lists.openwall.net   lists  /  announce  owl-users  owl-dev  john-users  john-dev  passwdqc-users  yescrypt  popa3d-users  /  oss-security  kernel-hardening  musl  sabotage  tlsify  passwords  /  crypt-dev  xvendor  /  Bugtraq  Full-Disclosure  linux-kernel  linux-netdev  linux-ext4  linux-hardening  linux-cve-announce  PHC 
Open Source and information security mailing list archives
 
Hash Suite: Windows password security audit tool. GUI, reports in PDF.
[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <ZvP6d2YNKKxJPGvQ@eichest-laptop>
Date: Wed, 25 Sep 2024 13:56:39 +0200
From: Stefan Eichenberger <eichest@...il.com>
To: Andrew Lunn <andrew@...n.ch>
Cc: Niklas Söderlund <niklas.soderlund+renesas@...natech.se>,
	Heiner Kallweit <hkallweit1@...il.com>,
	Russell King <linux@...linux.org.uk>,
	"David S. Miller" <davem@...emloft.net>,
	Eric Dumazet <edumazet@...gle.com>,
	Jakub Kicinski <kuba@...nel.org>, Paolo Abeni <pabeni@...hat.com>,
	Dimitri Fedrau <dima.fedrau@...il.com>,
	Yoshihiro Shimoda <yoshihiro.shimoda.uh@...esas.com>,
	netdev@...r.kernel.org, linux-renesas-soc@...r.kernel.org
Subject: Re: [net-next 3/3] net: phy: marvell-88q2xxx: Enable auto
 negotiation for mv88q2110

Hi Andrew and Niklas,

On Sat, Sep 14, 2024 at 04:50:02PM +0200, Andrew Lunn wrote:
> > master, I can normally do: 
> > ethtool -s end1 speed 1000 master-slave forced-slave
> 
> You might want to try adding 'autoneg off'
> 
> If the new default is to perform autoneg, speed 1000 tells it to try
> to autoneg only advertising 1000. If the link partner is not actually
> performing autoneg, it will never succeed.
> 
> This is the regression i was talking about. For this device, due to
> its history, we might want to default to autoneg off.
> 
> 	Andrew


You were right about the autoneg off. I wasn't able to turn it off in my
first trial because when autoneg is not working I also have to set the
duplex mode. So the following four things worked:
ethtool -s end1 autoneg off duplex full speed 1000 master-slave forced-slave
ethtool -s end1 autoneg off duplex full speed 1000 master-slave forced-master
ethtool -s end1 autoneg off duplex full speed 100 master-slave forced-slave
ethtool -s end1 autoneg off duplex full speed 100 master-slave forced-master

So for our use case everything is working fine now and we can live with
the fact that autoneg is the default.

Tested with a mv88q2110 device.

Tested-by: Stefan Eichenberger <eichest@...il.com>

Thanks,
Stefan

Powered by blists - more mailing lists

Powered by Openwall GNU/*/Linux Powered by OpenVZ