| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <20230814223232.GA195681@bhelgaas>
Date: Mon, 14 Aug 2023 17:32:32 -0500
From: Bjorn Helgaas <helgaas@...nel.org>
To: Ilpo Järvinen <ilpo.jarvinen@...ux.intel.com>
Cc: linux-pci@...r.kernel.org, Saeed Mahameed <saeedm@...dia.com>,
Leon Romanovsky <leon@...nel.org>,
"David S. Miller" <davem@...emloft.net>,
Eric Dumazet <edumazet@...gle.com>,
Jakub Kicinski <kuba@...nel.org>, Paolo Abeni <pabeni@...hat.com>,
Moshe Shemesh <moshe@...lanox.com>, netdev@...r.kernel.org,
linux-rdma@...r.kernel.org, linux-kernel@...r.kernel.org
Subject: Re: [PATCH 1/1] net/mlx5: Convert PCI error values to generic errnos
On Mon, Aug 14, 2023 at 04:27:20PM +0300, Ilpo Järvinen wrote:
> mlx5_pci_link_toggle() returns mix PCI specific error codes and generic
> errnos.
>
> Convert the PCI specific error values to generic errno using
> pcibios_err_to_errno() before returning them.
>
> Fixes: eabe8e5e88f5 ("net/mlx5: Handle sync reset now event")
> Fixes: 212b4d7251c1 ("net/mlx5: Wait for firmware to enable CRS before pci_restore_state")
> Signed-off-by: Ilpo Järvinen <ilpo.jarvinen@...ux.intel.com>
>
> ---
>
> Maintainers beware, this will conflict with read+write -> set/clear_word
> fixes in pci.git/pcie-rmw. As such, it might be the easiest for Bjorn to
> take it instead of net people.
I provisionally rebased and applied it on pci/pcie-rmw. Take a look
and make sure I didn't botch it -- I also found a case in
mlx5_check_dev_ids() that looks like it needs the same conversion.
The commit as applied is below.
If networking folks would prefer to take this, let me know and I can
drop it.
> I wonder if these PCIBIOS_* error codes are useful at all? There's 1:1
> mapping into errno values so no information loss if the functions would just
> return errnos directly. Perhaps this is just legacy nobody has bothered to
> remove? If nobody opposes, I could take a look at getting rid of them.
I don't think the PCIBIOS error codes are very useful outside of
arch/x86. They're returned by x86 PCIBIOS functions, and I think we
still use those calls, but I don't think there's value in exposing the
x86 error codes outside arch/x86. Looks like a big job to clean it up
though ;)
> ---
> drivers/net/ethernet/mellanox/mlx5/core/fw_reset.c | 12 ++++++------
> 1 file changed, 6 insertions(+), 6 deletions(-)
>
> diff --git a/drivers/net/ethernet/mellanox/mlx5/core/fw_reset.c b/drivers/net/ethernet/mellanox/mlx5/core/fw_reset.c
> index 4804990b7f22..0afd9dbfc471 100644
> --- a/drivers/net/ethernet/mellanox/mlx5/core/fw_reset.c
> +++ b/drivers/net/ethernet/mellanox/mlx5/core/fw_reset.c
> @@ -371,7 +371,7 @@ static int mlx5_pci_link_toggle(struct mlx5_core_dev *dev)
>
> err = pci_read_config_word(dev->pdev, PCI_DEVICE_ID, &dev_id);
> if (err)
> - return err;
> + return pcibios_err_to_errno(err);
> err = mlx5_check_dev_ids(dev, dev_id);
> if (err)
> return err;
> @@ -386,16 +386,16 @@ static int mlx5_pci_link_toggle(struct mlx5_core_dev *dev)
> /* PCI link toggle */
> err = pci_read_config_word(bridge, cap + PCI_EXP_LNKCTL, ®16);
> if (err)
> - return err;
> + return pcibios_err_to_errno(err);
> reg16 |= PCI_EXP_LNKCTL_LD;
> err = pci_write_config_word(bridge, cap + PCI_EXP_LNKCTL, reg16);
> if (err)
> - return err;
> + return pcibios_err_to_errno(err);
> msleep(500);
> reg16 &= ~PCI_EXP_LNKCTL_LD;
> err = pci_write_config_word(bridge, cap + PCI_EXP_LNKCTL, reg16);
> if (err)
> - return err;
> + return pcibios_err_to_errno(err);
>
> /* Check link */
> if (!bridge->link_active_reporting) {
> @@ -408,7 +408,7 @@ static int mlx5_pci_link_toggle(struct mlx5_core_dev *dev)
> do {
> err = pci_read_config_word(bridge, cap + PCI_EXP_LNKSTA, ®16);
> if (err)
> - return err;
> + return pcibios_err_to_errno(err);
> if (reg16 & PCI_EXP_LNKSTA_DLLLA)
> break;
> msleep(20);
> @@ -426,7 +426,7 @@ static int mlx5_pci_link_toggle(struct mlx5_core_dev *dev)
> do {
> err = pci_read_config_word(dev->pdev, PCI_DEVICE_ID, ®16);
> if (err)
> - return err;
> + return pcibios_err_to_errno(err);
> if (reg16 == dev_id)
> break;
> msleep(20);
commit a48c6af2d2a5 ("net/mlx5: Convert PCI error values to generic errnos")
Author: Ilpo Järvinen <ilpo.jarvinen@...ux.intel.com>
Date: Mon Aug 14 16:27:20 2023 +0300
net/mlx5: Convert PCI error values to generic errnos
mlx5_pci_link_toggle() returns a mix of PCI-specific error codes and
generic errnos.
