| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <20211117225050.18395-9-kabel@kernel.org>
Date: Wed, 17 Nov 2021 23:50:50 +0100
From: Marek Behún <kabel@...nel.org>
To: netdev@...r.kernel.org, Andrew Lunn <andrew@...n.ch>
Cc: Jakub Kicinski <kuba@...nel.org>,
David Miller <davem@...emloft.net>,
Russell King <rmk+kernel@...linux.org.uk>,
Rob Herring <robh+dt@...nel.org>, devicetree@...r.kernel.org,
Marek Behún <kabel@...nel.org>
Subject: [PATCH net-next 8/8] net: phy: marvell10g: select host interface configuration
From: Russell King <rmk+kernel@...linux.org.uk>
Select the host interface configuration according to the capabilities of
the host.
This allows the kernel to:
- support SFP modules with 88X33X0 or 88E21X0 inside them
- switch interface modes when the PHY is used with the mvpp2 MAC
(e.g. on MacchiatoBIN)
Signed-off-by: Russell King <rmk+kernel@...linux.org.uk>
[ rebase, updated, also added support for 88E21X0 ]
Signed-off-by: Marek Behún <kabel@...nel.org>
---
drivers/net/phy/marvell10g.c | 120 +++++++++++++++++++++++++++++++++--
1 file changed, 115 insertions(+), 5 deletions(-)
diff --git a/drivers/net/phy/marvell10g.c b/drivers/net/phy/marvell10g.c
index 0cb9b4ef09c7..94bea1bade6f 100644
--- a/drivers/net/phy/marvell10g.c
+++ b/drivers/net/phy/marvell10g.c
@@ -96,6 +96,11 @@ enum {
MV_PCS_PORT_INFO_NPORTS_MASK = 0x0380,
MV_PCS_PORT_INFO_NPORTS_SHIFT = 7,
+ /* SerDes reinitialization 88E21X0 */
+ MV_AN_21X0_SERDES_CTRL2 = 0x800f,
+ MV_AN_21X0_SERDES_CTRL2_AUTO_INIT_DIS = BIT(13),
+ MV_AN_21X0_SERDES_CTRL2_RUN_INIT = BIT(15),
+
/* These registers appear at 0x800X and 0xa00X - the 0xa00X control
* registers appear to set themselves to the 0x800X when AN is
* restarted, but status registers appear readable from either.
@@ -140,6 +145,8 @@ struct mv3310_chip {
bool (*has_downshift)(struct phy_device *phydev);
void (*init_supported_interfaces)(unsigned long *mask);
int (*get_mactype)(struct phy_device *phydev);
+ int (*set_mactype)(struct phy_device *phydev, int mactype);
+ int (*select_mactype)(unsigned long *interfaces);
int (*init_interface)(struct phy_device *phydev, int mactype);
#ifdef CONFIG_HWMON
@@ -593,6 +600,49 @@ static int mv2110_get_mactype(struct phy_device *phydev)
return mactype & MV_PMA_21X0_PORT_CTRL_MACTYPE_MASK;
}
+static int mv2110_set_mactype(struct phy_device *phydev, int mactype)
+{
+ int err, val;
+
+ mactype &= MV_PMA_21X0_PORT_CTRL_MACTYPE_MASK;
+ err = phy_modify_mmd(phydev, MDIO_MMD_PMAPMD, MV_PMA_21X0_PORT_CTRL,
+ MV_PMA_21X0_PORT_CTRL_SWRST |
+ MV_PMA_21X0_PORT_CTRL_MACTYPE_MASK,
+ MV_PMA_21X0_PORT_CTRL_SWRST | mactype);
+ if (err)
+ return err;
+
+ err = phy_set_bits_mmd(phydev, MDIO_MMD_AN, MV_AN_21X0_SERDES_CTRL2,
