 @@ static bool i40e_check_recovery_mode(struct i40e_pf *pf)
return false;
}
+/**
+ * i40e_pf_loop_reset - perform reset in a loop.
+ * @pf: board private structure
+ *
+ * This function is useful when a NIC is about to enter recovery mode.
+ * When a NIC's internal data structures are corrupted the NIC's
+ * firmware is going to enter recovery mode.
+ * Right after a POR it takes about 7 minutes for firmware to enter
+ * recovery mode. Until that time a NIC is in some kind of intermediate
+ * state. After that time period the NIC almost surely enters
+ * recovery mode. The only way for a driver to detect intermediate
+ * state is to issue a series of pf-resets and check a return value.
+ * If a PF reset returns success then the firmware could be in recovery
+ * mode so the caller of this code needs to check for recovery mode
+ * if this function returns success. There is a little chance that
+ * firmware will hang in intermediate state forever.
+ * Since waiting 7 minutes is quite a lot of time this function waits
+ * 10 seconds and then gives up by returning an error.
+ *
+ * Return 0 on success, negative on failure.
+ **/
+static i40e_status i40e_pf_loop_reset(struct i40e_pf *pf)
+{
+ const unsigned short MAX_CNT = 1000;
+ const unsigned short MSECS = 10;
+ struct i40e_hw *hw = &pf->hw;
+ i40e_status ret;
+ int cnt;
+
+ for (cnt = 0; cnt < MAX_CNT; ++cnt) {
+ ret = i40e_pf_reset(hw);
+ if (!ret)
+ break;
+ msleep(MSECS);
+ }
+
+ if (cnt == MAX_CNT) {
+ dev_info(&pf->pdev->dev, "PF reset failed: %d\n", ret);
+ return ret;
+ }
+
+ pf->pfr_count++;
+ return ret;
+}
+
/**
* i40e_init_recovery_mode - initialize subsystems needed in recovery mode
* @pf: board private structure
@@ -14792,14 +14837,22 @@ static int i40e_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
/* Reset here to make sure all is clean and to define PF 'n' */
i40e_clear_hw(hw);
- if (!i40e_check_recovery_mode(pf)) {
- err = i40e_pf_reset(hw);
- if (err) {
- dev_info(&pdev->dev, "Initial pf_reset failed: %d\n", err);
- goto err_pf_reset;
- }
- pf->pfr_count++;
+
+ err = i40e_set_mac_type(hw);
+ if (err) {
+ dev_warn(&pdev->dev, "unidentified MAC or BLANK NVM: %d\n",
+ err);
+ goto err_pf_reset;
}
+
+ err = i40e_pf_loop_reset(pf);
+ if (err) {
+ dev_info(&pdev->dev, "Initial pf_reset failed: %d\n", err);
+ goto err_pf_reset;
+ }
+
+ i40e_check_recovery_mode(pf);
+
hw->aq.num_arq_entries = I40E_AQ_LEN;
hw->aq.num_asq_entries = I40E_AQ_LEN;
hw->aq.arq_buf_size = I40E_MAX_AQ_BUF_SIZE;
diff --git a/drivers/net/ethernet/intel/i40e/i40e_prototype.h b/drivers/net/ethernet/intel/i40e/i40e_prototype.h
index eac88bcc6c06..9c810d54df1c 100644
--- a/drivers/net/ethernet/intel/i40e/i40e_prototype.h
+++ b/drivers/net/ethernet/intel/i40e/i40e_prototype.h
@@ -326,6 +326,8 @@ void i40e_nvmupd_check_wait_event(struct i40e_hw *hw, u16 opcode,
void i40e_nvmupd_clear_wait_state(struct i40e_hw *hw);
void i40e_set_pci_config_data(struct i40e_hw *hw, u16 link_status);
+i40e_status i40e_set_mac_type(struct i40e_hw *hw);
+
extern struct i40e_rx_ptype_decoded i40e_ptype_lookup[];
static inline struct i40e_rx_ptype_decoded decode_rx_desc_ptype(u8 ptype)
--
2.21.0
Powered by blists - more mailing lists