Message-ID: <20140804173907.GU3711@ld-irv-0074>
Date:	Mon, 4 Aug 2014 10:39:07 -0700
From:	Brian Norris <computersforpeace@...il.com>
To:	Russell King - ARM Linux <linux@....linux.org.uk>
Cc:	Arnd Bergmann <arnd@...db.de>, Olof Johansson <olof@...om.net>,
	Matt Porter <mporter@...aro.org>,
	Christian Daudt <bcm@...thebug.org>,
	linux-arm-kernel@...ts.infradead.org,
	Linux Kernel <linux-kernel@...r.kernel.org>,
	devicetree@...r.kernel.org, Gregory Fong <gregory.0xf0@...il.com>,
	Florian Fainelli <f.fainelli@...il.com>,
	Marc Carino <marc.ceeeee@...il.com>
Subject: Re: [PATCH v8 01/11] ARM: brcmstb: add infrastructure for ARM-based
 Broadcom STB SoCs

On Sat, Aug 02, 2014 at 09:19:24AM +0100, Russell King wrote:
> Here's some more comments on this.
> 
> On Mon, Jul 21, 2014 at 02:07:56PM -0700, Brian Norris wrote:
> > +static void brcmstb_cpu_die(u32 cpu)
> > +{
> > +	v7_exit_coherency_flush(all);
> 
> This is ultimately what causes my builds to break:
> 
> /tmp/ccSPowmq.s:171: Error: selected processor does not support ARM mode `isb '
> /tmp/ccSPowmq.s:177: Error: selected processor does not support ARM mode `isb '
> /tmp/ccSPowmq.s:178: Error: selected processor does not support ARM mode `dsb '
> make[2]: *** [arch/arm/mach-bcm/platsmp-brcmstb.o] Error 1
> 
> It seems that v7_exit_coherency_flush() can only be used with code which
> is ARMv7 only.

Yes, I noticed this already, and I proposed a solution:

  http://article.gmane.org/gmane.linux.drivers.devicetree/84517

> > +	/* Prevent all interrupts from reaching this CPU. */
> > +	arch_local_irq_disable();
> 
> Why do you think it is necessary to disable interrupts here?  Where
> have they been re-enabled since this bit of generic code:
> 
> void __ref cpu_die(void)
> {
>         unsigned int cpu = smp_processor_id();
> 
>         idle_task_exit();
> 
>         local_irq_disable();
> 
> and why arch_local_irq_disable() at that?  Even if interrupts were
> enabled prior to your call to arch_local_irq_disable(), what do you
> think would be the effect of receiving an interrupt after you've
> exited coherency?

This mistake was already noted. No need for the extra IRQ disable.

(http://article.gmane.org/gmane.linux.drivers.devicetree/84516)

> > +
> > +	/*
> > +	 * Final full barrier to ensure everything before this instruction has
> > +	 * quiesced.
> > +	 */
> > +	isb();
> > +	dsb();
> 
> If the call to arch_local_irq_disable() is removed, and
> v7_exit_coherency_flush() is fixed, then this is not required, because
> v7_exit_coherency_flush() already does this at the very end.

Right. Will drop.

> > +
> > +	per_cpu_sw_state_wr(cpu, 0);
> > +
> > +	/* Sit and wait to die */
> > +	wfi();
> > +
> > +	/* We should never get here... */
> > +	panic("Spurious interrupt on CPU %d received!\n", cpu);
> 
> You really should /not/ be calling panic here, because that uses data
> shared with the CPUs which are still coherent.  This is akin to doing
> DMA into bits of the kernel space without dealing with the cache
> coherency issues.

OK.

> Moreover, if you read the comments on
> v7_exit_coherency_flush() about ldrex/strex, which are two instructions
> spinlocks use, you'll see that ldrex/strex must not be executed, which
> means you can't call any function which uses spinlocks.  That rules
> out printk() et.al.  printascii is fine, but that's only available when
> the low level debug stuff is enabled.

OK, so I'll drop the panic(). printascii doesn't look extremely useful,
but I suppose we could use it for debugging. Seems like a while (1) loop
might be a suitable replacement. If we get this far, we'll likely get
locked up trying to power this CPU off anyway, so it'll be apparent that
there was power-down failure.

Thanks,
Brian
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

Powered by blists - more mailing lists