+ MV_AN_21X0_SERDES_CTRL2_AUTO_INIT_DIS |
+ MV_AN_21X0_SERDES_CTRL2_RUN_INIT);
+ if (err)
+ return err;
+
+ err = phy_read_mmd_poll_timeout(phydev, MDIO_MMD_AN,
+ MV_AN_21X0_SERDES_CTRL2, val,
+ !(val &
+ MV_AN_21X0_SERDES_CTRL2_RUN_INIT),
+ 5000, 100000, true);
+ if (err)
+ return err;
+
+ return phy_clear_bits_mmd(phydev, MDIO_MMD_AN, MV_AN_21X0_SERDES_CTRL2,
+ MV_AN_21X0_SERDES_CTRL2_AUTO_INIT_DIS);
+}
+
+static int mv2110_select_mactype(unsigned long *interfaces)
+{
+ if (test_bit(PHY_INTERFACE_MODE_USXGMII, interfaces))
+ return MV_PMA_21X0_PORT_CTRL_MACTYPE_USXGMII;
+ else if (test_bit(PHY_INTERFACE_MODE_SGMII, interfaces) &&
+ !test_bit(PHY_INTERFACE_MODE_10GBASER, interfaces))
+ return MV_PMA_21X0_PORT_CTRL_MACTYPE_5GBASER;
+ else if (test_bit(PHY_INTERFACE_MODE_10GBASER, interfaces))
+ return MV_PMA_21X0_PORT_CTRL_MACTYPE_10GBASER_RATE_MATCH;
+ else
+ return -1;
+}
+
static int mv3310_get_mactype(struct phy_device *phydev)
{
int mactype;
@@ -604,6 +654,46 @@ static int mv3310_get_mactype(struct phy_device *phydev)
return mactype & MV_V2_33X0_PORT_CTRL_MACTYPE_MASK;
}
+static int mv3310_set_mactype(struct phy_device *phydev, int mactype)
+{
+ int ret;
+
+ mactype &= MV_V2_33X0_PORT_CTRL_MACTYPE_MASK;
+ ret = phy_modify_mmd_changed(phydev, MDIO_MMD_VEND2, MV_V2_PORT_CTRL,
+ MV_V2_33X0_PORT_CTRL_MACTYPE_MASK,
+ mactype);
+ if (ret <= 0)
+ return ret;
+
+ return phy_set_bits_mmd(phydev, MDIO_MMD_VEND2, MV_V2_PORT_CTRL,
+ MV_V2_33X0_PORT_CTRL_SWRST);
+}
+
+static int mv3310_select_mactype(unsigned long *interfaces)
+{
+ if (test_bit(PHY_INTERFACE_MODE_USXGMII, interfaces))
+ return MV_V2_33X0_PORT_CTRL_MACTYPE_USXGMII;
+ else if (test_bit(PHY_INTERFACE_MODE_SGMII, interfaces) &&
+ test_bit(PHY_INTERFACE_MODE_10GBASER, interfaces))
+ return MV_V2_33X0_PORT_CTRL_MACTYPE_10GBASER;
+ else if (test_bit(PHY_INTERFACE_MODE_SGMII, interfaces) &&
+ test_bit(PHY_INTERFACE_MODE_RXAUI, interfaces))
+ return MV_V2_33X0_PORT_CTRL_MACTYPE_RXAUI;
+ else if (test_bit(PHY_INTERFACE_MODE_SGMII, interfaces) &&
+ test_bit(PHY_INTERFACE_MODE_XAUI, interfaces))
+ return MV_V2_3310_PORT_CTRL_MACTYPE_XAUI;
+ else if (test_bit(PHY_INTERFACE_MODE_10GBASER, interfaces))
+ return MV_V2_33X0_PORT_CTRL_MACTYPE_10GBASER_RATE_MATCH;
+ else if (test_bit(PHY_INTERFACE_MODE_RXAUI, interfaces))
+ return MV_V2_33X0_PORT_CTRL_MACTYPE_RXAUI_RATE_MATCH;
+ else if (test_bit(PHY_INTERFACE_MODE_XAUI, interfaces))
+ return MV_V2_3310_PORT_CTRL_MACTYPE_XAUI_RATE_MATCH;
+ else if (test_bit(PHY_INTERFACE_MODE_SGMII, interfaces))
+ return MV_V2_33X0_PORT_CTRL_MACTYPE_10GBASER;
+ else
+ return -1;
+}
+
static int mv2110_init_interface(struct phy_device *phydev, int mactype)
{
struct mv3310_priv *priv = dev_get_drvdata(&phydev->mdio.dev);
