| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <20240604143502.154463-8-christophe.roullier@foss.st.com>
Date: Tue, 4 Jun 2024 16:34:58 +0200
From: Christophe Roullier <christophe.roullier@...s.st.com>
To: "David S . Miller" <davem@...emloft.net>,
Eric Dumazet
<edumazet@...gle.com>, Jakub Kicinski <kuba@...nel.org>,
Paolo Abeni
<pabeni@...hat.com>, Rob Herring <robh+dt@...nel.org>,
Krzysztof Kozlowski
<krzysztof.kozlowski+dt@...aro.org>,
Conor Dooley <conor+dt@...nel.org>,
Maxime Coquelin <mcoquelin.stm32@...il.com>,
Alexandre Torgue
<alexandre.torgue@...s.st.com>,
Richard Cochran <richardcochran@...il.com>,
Jose Abreu <joabreu@...opsys.com>, Liam Girdwood <lgirdwood@...il.com>,
Mark
Brown <broonie@...nel.org>,
Christophe Roullier
<christophe.roullier@...s.st.com>,
Marek Vasut <marex@...x.de>
CC: <netdev@...r.kernel.org>, <devicetree@...r.kernel.org>,
<linux-stm32@...md-mailman.stormreply.com>,
<linux-arm-kernel@...ts.infradead.org>, <linux-kernel@...r.kernel.org>
Subject: [PATCH v4 07/11] net: ethernet: stmmac: add management of stm32mp13 for stm32
Add Ethernet support for STM32MP13.
STM32MP13 is STM32 SOC with 2 GMACs instances.
GMAC IP version is SNPS 4.20.
GMAC IP configure with 1 RX and 1 TX queue.
DMA HW capability register supported
RX Checksum Offload Engine supported
TX Checksum insertion supported
Wake-Up On Lan supported
TSO supported
Signed-off-by: Christophe Roullier <christophe.roullier@...s.st.com>
---
.../net/ethernet/stmicro/stmmac/dwmac-stm32.c | 50 +++++++++++++++----
1 file changed, 40 insertions(+), 10 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c
index bed2be129b2d2..e59f8a845e01e 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c
@@ -84,12 +84,14 @@ struct stm32_dwmac {
struct clk *clk_eth_ck;
struct clk *clk_ethstp;
struct clk *syscfg_clk;
+ bool is_mp13;
int ext_phyclk;
int enable_eth_ck;
int eth_clk_sel_reg;
int eth_ref_clk_sel_reg;
int irq_pwr_wakeup;
u32 mode_reg; /* MAC glue-logic mode register */
+ u32 mode_mask;
struct regmap *regmap;
u32 speed;
const struct stm32_ops *ops;
@@ -102,8 +104,8 @@ struct stm32_ops {
void (*resume)(struct stm32_dwmac *dwmac);
int (*parse_data)(struct stm32_dwmac *dwmac,
struct device *dev);
- u32 syscfg_eth_mask;
bool clk_rx_enable_in_suspend;
+ u32 syscfg_clr_off;
};
static int stm32_dwmac_clk_enable(struct stm32_dwmac *dwmac, bool resume)
@@ -227,7 +229,14 @@ static int stm32mp1_configure_pmcr(struct plat_stmmacenet_data *plat_dat)
switch (plat_dat->mac_interface) {
case PHY_INTERFACE_MODE_MII:
- val = SYSCFG_PMCR_ETH_SEL_MII;
+ /*
+ * STM32MP15xx supports both MII and GMII, STM32MP13xx MII only.
+ * SYSCFG_PMCSETR ETH_SELMII is present only on STM32MP15xx and
+ * acts as a selector between 0:GMII and 1:MII. As STM32MP13xx
+ * supports only MII, ETH_SELMII is not present.
