[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-Id: <20250107214159.18807-3-johndale@cisco.com>
Date: Tue, 7 Jan 2025 13:41:58 -0800
From: John Daley <johndale@...co.com>
To: benve@...co.com,
satishkh@...co.com,
andrew+netdev@...n.ch,
davem@...emloft.net,
edumazet@...gle.com,
kuba@...nel.org,
pabeni@...hat.com,
netdev@...r.kernel.org
Cc: John Daley <johndale@...co.com>,
Nelson Escobar <neescoba@...co.com>
Subject: [PATCH net-next v2 2/3] enic: Obtain the Link speed only after the link comes up
The link speed is obtained in the RX adaptive coalescing function. It
was being called at probe time when the link may not be up. Change the
call to run after the Link comes up.
The impact of not getting the correct link speed was that the low end of
the adaptive interrupt range was always being set to 0 which could have
caused a slight increase in the number of RX interrupts.
Co-developed-by: Nelson Escobar <neescoba@...co.com>
Signed-off-by: Nelson Escobar <neescoba@...co.com>
Co-developed-by: Satish Kharat <satishkh@...co.com>
Signed-off-by: Satish Kharat <satishkh@...co.com>
Signed-off-by: John Daley <johndale@...co.com>
---
drivers/net/ethernet/cisco/enic/enic_main.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/net/ethernet/cisco/enic/enic_main.c b/drivers/net/ethernet/cisco/enic/enic_main.c
index 957efe73e41a..8109e9c484f6 100644
--- a/drivers/net/ethernet/cisco/enic/enic_main.c
+++ b/drivers/net/ethernet/cisco/enic/enic_main.c
@@ -466,6 +466,7 @@ static void enic_link_check(struct enic *enic)
if (link_status && !carrier_ok) {
netdev_info(enic->netdev, "Link UP\n");
netif_carrier_on(enic->netdev);
+ enic_set_rx_coal_setting(enic);
} else if (!link_status && carrier_ok) {
netdev_info(enic->netdev, "Link DOWN\n");
netif_carrier_off(enic->netdev);
@@ -3063,7 +3064,6 @@ static int enic_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
timer_setup(&enic->notify_timer, enic_notify_timer, 0);
enic_rfs_flw_tbl_init(enic);
- enic_set_rx_coal_setting(enic);
INIT_WORK(&enic->reset, enic_reset);
INIT_WORK(&enic->tx_hang_reset, enic_tx_hang_reset);
INIT_WORK(&enic->change_mtu_work, enic_change_mtu_work);
--
2.35.2
Powered by blists - more mailing lists