@@ -674,10 +764,16 @@ static int mv3310_config_init(struct phy_device *phydev)
{
struct mv3310_priv *priv = dev_get_drvdata(&phydev->mdio.dev);
const struct mv3310_chip *chip = to_mv3310_chip(phydev);
+ DECLARE_PHY_INTERFACE_MASK(interfaces);
int err, mactype;
- /* Check that the PHY interface type is compatible */
- if (!test_bit(phydev->interface, priv->supported_interfaces))
+ /* In case host didn't provide supported interfaces */
+ __set_bit(phydev->interface, phydev->host_interfaces);
+
+ /* Check that there is at least one compatible PHY interface type */
+ phy_interface_and(interfaces, phydev->host_interfaces,
+ priv->supported_interfaces);
+ if (phy_interface_empty(interfaces))
return -ENODEV;
phydev->mdix_ctrl = ETH_TP_MDI_AUTO;
@@ -687,9 +783,15 @@ static int mv3310_config_init(struct phy_device *phydev)
if (err)
return err;
- mactype = chip->get_mactype(phydev);
- if (mactype < 0)
- return mactype;
+ mactype = chip->select_mactype(interfaces);
+ if (mactype < 0) {
+ mactype = chip->get_mactype(phydev);
+ } else {
+ phydev_info(phydev, "Changing MACTYPE to %i\n", mactype);
+ err = chip->set_mactype(phydev, mactype);
+ if (err)
+ return err;
+ }
err = chip->init_interface(phydev, mactype);
if (err) {
@@ -1049,6 +1151,8 @@ static const struct mv3310_chip mv3310_type = {
.has_downshift = mv3310_has_downshift,
.init_supported_interfaces = mv3310_init_supported_interfaces,
.get_mactype = mv3310_get_mactype,
+ .set_mactype = mv3310_set_mactype,
+ .select_mactype = mv3310_select_mactype,
.init_interface = mv3310_init_interface,
#ifdef CONFIG_HWMON
@@ -1060,6 +1164,8 @@ static const struct mv3310_chip mv3340_type = {
.has_downshift = mv3310_has_downshift,
.init_supported_interfaces = mv3340_init_supported_interfaces,
.get_mactype = mv3310_get_mactype,
+ .set_mactype = mv3310_set_mactype,
+ .select_mactype = mv3310_select_mactype,
.init_interface = mv3340_init_interface,
#ifdef CONFIG_HWMON
@@ -1070,6 +1176,8 @@ static const struct mv3310_chip mv3340_type = {
static const struct mv3310_chip mv2110_type = {
.init_supported_interfaces = mv2110_init_supported_interfaces,
.get_mactype = mv2110_get_mactype,
+ .set_mactype = mv2110_set_mactype,
+ .select_mactype = mv2110_select_mactype,
.init_interface = mv2110_init_interface,
#ifdef CONFIG_HWMON
@@ -1080,6 +1188,8 @@ static const struct mv3310_chip mv2110_type = {
static const struct mv3310_chip mv2111_type = {
.init_supported_interfaces = mv2111_init_supported_interfaces,
.get_mactype = mv2110_get_mactype,
+ .set_mactype = mv2110_set_mactype,
+ .select_mactype = mv2110_select_mactype,
.init_interface = mv2110_init_interface,
#ifdef CONFIG_HWMON
--
2.32.0
Powered by blists - more mailing lists