[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <20150929205923.GQ31505@google.com>
Date: Tue, 29 Sep 2015 13:59:23 -0700
From: Brian Norris <computersforpeace@...il.com>
To: Stefan Agner <stefan@...er.ch>
Cc: dwmw2@...radead.org, sebastian@...akpoint.cc, robh+dt@...nel.org,
pawel.moll@....com, mark.rutland@....com,
ijc+devicetree@...lion.org.uk, galak@...eaurora.org,
shawn.guo@...aro.org, kernel@...gutronix.de,
boris.brezillon@...e-electrons.com, marb@...at.de,
aaron@...tycactus.com, bpringlemeir@...il.com,
linux-mtd@...ts.infradead.org, devicetree@...r.kernel.org,
linux-arm-kernel@...ts.infradead.org, linux-kernel@...r.kernel.org,
albert.aribaud@...ev.fr, klimov.linux@...il.com,
Bill Pringlemeir <bpringlemeir@...ps.com>
Subject: Re: [PATCH v12 3/5] mtd: nand: vf610_nfc: add device tree bindings
On Wed, Sep 02, 2015 at 06:06:35PM -0700, Stefan Agner wrote:
> Signed-off-by: Bill Pringlemeir <bpringlemeir@...ps.com>
> Acked-by: Shawn Guo <shawnguo@...nel.org>
> Signed-off-by: Stefan Agner <stefan@...er.ch>
> ---
> .../devicetree/bindings/mtd/vf610-nfc.txt | 59 ++++++++++++++++++++++
> 1 file changed, 59 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/mtd/vf610-nfc.txt
>
> diff --git a/Documentation/devicetree/bindings/mtd/vf610-nfc.txt b/Documentation/devicetree/bindings/mtd/vf610-nfc.txt
> new file mode 100644
> index 0000000..6be4871
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/mtd/vf610-nfc.txt
> @@ -0,0 +1,59 @@
> +Freescale's NAND flash controller (NFC)
> +
> +This variant of the Freescale NAND flash controller (NFC) can be found on
> +Vybrid (vf610), MPC5125, MCF54418 and Kinetis K70.
> +
> +Required properties:
> +- compatible: Should be set to "fsl,vf610-nfc".
> +- reg: address range of the NFC.
> +- interrupts: interrupt of the NFC.
> +- #address-cells: shall be set to 1. Encode the nand CS.
> +- #size-cells : shall be set to 0.
> +- assigned-clocks: main clock from the SoC, for Vybrid <&clks VF610_CLK_NFC>;
> +- assigned-clock-rates: The NAND bus timing is derived from this clock
> + rate and should not exceed maximum timing for any NAND memory chip
> + in a board stuffing. Typical NAND memory timings derived from this
> + clock are found in the SoC hardware reference manual. Furthermore,
> + there might be restrictions on maximum rates when using hardware ECC.
> +
> +- #address-cells, #size-cells : Must be present if the device has sub-nodes
> + representing partitions.
> +
> +Required children nodes:
> +Children nodes represent the available nand chips. Currently the driver can
> +only handle one NAND chip.
> +
> +Required properties:
> +- compatible: Should be set to "fsl,vf610-nfc-cs".
> +- nand-bus-width: see nand.txt
> +- nand-ecc-mode: see nand.txt
> +
> +Required properties for hardware ECC:
> +- nand-ecc-strength: supported strengths are 24 and 32 bit (see nand.txt)
> +- nand-ecc-step-size: step size equals page size, currently only 2k pages are
> + supported
> +- nand-on-flash-bbt: see nand.txt
> +
> +Example:
> +
> + nfc: nand@...e0000 {
> + compatible = "fsl,vf610-nfc";
> + #address-cells = <1>;
> + #size-cells = <1>;
Fixed this to <0> ^^^
and pushed to l2-mtd.git. I'll assume the DTS updates can be rebased and
taken through arm-soc
> + reg = <0x400e0000 0x4000>;
> + interrupts = <GIC_SPI 83 IRQ_TYPE_LEVEL_HIGH>;
> + clocks = <&clks VF610_CLK_NFC>;
> + clock-names = "nfc";
> + assigned-clocks = <&clks VF610_CLK_NFC>;
> + assigned-clock-rates = <33000000>;
> +
> + nand@0 {
> + compatible = "fsl,vf610-nfc-nandcs";
> + reg = <0>;
> + nand-bus-width = <8>;
> + nand-ecc-mode = "hw";
> + nand-ecc-strength = <32>;
> + nand-ecc-step-size = <2048>;
> + nand-on-flash-bbt;
> + };
> + };
> --
> 2.5.1
>
Brian
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@...r.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Powered by blists - more mailing lists