+ */
+ if (!dwmac->is_mp13) /* Select MII mode on STM32MP15xx */
+ val |= SYSCFG_PMCR_ETH_SEL_MII;
break;
case PHY_INTERFACE_MODE_GMII:
val = SYSCFG_PMCR_ETH_SEL_GMII;
@@ -256,13 +265,16 @@ static int stm32mp1_configure_pmcr(struct plat_stmmacenet_data *plat_dat)
dev_dbg(dwmac->dev, "Mode %s", phy_modes(plat_dat->mac_interface));
+ /* Shift value at correct ethernet MAC offset in SYSCFG_PMCSETR */
+ val <<= ffs(dwmac->mode_mask) - ffs(SYSCFG_MP1_ETH_MASK);
+
/* Need to update PMCCLRR (clear register) */
- regmap_write(dwmac->regmap, reg + SYSCFG_PMCCLRR_OFFSET,
- dwmac->ops->syscfg_eth_mask);
+ regmap_write(dwmac->regmap, dwmac->ops->syscfg_clr_off,
+ dwmac->mode_mask);
/* Update PMCSETR (set register) */
return regmap_update_bits(dwmac->regmap, reg,
- dwmac->ops->syscfg_eth_mask, val);
+ dwmac->mode_mask, val);
}
static int stm32mp1_set_mode(struct plat_stmmacenet_data *plat_dat)
@@ -303,7 +315,7 @@ static int stm32mcu_set_mode(struct plat_stmmacenet_data *plat_dat)
dev_dbg(dwmac->dev, "Mode %s", phy_modes(plat_dat->mac_interface));
return regmap_update_bits(dwmac->regmap, reg,
- dwmac->ops->syscfg_eth_mask, val << 23);
+ SYSCFG_MCU_ETH_MASK, val << 23);
}
static void stm32_dwmac_clk_disable(struct stm32_dwmac *dwmac, bool suspend)
@@ -348,8 +360,15 @@ static int stm32_dwmac_parse_data(struct stm32_dwmac *dwmac,
return PTR_ERR(dwmac->regmap);
err = of_property_read_u32_index(np, "st,syscon", 1, &dwmac->mode_reg);
- if (err)
+ if (err) {
dev_err(dev, "Can't get sysconfig mode offset (%d)\n", err);
+ return err;
+ }
+
+ dwmac->mode_mask = SYSCFG_MP1_ETH_MASK;
+ err = of_property_read_u32_index(np, "st,syscon", 2, &dwmac->mode_mask);
+ if (err)
+ pr_debug("Warning sysconfig register mask not set\n");
return err;
}
@@ -361,6 +380,8 @@ static int stm32mp1_parse_data(struct stm32_dwmac *dwmac,
struct device_node *np = dev->of_node;
int err = 0;
+ dwmac->is_mp13 = of_device_is_compatible(np, "st,stm32mp13-dwmac");
+
/* Ethernet PHY have no crystal */
dwmac->ext_phyclk = of_property_read_bool(np, "st,ext-phyclk");
@@ -540,8 +561,7 @@ static SIMPLE_DEV_PM_OPS(stm32_dwmac_pm_ops,
stm32_dwmac_suspend, stm32_dwmac_resume);
static struct stm32_ops stm32mcu_dwmac_data = {
- .set_mode = stm32mcu_set_mode,
- .syscfg_eth_mask = SYSCFG_MCU_ETH_MASK
+ .set_mode = stm32mcu_set_mode
};
static struct stm32_ops stm32mp1_dwmac_data = {
@@ -549,13 +569,23 @@ static struct stm32_ops stm32mp1_dwmac_data = {
.suspend = stm32mp1_suspend,
.resume = stm32mp1_resume,
.parse_data = stm32mp1_parse_data,
- .syscfg_eth_mask = SYSCFG_MP1_ETH_MASK,
+ .syscfg_clr_off = 0x44,
+ .clk_rx_enable_in_suspend = true
+};
+
+static struct stm32_ops stm32mp13_dwmac_data = {
+ .set_mode = stm32mp1_set_mode,
+ .suspend = stm32mp1_suspend,
+ .resume = stm32mp1_resume,
+ .parse_data = stm32mp1_parse_data,
+ .syscfg_clr_off = 0x08,
.clk_rx_enable_in_suspend = true
};
static const struct of_device_id stm32_dwmac_match[] = {
{ .compatible = "st,stm32-dwmac", .data = &stm32mcu_dwmac_data},
{ .compatible = "st,stm32mp1-dwmac", .data = &stm32mp1_dwmac_data},
+ { .compatible = "st,stm32mp13-dwmac", .data = &stm32mp13_dwmac_data},
{ }
};
MODULE_DEVICE_TABLE(of, stm32_dwmac_match);
--
2.25.1
Powered by blists - more mailing lists