netdev - Re: [PATCH] net: phy: marvell-88q2xxx: add driver for the Marvell 88Q2220 PHY

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]

Message-ID: <20240105124221.GA30964@debian>
Date: Fri, 5 Jan 2024 13:42:21 +0100
From: Dimitri Fedrau <dima.fedrau@...il.com>
To: Andrew Lunn <andrew@...n.ch>
Cc: Stefan Eichenberger <eichest@...il.com>,
	Heiner Kallweit <hkallweit1@...il.com>,
	Russell King <linux@...linux.org.uk>,
	"David S. Miller" <davem@...emloft.net>,
	Eric Dumazet <edumazet@...gle.com>,
	Jakub Kicinski <kuba@...nel.org>, Paolo Abeni <pabeni@...hat.com>,
	netdev@...r.kernel.org, linux-kernel@...r.kernel.org
Subject: Re: [PATCH] net: phy: marvell-88q2xxx: add driver for the Marvell
 88Q2220 PHY

Am Tue, Dec 19, 2023 at 04:57:50PM +0100 schrieb Andrew Lunn:
> > I am not sure that it will be accepted by the maintainers if you use a
> > lot of registers that are not documented.
> 
> Sometimes there is no choice, there is no documentation except the
> vendor crap driver which we try to clean up as much as possible, but
> we still end up with lots of magic numbers.
>

Hi Andrew, hi Stefan,

tried to reduce the init sequence. This worked for me:

static int mv88q222x_config_init(struct phy_device *phydev)
{
	int ret;

	/* send_s detection threshold, slave and master */
	ret = phy_write_mmd(phydev, MDIO_MMD_AN, 0x8032, 0x2020);
	if (ret < 0)
		return ret;

	ret = phy_write_mmd(phydev, MDIO_MMD_AN, 0x8031, 0xa28);
	if (ret < 0)
		return ret;

	ret = phy_write_mmd(phydev, MDIO_MMD_AN, 0x8031, 0xc28);
	if (ret < 0)
		return ret;

	ret = phy_write_mmd(phydev, MDIO_MMD_PCS, 0xffe4, 0xc);
	if (ret < 0)
		return ret;

	return mv88q2xxx_config_init(phydev);
}

The four register writes were required to make the PHY work in 1000Mbit forced
mode. When using autonegotiation or 100Mbit forced mode they weren't needed.
It was enough to write them once in mv88q222x_config_init as you can
see. Thanks Stefan for the hint with the first three register writes, it
helped a lot.

> 	Andrew

Best regards,
Dimitri