linux-kernel - Re: serial port 8250 messed up after coverting from little endian to big endian on kernel 2.6.31

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite for Android: free password hash cracker in your pocket

[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]

Message-Id: <1256676013.24305.1342273367@webmail.messagingengine.com>
Date:	Tue, 27 Oct 2009 15:40:13 -0500
From:	myuboot@...tmail.fm
To:	"Florian Fainelli" <florian@...nwrt.org>
Cc:	linux-kernel@...r.kernel.org,
	"linux-mips" <linux-mips@...ux-mips.org>
Subject: Re: serial port 8250 messed up after coverting from little endian to
 big endian on kernel  2.6.31

Thanks, Florian. I found the cause of the problem. My board is 32 bit
based, so each serial port register is 32bit even only 8 bit is used. So
when the board is switched endianess, I need to change the address
offset to access the same registers.
For example, original RHR register address is 0x8001000 with little
endian mode. With big endian, I need to access it as 0x8001003.

On Tue, 20 Oct 2009 08:17 +0200, "Florian Fainelli"
<florian@...nwrt.org> wrote:
> Hi,
> 
> Le mardi 20 octobre 2009 01:56:04, myuboot@...tmail.fm a écrit :
> > I am trying to bringup a MIPS32 board using 2.6.31. It is working in
> > little endian mode. After changing the board's hardware from little
> > endian to bit endian, the serial port print messed up. It prints now
> > something like - "àààààààààààààààà" on the screen. When I trace the
> > execution, I can see the string the kernel is trying print is correct -
> > "Linux version 2.6.31 ..." and etc.
> > 
> > I guess it means the initialization of the serial port is not properly
> > done. But I am not sure where I should check for the problem. The serial
> > port device I am using is 8250. Please give me some advise.
> 
> If the same initialization routine used to work in little-endian, check
> how 
> you actually write and read characters from the UART FIFO and especially
> if 
> your hardware requires you to do word or byte access to these registers.
> 
> You can have a look at AR7, which has the same code working for Little
> and Big 
> Endian modes in arch/mips/ar7/prom.c lines 272 to the end of the file. It
> also 
> uses a 8250-compatible UART.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/