[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <20230830113134.1226970-2-danishanwar@ti.com>
Date: Wed, 30 Aug 2023 17:01:33 +0530
From: MD Danish Anwar <danishanwar@...com>
To: Andrew Lunn <andrew@...n.ch>, Vignesh Raghavendra <vigneshr@...com>,
Roger
Quadros <rogerq@...nel.org>,
Jacob Keller <jacob.e.keller@...el.com>,
Simon
Horman <horms@...nel.org>, MD Danish Anwar <danishanwar@...com>,
Conor Dooley
<conor+dt@...nel.org>,
Krzysztof Kozlowski
<krzysztof.kozlowski+dt@...aro.org>,
Rob Herring <robh+dt@...nel.org>, Paolo
Abeni <pabeni@...hat.com>,
Jakub Kicinski <kuba@...nel.org>, Eric Dumazet
<edumazet@...gle.com>,
"David S. Miller" <davem@...emloft.net>
CC: <linux-kernel@...r.kernel.org>, <devicetree@...r.kernel.org>,
<netdev@...r.kernel.org>, <srk@...com>, <r-gunasekaran@...com>
Subject: [RFC PATCH net-next 1/2] dt-bindings: net: Add documentation for Half duplex support.
In order to support half-duplex operation at 10M and 100M link speeds, the
PHY collision detection signal (COL) should be routed to ICSSG
GPIO pin (PRGx_PRU0/1_GPI10) so that firmware can detect collision signal
and apply the CSMA/CD algorithm applicable for half duplex operation. A DT
property, "ti,half-duplex-capable" is introduced for this purpose. If
board has PHY COL pin conencted to PRGx_PRU1_GPIO10, this DT property can
be added to eth node of ICSSG, MII port to support half duplex operation at
that port.
Signed-off-by: MD Danish Anwar <danishanwar@...com>
---
Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml b/Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml
index 13371159515a..59da9aeaee7e 100644
--- a/Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml
+++ b/Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml
@@ -107,6 +107,13 @@ properties:
phandle to system controller node and register offset
to ICSSG control register for RGMII transmit delay
+ ti,half-duplex-capable:
+ type: boolean
+ description:
+ Enable half duplex operation on ICSSG MII port. This requires
+ PHY output pin (COL) to be routed to ICSSG GPIO pin
+ (PRGx_PRU0/1_GPIO10) as input.
+
required:
- reg
anyOf:
--
2.34.1
Powered by blists - more mailing lists