Message-ID: <20140930164256.GS841@e106497-lin.cambridge.arm.com>
Date:	Tue, 30 Sep 2014 17:42:56 +0100
From:	Liviu Dudau <Liviu.Dudau@....com>
To:	Lorenzo Pieralisi <Lorenzo.Pieralisi@....com>
Cc:	Arnd Bergmann <arnd@...db.de>,
	"linux-arm-kernel@...ts.infradead.org" 
	<linux-arm-kernel@...ts.infradead.org>,
	Mark Rutland <Mark.Rutland@....com>,
	"devicetree@...r.kernel.org" <devicetree@...r.kernel.org>,
	"jason@...edaemon.net" <jason@...edaemon.net>,
	"linux-doc@...r.kernel.org" <linux-doc@...r.kernel.org>,
	Marc Zyngier <Marc.Zyngier@....com>,
	Will Deacon <Will.Deacon@....com>,
	"linux-kernel@...r.kernel.org" <linux-kernel@...r.kernel.org>,
	"linux-pci@...r.kernel.org" <linux-pci@...r.kernel.org>,
	"robh+dt@...nel.org" <robh+dt@...nel.org>,
	"suravee.suthikulpanit@....com" <suravee.suthikulpanit@....com>,
	Catalin Marinas <Catalin.Marinas@....com>,
	"bhelgaas@...gle.com" <bhelgaas@...gle.com>,
	"tglx@...utronix.de" <tglx@...utronix.de>
Subject: Re: [RFC 2/4] PCI: generic: Add support for ARM64 and MSI(x)

On Tue, Sep 30, 2014 at 05:12:41PM +0100, Lorenzo Pieralisi wrote:
> On Tue, Sep 30, 2014 at 01:31:44PM +0100, Arnd Bergmann wrote:
> > On Tuesday 30 September 2014 13:03:44 Lorenzo Pieralisi wrote:
> > > > >  static int gen_pci_probe(struct platform_device *pdev)
> > > > >  {
> > > > > @@ -326,6 +385,7 @@ static int gen_pci_probe(struct platform_device *pdev)
> > > > >         struct device *dev = &pdev->dev;
> > > > >         struct device_node *np = dev->of_node;
> > > > >         struct gen_pci *pci = devm_kzalloc(dev, sizeof(*pci), GFP_KERNEL);
> > > > > +#ifndef CONFIG_ARM64
> > > > >         struct hw_pci hw = {
> > > > >                 .nr_controllers = 1,
> > > > >                 .private_data   = (void **)&pci,
> > > > > @@ -333,6 +393,7 @@ static int gen_pci_probe(struct platform_device *pdev)
> > > > >                 .map_irq        = of_irq_parse_and_map_pci,
> > > > >                 .ops            = &gen_pci_ops,
> > > > >         };
> > > > > +#endif
> > > > >  
> > > > 
> > > > Same here, I'd suggest marking this "#ifdef CONFIG_ARM" instead, as hw_pci
> > > > is an arm32 specific data structure.
> > > 
> > > I do not think we need hw struct at all, see below, we can write code so
> > > that we do not rely on ARM32 PCI bios, I will have a stab at that and
> > > post the resulting code.
> > 
> > That would of course be best. I think it needs some rework of the
> > arm32 PCI code though, or you'd still have to create pci_sys_data
> > manually, and that is currently allocated by pcibios_init_hw.

I don't see why we need to involve the arm32 code here at all. A host bridge can
be fully functional with the generic code without having to use any of the
arm32 code (unless I'm missing something here).

> 
> Right, as far as I can see, creating a pci_sys_data struct
> that's all we would need. "Problem" is that it does not exist on ARM64
> so to avoid ifdeffery we have to declare a struct with the same
> fields (ie only pci_sys_data.private_data is used by this driver -
> apart from arm32 specific functions usage) that is passed to the PCI layer
> and stored in the bus.sysdata, but that's extremely ugly (and we won't
> need this when the arm32 conversion is completed).
> 
> > > > > +       if (!gen_scan_root_bus(&pdev->dev, pci->cfg.bus_range.start,
> > > > > +                              &gen_pci_ops, pci, &pci->resources)) {
> > > > > +               dev_err(&pdev->dev, "failed to enable PCIe ports\n");
> > > > > +               return -ENODEV;
> > > > > +       }
> > > > > +#else
> > > > >         pci_common_init_dev(dev, &hw);
> > > > > +#endif /* CONFIG_ARM64 */
> > > > > 
> > > > 
> > > > Again, just make the pci_common_init_dev() call #ifdef CONFIG_ARM, and move
> > > > the generic case after it, outside of the #ifdef.
> > > 
> > > I went through the code quickly but I think we can (and should) remove
> > > this quite ugly ifdeffery altogether. Most of the functionality in
> > > pci_common_init_dev() can be implemented through the common PCI API (and this
> > > would make this driver arch agnostic as it should be), I will go through ARM32
> > > PCI bios code to check what is executed in detail in pci_common_init_dev() and
> > > make sure that we follow those initialization steps in the resulting probe code
> > > for this PCI generic host controller driver.
> > 
> > These are the functions I found that refer to pci_sys_data on arm32:
> > 
> > pcibios_add_bus
> > pcibios_remove_bus
> > pcibios_align_resource
> > pci_mmap_page_range
> > pci_domain_nr
> > pci_proc_domain
> > 
> > This is not as bad as I had feared, but we still have to ensure that
> > any caller of these functions will work with both the generic PCI support
> > and the arm32 specific drivers that today use hw_pci.
> > 
> > My idea for dealing with this was to convert all host drivers in
> > drivers/pci/host to the generic PCI code and never build the arm32
> > bios32 code when CONFIG_ARCH_MULTIPLATFORM is set. Unfortunately that
> > requires either doing them all at once or coming up with a migration
> > strategy so we don't break things in the process.
> 
> That makes sense. Related to the migration strategy, thoughts
> appreciated. Declaring a static pci_sys_data (with some ifdef around it)
> seems a horrible hack to me. Calling pci_common_init() only if CONFIG_ARM
> is rather horrible too, but we can probably live with that.
> 
> I do not see anything else as possible solution at the moment unless
> we go the whole nine yards and do what you suggest above, might take a
> little while though.
> 
> Probably leaving pci_common_init() call (and related hw_pci struct, and
> related ifdeffery to differentiate between different sysdata layouts for ARM
> and ARM64) is the fastest path but I still think it is not nice at all.

Rob Herring found the conversion of mach-integrator/pci_v3.c to the generic
framework quite painless. We might have to go through a lot of testing, but I don't
see the process to be too horrendous.

That being said, I think we first need to make sure we have all the features
needed by the host bridge drivers in place before we start the conversion. MSI
support is amongst them.

Best regards,
Liviu

> 
> Thanks,
> Lorenzo

-- 
====================
| I would like to |
| fix the world,  |
| but they're not |
| giving me the   |
 \ source code!  /
  ---------------
    ¯\_(ツ)_/¯

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

Powered by blists - more mailing lists