| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <20191002145258.178745-3-thierry.reding@gmail.com>
Date: Wed, 2 Oct 2019 16:52:58 +0200
From: Thierry Reding <thierry.reding@...il.com>
To: "David S . Miller" <davem@...emloft.net>
Cc: Jose Abreu <joabreu@...opsys.com>,
Alexandre Torgue <alexandre.torgue@...com>,
Giuseppe Cavallaro <peppe.cavallaro@...com>,
Florian Fainelli <f.fainelli@...il.com>,
Jon Hunter <jonathanh@...dia.com>,
Bitan Biswas <bbiswas@...dia.com>, netdev@...r.kernel.org,
linux-tegra@...r.kernel.org
Subject: [PATCH net-next v4 2/2] net: stmmac: Support enhanced addressing mode for DWMAC 4.10
From: Thierry Reding <treding@...dia.com>
The address width of the controller can be read from hardware feature
registers much like on XGMAC. Add support for parsing the ADDR64 field
so that the DMA mask can be set accordingly.
This avoids getting swiotlb involved for DMA on Tegra186 and later.
Also make sure that the upper 32 bits of the DMA address are written to
the DMA descriptors when enhanced addressing mode is used. Similarily,
for each channel, the upper 32 bits of the DMA descriptor ring's base
address also need to be programmed to make sure the correct memory can
be fetched when the DMA descriptor ring is located beyond the 32-bit
boundary.
Signed-off-by: Thierry Reding <treding@...dia.com>
---
Changes in v4:
- only write upper 32 bits when necessary
Changes in v3:
- unconditionally write upper 32 bits
Changes in v2:
- also program the upper 32 bits of the DMA descriptor base address for
each channel
drivers/net/ethernet/stmicro/stmmac/dwmac4.h | 1 +
.../ethernet/stmicro/stmmac/dwmac4_descs.c | 4 +--
.../net/ethernet/stmicro/stmmac/dwmac4_dma.c | 28 +++++++++++++++++++
.../net/ethernet/stmicro/stmmac/dwmac4_dma.h | 3 ++
4 files changed, 34 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac4.h b/drivers/net/ethernet/stmicro/stmmac/dwmac4.h
index 89a3420eba42..2fe45fa3c482 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac4.h
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac4.h
@@ -205,6 +205,7 @@ enum power_event {
#define GMAC_HW_HASH_TB_SZ GENMASK(25, 24)
#define GMAC_HW_FEAT_AVSEL BIT(20)
#define GMAC_HW_TSOEN BIT(18)
+#define GMAC_HW_ADDR64 GENMASK(15, 14)
#define GMAC_HW_TXFIFOSIZE GENMASK(10, 6)
#define GMAC_HW_RXFIFOSIZE GENMASK(4, 0)
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac4_descs.c b/drivers/net/ethernet/stmicro/stmmac/dwmac4_descs.c
index 15eb1abba91d..707ab5eba8da 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac4_descs.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac4_descs.c
@@ -431,8 +431,8 @@ static void dwmac4_get_addr(struct dma_desc *p, unsigned int *addr)
static void dwmac4_set_addr(struct dma_desc *p, dma_addr_t addr)
{
- p->des0 = cpu_to_le32(addr);
- p->des1 = 0;
+ p->des0 = cpu_to_le32(lower_32_bits(addr));
+ p->des1 = cpu_to_le32(upper_32_bits(addr));
}
static void dwmac4_clear(struct dma_desc *p)
