| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <20150513122150.GT3394@x1>
Date: Wed, 13 May 2015 13:21:50 +0100
From: Lee Jones <lee.jones@...aro.org>
To: Charles Keepax <ckeepax@...nsource.wolfsonmicro.com>
Cc: broonie@...nel.org, lgirdwood@...il.com, sameo@...ux.intel.com,
patches@...nsource.wolfsonmicro.com, linux-kernel@...r.kernel.org
Subject: Re: [RESEND PATCH v3 09/10] mfd: arizona: Add better support for
system suspend
On Mon, 11 May 2015, Charles Keepax wrote:
> Allow the chip to completely power off if we enter runtime suspend and
> there is no jack detection active. This is helpful for systems where
> system suspend might remove the supplies to the CODEC, without informing
> us. Note the powering off is done in runtime suspend rather than system
> suspend, because we need to hold reset until the first time DCVDD is
> powered anyway (which would be in runtime resume), and we might as well
> save the extra power.
>
> Signed-off-by: Charles Keepax <ckeepax@...nsource.wolfsonmicro.com>
> Acked-by: Lee Jones <lee.jones@...aro.org>
> ---
> drivers/mfd/arizona-core.c | 94 +++++++++++++++++++++++++++++++-------
> include/linux/mfd/arizona/core.h | 1 +
> 2 files changed, 78 insertions(+), 17 deletions(-)
Applied, thanks.
> diff --git a/drivers/mfd/arizona-core.c b/drivers/mfd/arizona-core.c
> index 93024ac..f1ff68a 100644
> --- a/drivers/mfd/arizona-core.c
> +++ b/drivers/mfd/arizona-core.c
> @@ -442,12 +442,33 @@ static int arizona_runtime_resume(struct device *dev)
>
> dev_dbg(arizona->dev, "Leaving AoD mode\n");
>
> + if (arizona->has_fully_powered_off) {
> + dev_dbg(arizona->dev, "Re-enabling core supplies\n");
> +
> + ret = regulator_bulk_enable(arizona->num_core_supplies,
> + arizona->core_supplies);
> + if (ret) {
> + dev_err(dev, "Failed to enable core supplies: %d\n",
> + ret);
> + return ret;
> + }
> + }
> +
> ret = regulator_enable(arizona->dcvdd);
> if (ret != 0) {
> dev_err(arizona->dev, "Failed to enable DCVDD: %d\n", ret);
> + if (arizona->has_fully_powered_off)
> + regulator_bulk_disable(arizona->num_core_supplies,
> + arizona->core_supplies);
> return ret;
> }
>
> + if (arizona->has_fully_powered_off) {
> + arizona_disable_reset(arizona);
> + enable_irq(arizona->irq);
> + arizona->has_fully_powered_off = false;
> + }
> +
> regcache_cache_only(arizona->regmap, false);
>
> switch (arizona->type) {
> @@ -508,6 +529,14 @@ static int arizona_runtime_resume(struct device *dev)
> goto err;
> }
> }
> +
> + ret = wm5110_apply_sleep_patch(arizona);
> + if (ret) {
> + dev_err(arizona->dev,
> + "Failed to re-apply sleep patch: %d\n",
> + ret);
> + goto err;
> + }
> break;
> default:
> ret = arizona_wait_for_boot(arizona);
> @@ -545,10 +574,17 @@ err:
> static int arizona_runtime_suspend(struct device *dev)
> {
> struct arizona *arizona = dev_get_drvdata(dev);
> + unsigned int val;
> int ret;
>
> dev_dbg(arizona->dev, "Entering AoD mode\n");
>
> + ret = regmap_read(arizona->regmap, ARIZONA_JACK_DETECT_ANALOGUE, &val);
> + if (ret) {
> + dev_err(dev, "Failed to check jack det status: %d\n", ret);
> + return ret;
> + }
> +
> if (arizona->external_dcvdd) {
> ret = regmap_update_bits(arizona->regmap,
> ARIZONA_ISOLATION_CONTROL,
> @@ -559,33 +595,57 @@ static int arizona_runtime_suspend(struct device *dev)
> ret);
> return ret;
> }
> - } else {
> - switch (arizona->type) {
> - case WM5110:
> - case WM8280:
> - /*
> - * As this is only called for the internal regulator
> - * (where we know voltage ranges available) it is ok
> - * to request an exact range.
> - */
> - ret = regulator_set_voltage(arizona->dcvdd,
> - 1175000, 1175000);
> - if (ret < 0) {
> + }
> +
> + switch (arizona->type) {
> + case WM5110:
> + case WM8280:
> + if (arizona->external_dcvdd)
> + break;
> +
> + /*
> + * As this is only called for the internal regulator
> + * (where we know voltage ranges available) it is ok
> + * to request an exact range.
> + */
> + ret = regulator_set_voltage(arizona->dcvdd, 1175000, 1175000);
> + if (ret < 0) {
> + dev_err(arizona->dev,
> + "Failed to set suspend voltage: %d\n", ret);
> + return ret;
> + }
> + break;
> + case WM5102:
> + if (!(val & ARIZONA_JD1_ENA))
> + ret = regmap_write(arizona->regmap,
> + ARIZONA_WRITE_SEQUENCER_CTRL_3, 0x0);
> + if (ret) {
> dev_err(arizona->dev,
> - "Failed to set suspend voltage: %d\n",
> + "Failed to clear write sequencer: %d\n",
> ret);
> return ret;
> }
> - break;
> - default:
> - break;
> - }
> + break;
> + default:
> + break;
> }
>
> regcache_cache_only(arizona->regmap, true);
> regcache_mark_dirty(arizona->regmap);
> regulator_disable(arizona->dcvdd);
>
> + /* Allow us to completely power down if no jack detection */
> + if (!(val & ARIZONA_JD1_ENA)) {
> + dev_dbg(arizona->dev, "Fully powering off\n");
> +
> + arizona->has_fully_powered_off = true;
> +
> + disable_irq(arizona->irq);
> + arizona_enable_reset(arizona);
> + regulator_bulk_disable(arizona->num_core_supplies,
> + arizona->core_supplies);
> + }
> +
> return 0;
> }
> #endif
> diff --git a/include/linux/mfd/arizona/core.h b/include/linux/mfd/arizona/core.h
> index 16a498f..847bdaf 100644
> --- a/include/linux/mfd/arizona/core.h
> +++ b/include/linux/mfd/arizona/core.h
> @@ -117,6 +117,7 @@ struct arizona {
> int num_core_supplies;
> struct regulator_bulk_data core_supplies[ARIZONA_MAX_CORE_SUPPLIES];
> struct regulator *dcvdd;
> + bool has_fully_powered_off;
>
> struct arizona_pdata pdata;
>
--
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists