lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
Open Source and information security mailing list archives
| ||
|
Message-Id: <20231023093343.2370248-5-o.rempel@pengutronix.de> Date: Mon, 23 Oct 2023 11:33:38 +0200 From: Oleksij Rempel <o.rempel@...gutronix.de> To: "David S. Miller" <davem@...emloft.net>, Andrew Lunn <andrew@...n.ch>, Eric Dumazet <edumazet@...gle.com>, Florian Fainelli <f.fainelli@...il.com>, Jakub Kicinski <kuba@...nel.org>, Paolo Abeni <pabeni@...hat.com>, Vladimir Oltean <olteanv@...il.com>, Woojung Huh <woojung.huh@...rochip.com>, Arun Ramadoss <arun.ramadoss@...rochip.com>, Conor Dooley <conor+dt@...nel.org>, Krzysztof Kozlowski <krzysztof.kozlowski+dt@...aro.org>, Rob Herring <robh+dt@...nel.org> Cc: Oleksij Rempel <o.rempel@...gutronix.de>, Florian Fainelli <florian.fainelli@...adcom.com>, kernel@...gutronix.de, linux-kernel@...r.kernel.org, netdev@...r.kernel.org, UNGLinuxDriver@...rochip.com, "Russell King (Oracle)" <linux@...linux.org.uk>, devicetree@...r.kernel.org Subject: [PATCH net-next v7 4/9] net: dsa: microchip: ksz9477: add Wake on LAN support Add WoL support for KSZ9477 family of switches. This code was tested on KSZ8563 chip. KSZ9477 family of switches supports multiple PHY events: - wake on Link Up - wake on Energy Detect. Since current UAPI can't differentiate between this PHY events, map all of them to WAKE_PHY. Signed-off-by: Oleksij Rempel <o.rempel@...gutronix.de> Reviewed-by: Andrew Lunn <andrew@...n.ch> Reviewed-by: Florian Fainelli <florian.fainelli@...adcom.com> --- drivers/net/dsa/microchip/ksz9477.c | 100 +++++++++++++++++++++++++ drivers/net/dsa/microchip/ksz9477.h | 4 + drivers/net/dsa/microchip/ksz_common.c | 24 ++++++ drivers/net/dsa/microchip/ksz_common.h | 4 + 4 files changed, 132 insertions(+) diff --git a/drivers/net/dsa/microchip/ksz9477.c b/drivers/net/dsa/microchip/ksz9477.c index cde8ef33d029..036dfaddb32a 100644 --- a/drivers/net/dsa/microchip/ksz9477.c +++ b/drivers/net/dsa/microchip/ksz9477.c @@ -56,6 +56,103 @@ int ksz9477_change_mtu(struct ksz_device *dev, int port, int mtu) REG_SW_MTU_MASK, frame_size); } +/** + * ksz9477_handle_wake_reason - Handle wake reason on a specified port. + * @dev: The device structure. + * @port: The port number. + * + * This function reads the PME (Power Management Event) status register of a + * specified port to determine the wake reason. If there is no wake event, it + * returns early. Otherwise, it logs the wake reason which could be due to a + * "Magic Packet", "Link Up", or "Energy Detect" event. The PME status register + * is then cleared to acknowledge the handling of the wake event. + * + * Return: 0 on success, or an error code on failure. + */ +static int ksz9477_handle_wake_reason(struct ksz_device *dev, int port) +{ + u8 pme_status; + int ret; + + ret = ksz_pread8(dev, port, REG_PORT_PME_STATUS, &pme_status); + if (ret) + return ret; + + if (!pme_status) + return 0; + + dev_dbg(dev->dev, "Wake event on port %d due to:%s%s\n", port, + pme_status & PME_WOL_LINKUP ? " \"Link Up\"" : "", + pme_status & PME_WOL_ENERGY ? " \"Enery detect\"" : ""); + + return ksz_pwrite8(dev, port, REG_PORT_PME_STATUS, pme_status); +} + +/** + * ksz9477_get_wol - Get Wake-on-LAN settings for a specified port. + * @dev: The device structure. + * @port: The port number. + * @wol: Pointer to ethtool Wake-on-LAN settings structure. + * + * This function checks the PME Pin Control Register to see if PME Pin Output + * Enable is set, indicating PME is enabled. If enabled, it sets the supported + * and active WoL flags. + */ +void ksz9477_get_wol(struct ksz_device *dev, int port, + struct ethtool_wolinfo *wol) +{ + u8 pme_ctrl; + int ret; + + if (!dev->wakeup_source) + return; + + wol->supported = WAKE_PHY; + + ret = ksz_pread8(dev, port, REG_PORT_PME_CTRL, &pme_ctrl); + if (ret) + return; + + if (pme_ctrl & (PME_WOL_LINKUP | PME_WOL_ENERGY)) + wol->wolopts |= WAKE_PHY; +} + +/** + * ksz9477_set_wol - Set Wake-on-LAN settings for a specified port. + * @dev: The device structure. + * @port: The port number. + * @wol: Pointer to ethtool Wake-on-LAN settings structure. + * + * This function configures Wake-on-LAN (WoL) settings for a specified port. + * It validates the provided WoL options, checks if PME is enabled via the + * switch's PME Pin Control Register, clears any previous wake reasons, + * and sets the Magic Packet flag in the port's PME control register if + * specified. + * + * Return: 0 on success, or other error codes on failure. + */ +int ksz9477_set_wol(struct ksz_device *dev, int port, + struct ethtool_wolinfo *wol) +{ + u8 pme_ctrl = 0; + int ret; + + if (wol->wolopts & ~WAKE_PHY) + return -EINVAL; + + if (!dev->wakeup_source) + return -EOPNOTSUPP; + + ret = ksz9477_handle_wake_reason(dev, port); + if (ret) + return ret; + + if (wol->wolopts & WAKE_PHY) + pme_ctrl |= PME_WOL_LINKUP | PME_WOL_ENERGY; + + return ksz_pwrite8(dev, port, REG_PORT_PME_CTRL, pme_ctrl); +} + static int ksz9477_wait_vlan_ctrl_ready(struct ksz_device *dev) { unsigned int val; @@ -1006,6 +1103,9 @@ void ksz9477_port_setup(struct ksz_device *dev, int port, bool cpu_port) ksz_pread16(dev, port, REG_PORT_PHY_INT_ENABLE, &data16); ksz9477_port_acl_init(dev, port); + + /* clear pending wake flags */ + ksz9477_handle_wake_reason(dev, port); } void ksz9477_config_cpu_port(struct dsa_switch *ds) diff --git a/drivers/net/dsa/microchip/ksz9477.h b/drivers/net/dsa/microchip/ksz9477.h index f90e2e8ebe80..fa8d0318b437 100644 --- a/drivers/net/dsa/microchip/ksz9477.h +++ b/drivers/net/dsa/microchip/ksz9477.h @@ -58,6 +58,10 @@ void ksz9477_switch_exit(struct ksz_device *dev); void ksz9477_port_queue_split(struct ksz_device *dev, int port); void ksz9477_hsr_join(struct dsa_switch *ds, int port, struct net_device *hsr); void ksz9477_hsr_leave(struct dsa_switch *ds, int port, struct net_device *hsr); +void ksz9477_get_wol(struct ksz_device *dev, int port, + struct ethtool_wolinfo *wol); +int ksz9477_set_wol(struct ksz_device *dev, int port, + struct ethtool_wolinfo *wol); int ksz9477_port_acl_init(struct ksz_device *dev, int port); void ksz9477_port_acl_free(struct ksz_device *dev, int port); diff --git a/drivers/net/dsa/microchip/ksz_common.c b/drivers/net/dsa/microchip/ksz_common.c index 11adae8a2037..3f7c86e545a7 100644 --- a/drivers/net/dsa/microchip/ksz_common.c +++ b/drivers/net/dsa/microchip/ksz_common.c @@ -319,6 +319,8 @@ static const struct ksz_dev_ops ksz9477_dev_ops = { .mdb_del = ksz9477_mdb_del, .change_mtu = ksz9477_change_mtu, .phylink_mac_link_up = ksz9477_phylink_mac_link_up, + .get_wol = ksz9477_get_wol, + .set_wol = ksz9477_set_wol, .config_cpu_port = ksz9477_config_cpu_port, .tc_cbs_set_cinc = ksz9477_tc_cbs_set_cinc, .enable_stp_addr = ksz9477_enable_stp_addr, @@ -3543,6 +3545,26 @@ static int ksz_setup_tc(struct dsa_switch *ds, int port, } } +static void ksz_get_wol(struct dsa_switch *ds, int port, + struct ethtool_wolinfo *wol) +{ + struct ksz_device *dev = ds->priv; + + if (dev->dev_ops->get_wol) + dev->dev_ops->get_wol(dev, port, wol); +} + +static int ksz_set_wol(struct dsa_switch *ds, int port, + struct ethtool_wolinfo *wol) +{ + struct ksz_device *dev = ds->priv; + + if (dev->dev_ops->set_wol) + return dev->dev_ops->set_wol(dev, port, wol); + + return -EOPNOTSUPP; +} + static int ksz_port_set_mac_address(struct dsa_switch *ds, int port, const unsigned char *addr) { @@ -3727,6 +3749,8 @@ static const struct dsa_switch_ops ksz_switch_ops = { .get_pause_stats = ksz_get_pause_stats, .port_change_mtu = ksz_change_mtu, .port_max_mtu = ksz_max_mtu, + .get_wol = ksz_get_wol, + .set_wol = ksz_set_wol, .get_ts_info = ksz_get_ts_info, .port_hwtstamp_get = ksz_hwtstamp_get, .port_hwtstamp_set = ksz_hwtstamp_set, diff --git a/drivers/net/dsa/microchip/ksz_common.h b/drivers/net/dsa/microchip/ksz_common.h index f7c471bc040f..a7394175fcf6 100644 --- a/drivers/net/dsa/microchip/ksz_common.h +++ b/drivers/net/dsa/microchip/ksz_common.h @@ -374,6 +374,10 @@ struct ksz_dev_ops { int duplex, bool tx_pause, bool rx_pause); void (*setup_rgmii_delay)(struct ksz_device *dev, int port); int (*tc_cbs_set_cinc)(struct ksz_device *dev, int port, u32 val); + void (*get_wol)(struct ksz_device *dev, int port, + struct ethtool_wolinfo *wol); + int (*set_wol)(struct ksz_device *dev, int port, + struct ethtool_wolinfo *wol); void (*config_cpu_port)(struct dsa_switch *ds); int (*enable_stp_addr)(struct ksz_device *dev); int (*reset)(struct ksz_device *dev); -- 2.39.2
Powered by blists - more mailing lists