Message-ID: <362ed4b7-c3f8-8941-3614-2ad44a722e6e@baylibre.com>
Date:   Mon, 29 Aug 2022 09:39:47 +0200
From:   Neil Armstrong <narmstrong@...libre.com>
To:     Da Xue <da@...sconfused.com>,
        Heiner Kallweit <hkallweit1@...il.com>
Cc:     Jerome Brunet <jbrunet@...libre.com>,
        Giuseppe Cavallaro <peppe.cavallaro@...com>,
        Alexandre Torgue <alexandre.torgue@...s.st.com>,
        Jose Abreu <joabreu@...opsys.com>,
        Erico Nunes <nunes.erico@...il.com>, netdev@...r.kernel.org,
        linux-amlogic@...ts.infradead.org,
        Kevin Hilman <khilman@...libre.com>,
        Vyacheslav <adeep@...ina.in>, Qi Duan <qi.duan@...ogic.com>
Subject: Re: [RFC/RFT PATCH] net: stmmac: do not poke MAC_CTRL_REG twice on
 link up

On 27/08/2022 22:23, Da Xue wrote:
> On Fri, Aug 26, 2022 at 4:36 PM Heiner Kallweit <hkallweit1@...il.com> wrote:
>>
>> On 26.08.2022 17:45, Da Xue wrote:
>>> Hi Heiner,
>>>
>>> I have been running with the patch reverted for about two weeks now
>>> without issue but I have a modified u-boot with ethernet bringup
>>> disabled.
>>>
>>> If u-boot brings up ethernet, all of the GXL boards with more than 1GB
>>> memory experience various bugs. I had to bring the PHY initialization
>>> patch into Linux proper:
>>> https://github.com/libre-computer-project/libretech-linux/commit/1a4004c11877d4239b57b182da1ce69a81c0150c
>>>
>> Thanks for the follow-up. To be acceptable upstream I'm pretty sure that
>> the maintainer is going to request replacing magic number 0x10110181
>> with or'ing proper constants for the respective bits and fields.
> 
> Yes, it's a 32-bit field with a 32-bit value per the datasheet so a
> full write will do without bits and xors. This was just a quick patch
> from Duan. The patch as-is is not meant for upstream. I don't have any
> ODROID-C2 to test GXBB so can someone please confirm it doesn't blow
> anything up there? or maybe this should be a quirk for GXL only.

This register is only valid on GXL& GXM, and is part of the PHY MUX.

Today we use the MDIO MMIO mux, whoch works but is verly limited, we should
instead have a proper MDIO mux for GXL like we have for G12A.

With such driver we would initialize all PHY MUX registers, including this one.

Neil

> 
>>
>>> Hope this helps someone.
>>>
>>> Best,
>>>
>>> Da
>>>
>>> On Fri, Aug 26, 2022 at 5:51 AM Heiner Kallweit <hkallweit1@...il.com> wrote:
>>>>
>>>> On 07.07.2022 12:14, Jerome Brunet wrote:
>>>>> For some reason, poking MAC_CTRL_REG a second time, even with the same
>>>>> value, causes problem on a dwmac 3.70a.
>>>>>
>>>>> This problem happens on all the Amlogic SoCs, on link up, when the RMII
>>>>> 10/100 internal interface is used. The problem does not happen on boards
>>>>> using the external RGMII 10/100/1000 interface. Initially we suspected the
>>>>> PHY to be the problem but after a lot of testing, the problem seems to be
>>>>> coming from the MAC controller.
>>>>>
>>>>>> meson8b-dwmac c9410000.ethernet: IRQ eth_wake_irq not found
>>>>>> meson8b-dwmac c9410000.ethernet: IRQ eth_lpi not found
>>>>>> meson8b-dwmac c9410000.ethernet: PTP uses main clock
>>>>>> meson8b-dwmac c9410000.ethernet: User ID: 0x11, Synopsys ID: 0x37
>>>>>> meson8b-dwmac c9410000.ethernet:     DWMAC1000
>>>>>> meson8b-dwmac c9410000.ethernet: DMA HW capability register supported
>>>>>> meson8b-dwmac c9410000.ethernet: RX Checksum Offload Engine supported
>>>>>> meson8b-dwmac c9410000.ethernet: COE Type 2
>>>>>> meson8b-dwmac c9410000.ethernet: TX Checksum insertion supported
>>>>>> meson8b-dwmac c9410000.ethernet: Wake-Up On Lan supported
>>>>>> meson8b-dwmac c9410000.ethernet: Normal descriptors
>>>>>> meson8b-dwmac c9410000.ethernet: Ring mode enabled
>>>>>> meson8b-dwmac c9410000.ethernet: Enable RX Mitigation via HW Watchdog Timer
>>>>>
>>>>> The problem is not systematic. Its occurence is very random from 1/50 to
>>>>> 1/2. It is fairly easy to detect by setting the kernel to boot over NFS and
>>>>> possibly setting it to reboot automatically when reaching the prompt.
>>>>>
>>>>> When problem happens, the link is reported up by the PHY but no packet are
>>>>> actually going out. DHCP requests eventually times out and the kernel reset
>>>>> the interface. It may take several attempts but it will eventually work.
>>>>>
>>>>>> meson8b-dwmac ff3f0000.ethernet eth0: Link is Up - 100Mbps/Full - flow control rx/tx
>>>>>> Sending DHCP requests ...... timed out!
>>>>>> meson8b-dwmac ff3f0000.ethernet eth0: Link is Down
>>>>>> IP-Config: Retrying forever (NFS root)...
>>>>>> meson8b-dwmac ff3f0000.ethernet eth0: PHY [0.1:08] driver [Meson G12A Internal PHY] (irq=POLL)
>>>>>> meson8b-dwmac ff3f0000.ethernet eth0: Register MEM_TYPE_PAGE_POOL RxQ-0
>>>>>> meson8b-dwmac ff3f0000.ethernet eth0: No Safety Features support found
>>>>>> meson8b-dwmac ff3f0000.ethernet eth0: PTP not supported by HW
>>>>>> meson8b-dwmac ff3f0000.ethernet eth0: configuring for phy/rmii link mode
>>>>>> meson8b-dwmac ff3f0000.ethernet eth0: Link is Up - 100Mbps/Full - flow control rx/tx
>>>>>> Sending DHCP requests ...... timed out!
>>>>>> meson8b-dwmac ff3f0000.ethernet eth0: Link is Down
>>>>>> IP-Config: Retrying forever (NFS root)...
>>>>>> [...] 5 retries ...
>>>>>> IP-Config: Retrying forever (NFS root)...
>>>>>> meson8b-dwmac ff3f0000.ethernet eth0: PHY [0.1:08] driver [Meson G12A Internal PHY] (irq=POLL)
>>>>>> meson8b-dwmac ff3f0000.ethernet eth0: Register MEM_TYPE_PAGE_POOL RxQ-0
>>>>>> meson8b-dwmac ff3f0000.ethernet eth0: No Safety Features support found
>>>>>> meson8b-dwmac ff3f0000.ethernet eth0: PTP not supported by HW
>>>>>> meson8b-dwmac ff3f0000.ethernet eth0: configuring for phy/rmii link mode
>>>>>> meson8b-dwmac ff3f0000.ethernet eth0: Link is Up - 100Mbps/Full - flow control rx/tx
>>>>>> Sending DHCP requests ., OK
>>>>>> IP-Config: Got DHCP answer from 10.1.1.1, my address is 10.1.3.229
>>>>>
>>>>> Of course the same problem happens when not using NFS and it fairly
>>>>> difficult for IoT products to detect this situation and recover.
>>>>>
>>>>> The call to stmmac_mac_set() should be no-op in our case, the bits it sets
>>>>> have already been set by an earlier call to stmmac_mac_set(). However
>>>>> removing this call solves the problem. We have no idea why or what is the
>>>>> actual problem.
>>>>>
>>>>> Even weirder, keeping the call to stmmac_mac_set() but inserting a
>>>>> udelay(1) between writel() and stmmac_mac_set() solves the problem too.
>>>>>
>>>>> Suggested-by: Qi Duan <qi.duan@...ogic.com>
>>>>> Signed-off-by: Jerome Brunet <jbrunet@...libre.com>
>>>>> ---
>>>>>
>>>>>   Hi,
>>>>>
>>>>>   There is no intention to get this patch merged as it is.
>>>>>   It is sent with the hope to get a better understanding of the issue
>>>>>   and more testing.
>>>>>
>>>>>   The discussion on this issue initially started on this thread
>>>>>   https://lore.kernel.org/all/CAK4VdL3-BEBzgVXTMejrAmDjOorvoGDBZ14UFrDrKxVEMD2Zjg@mail.gmail.com/
>>>>>
>>>>>   The patches previously proposed in this thread have not solved the
>>>>>   problem.
>>>>>
>>>>>   The line removed in this patch should be a no-op when it comes to the
>>>>>   value of MAC_CTRL_REG. So the change should make not a difference but
>>>>>   it does. Testing result have been very good so far so there must be an
>>>>>   unexpected consequence on the HW. I hope that someone with more
>>>>>   knowledge on this controller will be able to shine some light on this.
>>>>>
>>>>>   Cheers
>>>>>   Jerome
>>>>>
>>>>>   drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 1 -
>>>>>   1 file changed, 1 deletion(-)
>>>>>
>>>>> diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
>>>>> index d1a7cf4567bc..3dca3cc61f39 100644
>>>>> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
>>>>> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
>>>>> @@ -1072,7 +1072,6 @@ static void stmmac_mac_link_up(struct phylink_config *config,
>>>>>
>>>>>        writel(ctrl, priv->ioaddr + MAC_CTRL_REG);
>>>>>
>>>>> -     stmmac_mac_set(priv, priv->ioaddr, true);
>>>>>        if (phy && priv->dma_cap.eee) {
>>>>>                priv->eee_active = phy_init_eee(phy, 1) >= 0;
>>>>>                priv->eee_enabled = stmmac_eee_init(priv);
>>>>
>>>> Now that we have a3a57bf07de2 ("net: stmmac: work around sporadic tx issue on link-up")
>>>> in linux-next and scheduled for stable:
>>>>
>>>> Jerome, can you confirm that after this commit the following is no longer needed?
>>>> 2c87c6f9fbdd ("net: phy: meson-gxl: improve link-up behavior")
>>>>
>>>> Then I'd revert it, referencing the successor workaround / fix in stmmac.
>>

Powered by blists - more mailing lists