[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <20200314211853.GB8622@lunn.ch>
Date: Sat, 14 Mar 2020 22:18:53 +0100
From: Andrew Lunn <andrew@...n.ch>
To: Madalin Bucur <madalin.bucur@....nxp.com>
Cc: davem@...emloft.net, netdev@...r.kernel.org,
devicetree@...r.kernel.org, shawnguo@...nel.org,
leoyang.li@....com, robh+dt@...nel.org, mark.rutland@....com,
linux-kernel@...r.kernel.org
Subject: Re: [PATCH net 2/3] arm64: dts: ls1043a-rdb: correct RGMII delay
mode to rgmii-id
On Fri, Mar 13, 2020 at 02:04:24PM +0200, Madalin Bucur wrote:
> The correct setting for the RGMII ports on LS1043ARDB is to
> enable delay on both Rx and Tx so the interface mode used must
> be PHY_INTERFACE_MODE_RGMII_ID.
>
> Since commit 1b3047b5208a80 ("net: phy: realtek: add support for
> configuring the RX delay on RTL8211F") the Realtek 8211F PHY driver
> has control over the RGMII RX delay and it is disabling it for
> RGMII_TXID. The LS1043ARDB uses two such PHYs in RGMII_ID mode but
> in the device tree the mode was described as "rgmii_txid".
> This issue was not apparent at the time as the PHY driver took the
> same action for RGMII_TXID and RGMII_ID back then but it became
> visible (RX no longer working) after the above patch.
>
> Changing the phy-connection-type to "rgmii-id" to address the issue.
>
> Fixes: bf02f2ffe59c ("arm64: dts: add LS1043A DPAA FMan support")
> Signed-off-by: Madalin Bucur <madalin.bucur@....nxp.com>
Reviewed-by: Andrew Lunn <andrew@...n.ch>
Andrew
Powered by blists - more mailing lists