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac4_dma.c b/drivers/net/ethernet/stmicro/stmmac/dwmac4_dma.c
index 68c157979b94..229059cef949 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac4_dma.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac4_dma.c
@@ -79,6 +79,10 @@ static void dwmac4_dma_init_rx_chan(void __iomem *ioaddr,
value = value | (rxpbl << DMA_BUS_MODE_RPBL_SHIFT);
writel(value, ioaddr + DMA_CHAN_RX_CONTROL(chan));
+ if (IS_ENABLED(CONFIG_ARCH_DMA_ADDR_T_64BIT) && likely(dma_cfg->eame))
+ writel(upper_32_bits(dma_rx_phy),
+ ioaddr + DMA_CHAN_RX_BASE_ADDR_HI(chan));
+
writel(lower_32_bits(dma_rx_phy), ioaddr + DMA_CHAN_RX_BASE_ADDR(chan));
}
@@ -97,6 +101,10 @@ static void dwmac4_dma_init_tx_chan(void __iomem *ioaddr,
writel(value, ioaddr + DMA_CHAN_TX_CONTROL(chan));
+ if (IS_ENABLED(CONFIG_ARCH_DMA_ADDR_T_64BIT) && likely(dma_cfg->eame))
+ writel(upper_32_bits(dma_tx_phy),
+ ioaddr + DMA_CHAN_TX_BASE_ADDR_HI(chan));
+
writel(lower_32_bits(dma_tx_phy), ioaddr + DMA_CHAN_TX_BASE_ADDR(chan));
}
@@ -132,6 +140,9 @@ static void dwmac4_dma_init(void __iomem *ioaddr,
if (dma_cfg->aal)
value |= DMA_SYS_BUS_AAL;
+ if (dma_cfg->eame)
+ value |= DMA_SYS_BUS_EAME;
+
writel(value, ioaddr + DMA_SYS_BUS_MODE);
}
@@ -356,6 +367,23 @@ static void dwmac4_get_hw_feature(void __iomem *ioaddr,
dma_cap->hash_tb_sz = (hw_cap & GMAC_HW_HASH_TB_SZ) >> 24;
dma_cap->av = (hw_cap & GMAC_HW_FEAT_AVSEL) >> 20;
dma_cap->tsoen = (hw_cap & GMAC_HW_TSOEN) >> 18;
+
+ dma_cap->addr64 = (hw_cap & GMAC_HW_ADDR64) >> 14;
+ switch (dma_cap->addr64) {
+ case 0:
+ dma_cap->addr64 = 32;
+ break;
+ case 1:
+ dma_cap->addr64 = 40;
+ break;
+ case 2:
+ dma_cap->addr64 = 48;
+ break;
+ default:
+ dma_cap->addr64 = 32;
+ break;
+ }
+
/* RX and TX FIFO sizes are encoded as log2(n / 128). Undo that by
* shifting and store the sizes in bytes.
*/
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac4_dma.h b/drivers/net/ethernet/stmicro/stmmac/dwmac4_dma.h
index b66da0237d2a..5299fa1001a3 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac4_dma.h
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac4_dma.h
@@ -65,6 +65,7 @@
#define DMA_SYS_BUS_MB BIT(14)
#define DMA_AXI_1KBBE BIT(13)
#define DMA_SYS_BUS_AAL BIT(12)
+#define DMA_SYS_BUS_EAME BIT(11)
#define DMA_AXI_BLEN256 BIT(7)
#define DMA_AXI_BLEN128 BIT(6)
#define DMA_AXI_BLEN64 BIT(5)
@@ -91,7 +92,9 @@
#define DMA_CHAN_CONTROL(x) DMA_CHANX_BASE_ADDR(x)
#define DMA_CHAN_TX_CONTROL(x) (DMA_CHANX_BASE_ADDR(x) + 0x4)
#define DMA_CHAN_RX_CONTROL(x) (DMA_CHANX_BASE_ADDR(x) + 0x8)
+#define DMA_CHAN_TX_BASE_ADDR_HI(x) (DMA_CHANX_BASE_ADDR(x) + 0x10)
#define DMA_CHAN_TX_BASE_ADDR(x) (DMA_CHANX_BASE_ADDR(x) + 0x14)
+#define DMA_CHAN_RX_BASE_ADDR_HI(x) (DMA_CHANX_BASE_ADDR(x) + 0x18)
#define DMA_CHAN_RX_BASE_ADDR(x) (DMA_CHANX_BASE_ADDR(x) + 0x1c)
#define DMA_CHAN_TX_END_ADDR(x) (DMA_CHANX_BASE_ADDR(x) + 0x20)
#define DMA_CHAN_RX_END_ADDR(x) (DMA_CHANX_BASE_ADDR(x) + 0x28)
--
2.23.0
Powered by blists - more mailing lists