Convert the PCI-specific error values to generic errno using
pcibios_err_to_errno() before returning them.
Fixes: eabe8e5e88f5 ("net/mlx5: Handle sync reset now event")
Fixes: 212b4d7251c1 ("net/mlx5: Wait for firmware to enable CRS before pci_restore_state")
Link: https://lore.kernel.org/r/20230814132721.26608-1-ilpo.jarvinen@linux.intel.com
Signed-off-by: Ilpo Järvinen <ilpo.jarvinen@...ux.intel.com>
[bhelgaas: rebase to pci/pcie-rmw, also convert in mlx5_check_dev_ids()]
Signed-off-by: Bjorn Helgaas <bhelgaas@...gle.com>
diff --git a/drivers/net/ethernet/mellanox/mlx5/core/fw_reset.c b/drivers/net/ethernet/mellanox/mlx5/core/fw_reset.c
index 99dcbd006357..85a2dfbb5c46 100644
--- a/drivers/net/ethernet/mellanox/mlx5/core/fw_reset.c
+++ b/drivers/net/ethernet/mellanox/mlx5/core/fw_reset.c
@@ -311,7 +311,7 @@ static int mlx5_check_dev_ids(struct mlx5_core_dev *dev, u16 dev_id)
list_for_each_entry(sdev, &bridge_bus->devices, bus_list) {
err = pci_read_config_word(sdev, PCI_DEVICE_ID, &sdev_id);
if (err)
- return err;
+ return pcibios_err_to_errno(err);
if (sdev_id != dev_id) {
mlx5_core_warn(dev, "unrecognized dev_id (0x%x)\n", sdev_id);
return -EPERM;
@@ -371,7 +371,7 @@ static int mlx5_pci_link_toggle(struct mlx5_core_dev *dev)
err = pci_read_config_word(dev->pdev, PCI_DEVICE_ID, &dev_id);
if (err)
- return err;
+ return pcibios_err_to_errno(err);
err = mlx5_check_dev_ids(dev, dev_id);
if (err)
return err;
@@ -386,11 +386,11 @@ static int mlx5_pci_link_toggle(struct mlx5_core_dev *dev)
/* PCI link toggle */
err = pcie_capability_set_word(bridge, PCI_EXP_LNKCTL, PCI_EXP_LNKCTL_LD);
if (err)
- return err;
+ return pcibios_err_to_errno(err);
msleep(500);
err = pcie_capability_clear_word(bridge, PCI_EXP_LNKCTL, PCI_EXP_LNKCTL_LD);
if (err)
- return err;
+ return pcibios_err_to_errno(err);
/* Check link */
if (!bridge->link_active_reporting) {
@@ -403,7 +403,7 @@ static int mlx5_pci_link_toggle(struct mlx5_core_dev *dev)
do {
err = pci_read_config_word(bridge, cap + PCI_EXP_LNKSTA, ®16);
if (err)
- return err;
+ return pcibios_err_to_errno(err);
if (reg16 & PCI_EXP_LNKSTA_DLLLA)
break;
msleep(20);
@@ -421,7 +421,7 @@ static int mlx5_pci_link_toggle(struct mlx5_core_dev *dev)
do {
err = pci_read_config_word(dev->pdev, PCI_DEVICE_ID, ®16);
if (err)
- return err;
+ return pcibios_err_to_errno(err);
if (reg16 == dev_id)
break;
msleep(20);
Powered by blists - more mailing lists