| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <20200420232624.9127-3-michael@walle.cc>
Date: Tue, 21 Apr 2020 01:26:24 +0200
From: Michael Walle <michael@...le.cc>
To: linux-kernel@...r.kernel.org, netdev@...r.kernel.org
Cc: Andrew Lunn <andrew@...n.ch>,
Florian Fainelli <f.fainelli@...il.com>,
Heiner Kallweit <hkallweit1@...il.com>,
Russell King <linux@...linux.org.uk>,
"David S . Miller" <davem@...emloft.net>,
Vladimir Oltean <vladimir.oltean@....com>,
Michael Walle <michael@...le.cc>
Subject: [RFC PATCH net-next 3/3] net: phy: mscc: use phy_package_shared
Use the new phy_package_shared common storage to ease the package
initialization and to access the global registers.
This was only compile-time tested!
Signed-off-by: Michael Walle <michael@...le.cc>
---
drivers/net/phy/mscc/mscc.h | 1 -
drivers/net/phy/mscc/mscc_main.c | 99 ++++++++++----------------------
2 files changed, 29 insertions(+), 71 deletions(-)
diff --git a/drivers/net/phy/mscc/mscc.h b/drivers/net/phy/mscc/mscc.h
index 030bf8b600df..acdd8ee61a39 100644
--- a/drivers/net/phy/mscc/mscc.h
+++ b/drivers/net/phy/mscc/mscc.h
@@ -353,7 +353,6 @@ struct vsc8531_private {
const struct vsc85xx_hw_stat *hw_stats;
u64 *stats;
int nstats;
- bool pkg_init;
/* For multiple port PHYs; the MDIO address of the base PHY in the
* package.
*/
diff --git a/drivers/net/phy/mscc/mscc_main.c b/drivers/net/phy/mscc/mscc_main.c
index 5391acdece05..382b56064de9 100644
--- a/drivers/net/phy/mscc/mscc_main.c
+++ b/drivers/net/phy/mscc/mscc_main.c
@@ -691,27 +691,23 @@ static int vsc85xx_eee_init_seq_set(struct phy_device *phydev)
/* phydev->bus->mdio_lock should be locked when using this function */
static int phy_base_write(struct phy_device *phydev, u32 regnum, u16 val)
{
- struct vsc8531_private *priv = phydev->priv;
-
if (unlikely(!mutex_is_locked(&phydev->mdio.bus->mdio_lock))) {
dev_err(&phydev->mdio.dev, "MDIO bus lock not held!\n");
dump_stack();
}
- return __mdiobus_write(phydev->mdio.bus, priv->base_addr, regnum, val);
+ return __phy_package_write(phydev, regnum, val);
}
/* phydev->bus->mdio_lock should be locked when using this function */
static int phy_base_read(struct phy_device *phydev, u32 regnum)
{
- struct vsc8531_private *priv = phydev->priv;
-
if (unlikely(!mutex_is_locked(&phydev->mdio.bus->mdio_lock))) {
dev_err(&phydev->mdio.dev, "MDIO bus lock not held!\n");
dump_stack();
}
- return __mdiobus_read(phydev->mdio.bus, priv->base_addr, regnum);
+ return __phy_package_read(phydev, regnum);
}
/* bus->mdio_lock should be locked when using this function */
@@ -1287,65 +1283,36 @@ static int vsc8584_config_pre_init(struct phy_device *phydev)
return ret;
}
-/* Check if one PHY has already done the init of the parts common to all PHYs
- * in the Quad PHY package.
