[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <CADQ0-X_pXKvUxLW23vEyH=9aZ6iLA2jOKz8QX6aqwQmxFcPY8Q@mail.gmail.com>
Date: Fri, 28 Jul 2023 21:35:00 +0900
From: Masahisa Kojima <masahisa.kojima@...aro.org>
To: Mark Brown <broonie@...nel.org>
Cc: Andrew Lunn <andrew@...n.ch>, Ard Biesheuvel <ardb@...nel.org>,
Jassi Brar <jaswinder.singh@...aro.org>, Ilias Apalodimas <ilias.apalodimas@...aro.org>,
"David S. Miller" <davem@...emloft.net>, Eric Dumazet <edumazet@...gle.com>,
Jakub Kicinski <kuba@...nel.org>, Paolo Abeni <pabeni@...hat.com>, netdev@...r.kernel.org,
linux-kernel@...r.kernel.org
Subject: Re: [PATCH] net: netsec: Ignore 'phy-mode' on SynQuacer in DT mode
On Fri, 28 Jul 2023 at 20:43, Mark Brown <broonie@...nel.org> wrote:
>
> On Fri, Jul 28, 2023 at 10:41:40AM +0200, Andrew Lunn wrote:
> > > Wouldn't this break SynQuacers booting with firmware that lacks a
> > > network driver? (I.e., u-boot?)
>
> > > I am not sure why, but quite some effort has gone into porting u-boot
> > > to this SoC as well.
>
> > Agreed, Rather than PHY_INTERFACE_MODE_NA, please use the correct
> > value.
>
> Does anyone know off hand what the correct value is? I only have access
> to one of these in a remote test lab which makes everything more
> painful.
"rgmii-id" is correct, configured by board level.
The latest EDK2 firmware was already modified to use the correct value
for DT(Thank you, Ard).
http://snapshots.linaro.org/components/kernel/leg-96boards-developerbox-edk2/100/
Thanks,
Masahisa Kojima
Powered by blists - more mailing lists