- */
-static bool vsc8584_is_pkg_init(struct phy_device *phydev, bool reversed)
+static void vsc8584_get_base_addr(struct phy_device *phydev)
{
- struct mii_bus *bus = phydev->mdio.bus;
- struct vsc8531_private *vsc8531;
- struct phy_device *phy;
- int i, addr;
-
- /* VSC8584 is a Quad PHY */
- for (i = 0; i < 4; i++) {
- vsc8531 = phydev->priv;
-
- if (reversed)
- addr = vsc8531->base_addr - i;
- else
- addr = vsc8531->base_addr + i;
-
- phy = mdiobus_get_phy(bus, addr);
- if (!phy)
- continue;
+ struct vsc8531_private *vsc8531 = phydev->priv;
+ u16 val, addr;
- if ((phy->phy_id & phydev->drv->phy_id_mask) !=
- (phydev->drv->phy_id & phydev->drv->phy_id_mask))
- continue;
+ mutex_lock(&phydev->mdio.bus->mdio_lock);
+ __phy_write(phydev, MSCC_EXT_PAGE_ACCESS, MSCC_PHY_PAGE_EXTENDED);
- vsc8531 = phy->priv;
+ addr = __phy_read(phydev, MSCC_PHY_EXT_PHY_CNTL_4);
+ addr >>= PHY_CNTL_4_ADDR_POS;
- if (vsc8531 && vsc8531->pkg_init)
- return true;
- }
+ val = __phy_read(phydev, MSCC_PHY_ACTIPHY_CNTL);
- return false;
+ if (val & PHY_ADDR_REVERSED)
+ vsc8531->base_addr = phydev->mdio.addr + addr;
+ else
+ vsc8531->base_addr = phydev->mdio.addr - addr;
+ mutex_unlock(&phydev->mdio.bus->mdio_lock);
}
static int vsc8584_config_init(struct phy_device *phydev)
{
struct vsc8531_private *vsc8531 = phydev->priv;
- u16 addr, val;
int ret, i;
+ u16 val;
phydev->mdix_ctrl = ETH_TP_MDI_AUTO;
mutex_lock(&phydev->mdio.bus->mdio_lock);
- __mdiobus_write(phydev->mdio.bus, phydev->mdio.addr,
- MSCC_EXT_PAGE_ACCESS, MSCC_PHY_PAGE_EXTENDED);
- addr = __mdiobus_read(phydev->mdio.bus, phydev->mdio.addr,
- MSCC_PHY_EXT_PHY_CNTL_4);
- addr >>= PHY_CNTL_4_ADDR_POS;
-
- val = __mdiobus_read(phydev->mdio.bus, phydev->mdio.addr,
- MSCC_PHY_ACTIPHY_CNTL);
- if (val & PHY_ADDR_REVERSED)
- vsc8531->base_addr = phydev->mdio.addr + addr;
- else
- vsc8531->base_addr = phydev->mdio.addr - addr;
-
/* Some parts of the init sequence are identical for every PHY in the
* package. Some parts are modifying the GPIO register bank which is a
* set of registers that are affecting all PHYs, a few resetting the
@@ -1359,7 +1326,7 @@ static int vsc8584_config_init(struct phy_device *phydev)
* do the correct init sequence for all PHYs that are package-critical
* in this pre-init function.
*/
- if (!vsc8584_is_pkg_init(phydev, val & PHY_ADDR_REVERSED ? 1 : 0)) {
+ if (phy_package_init_once(phydev)) {
/* The following switch statement assumes that the lowest
* nibble of the phy_id_mask is always 0. This works because
* the lowest nibble of the PHY_ID's below are also 0.
@@ -1388,8 +1355,6 @@ static int vsc8584_config_init(struct phy_device *phydev)
goto err;
}
- vsc8531->pkg_init = true;
-
phy_base_write(phydev, MSCC_EXT_PAGE_ACCESS,
MSCC_PHY_PAGE_EXTENDED_GPIO);
@@ -1427,7 +1392,8 @@ static int vsc8584_config_init(struct phy_device *phydev)
/* Disable SerDes for 100Base-FX */
ret = vsc8584_cmd(phydev, PROC_CMD_FIBER_MEDIA_CONF |
- PROC_CMD_FIBER_PORT(addr) | PROC_CMD_FIBER_DISABLE |
+ PROC_CMD_FIBER_PORT(vsc8531->base_addr) |
+ PROC_CMD_FIBER_DISABLE |
PROC_CMD_READ_MOD_WRITE_PORT |
PROC_CMD_RST_CONF_PORT | PROC_CMD_FIBER_100BASE_FX);
if (ret)
@@ -1435,7 +1401,8 @@ static int vsc8584_config_init(struct phy_device *phydev)
/* Disable SerDes for 1000Base-X */
ret = vsc8584_cmd(phydev, PROC_CMD_FIBER_MEDIA_CONF |
- PROC_CMD_FIBER_PORT(addr) | PROC_CMD_FIBER_DISABLE |
+ PROC_CMD_FIBER_PORT(vsc8531->base_addr) |
+ PROC_CMD_FIBER_DISABLE |
PROC_CMD_READ_MOD_WRITE_PORT |
PROC_CMD_RST_CONF_PORT | PROC_CMD_FIBER_1000BASE_X);
if (ret)
@@ -1750,26 +1717,14 @@ static int vsc8514_config_init(struct phy_device *phydev)
{
struct vsc8531_private *vsc8531 = phydev->priv;
unsigned long deadline;
- u16 val, addr;
int ret, i;
+ u16 val;
u32 reg;
phydev->mdix_ctrl = ETH_TP_MDI_AUTO;
mutex_lock(&phydev->mdio.bus->mdio_lock);
- __phy_write(phydev, MSCC_EXT_PAGE_ACCESS, MSCC_PHY_PAGE_EXTENDED);
-
- addr = __phy_read(phydev, MSCC_PHY_EXT_PHY_CNTL_4);
- addr >>= PHY_CNTL_4_ADDR_POS;
-
- val = __phy_read(phydev, MSCC_PHY_ACTIPHY_CNTL);
-
- if (val & PHY_ADDR_REVERSED)
- vsc8531->base_addr = phydev->mdio.addr + addr;
- else
- vsc8531->base_addr = phydev->mdio.addr - addr;
-
/* Some parts of the init sequence are identical for every PHY in the
* package. Some parts are modifying the GPIO register bank which is a
* set of registers that are affecting all PHYs, a few resetting the
@@ -1781,11 +1736,9 @@ static int vsc8514_config_init(struct phy_device *phydev)
* do the correct init sequence for all PHYs that are package-critical
* in this pre-init function.
*/
- if (!vsc8584_is_pkg_init(phydev, val & PHY_ADDR_REVERSED ? 1 : 0))
+ if (phy_package_init_once(phydev))
vsc8514_config_pre_init(phydev);
- vsc8531->pkg_init = true;
-
phy_base_write(phydev, MSCC_EXT_PAGE_ACCESS,
MSCC_PHY_PAGE_EXTENDED_GPIO);
@@ -1991,6 +1944,9 @@ static int vsc8514_probe(struct phy_device *phydev)
phydev->priv = vsc8531;
+ vsc8584_get_base_addr(phydev);
+ devm_phy_package_join(&phydev->mdio.dev, phydev, vsc8531->base_addr);
+
vsc8531->nleds = 4;
vsc8531->supp_led_modes = VSC85XX_SUPP_LED_MODES;
vsc8531->hw_stats = vsc85xx_hw_stats;
@@ -2046,6 +2002,9 @@ static int vsc8584_probe(struct phy_device *phydev)
phydev->priv = vsc8531;
+ vsc8584_get_base_addr(phydev);
+ devm_phy_package_join(&phydev->mdio.dev, phydev, vsc8531->base_addr);
+
vsc8531->nleds = 4;
vsc8531->supp_led_modes = VSC8584_SUPP_LED_MODES;
vsc8531->hw_stats = vsc8584_hw_stats;
--
2.20.1
Powered by blists - more mailing lists