| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <5694BEB2.4000603@atmel.com>
Date: Tue, 12 Jan 2016 09:52:02 +0100
From: Nicolas Ferre <nicolas.ferre@...el.com>
To: Mans Rullgard <mans@...sr.com>,
<linux-arm-kernel@...ts.infradead.org>,
Cyrille Pitchen <cyrille.pitchen@...el.com>,
"Yang, Wenyou" <Wenyou.Yang@...el.com>,
Mark Brown <broonie@...nel.org>, <linux-spi@...r.kernel.org>,
<linux-kernel@...r.kernel.org>
Subject: Re: [PATCH v2] spi: atmel: improve internal vs gpio chip-select
choice
Le 11/01/2016 17:01, Mans Rullgard a écrit :
> The driver currently chooses between internal chip-select or gpio
> based on the existence of the cs-gpios DT property which fails on
> non-DT systems and also enforces the same choice for all devices.
>
> This patch makes the method per device instead of per controller
> and fixes the selection on non-DT systems.
Sorry Mans, but it's still a NACK for me on this "mixed CS feature" (Cf.
my answer to the previous version).
Bye,
> With these changes,
> the chip-select method for each device is chosen according to the
> following priority:
>
> 1. GPIO from device tree
> 2. GPIO from platform data
> 3. Internal chip-select
>
> Tested on AVR32 ATSTK1000.
>
> Signed-off-by: Mans Rullgard <mans@...sr.com>
> ---
> Changes:
> - allow internal CS only hardware v2
> - retain seting of master->num_chipselect to 4 on hardware v2 if
> cs-gpios property is missing
> ---
> drivers/spi/spi-atmel.c | 38 +++++++++++++++++++++++---------------
> 1 file changed, 23 insertions(+), 15 deletions(-)
>
> diff --git a/drivers/spi/spi-atmel.c b/drivers/spi/spi-atmel.c
> index 08cbb3e43c76..d4a806e24060 100644
> --- a/drivers/spi/spi-atmel.c
> +++ b/drivers/spi/spi-atmel.c
> @@ -312,7 +312,6 @@ struct atmel_spi {
>
> bool use_dma;
> bool use_pdc;
> - bool use_cs_gpios;
> /* dmaengine data */
> struct atmel_spi_dma dma;
>
> @@ -323,6 +322,7 @@ struct atmel_spi {
> struct atmel_spi_device {
> unsigned int npcs_pin;
> u32 csr;
> + bool use_cs_gpio;
> };
>
> #define BUFFER_SIZE PAGE_SIZE
> @@ -387,7 +387,7 @@ static void cs_activate(struct atmel_spi *as, struct spi_device *spi)
> }
>
> mr = spi_readl(as, MR);
> - if (as->use_cs_gpios)
> + if (asd->use_cs_gpio)
> gpio_set_value(asd->npcs_pin, active);
> } else {
> u32 cpol = (spi->mode & SPI_CPOL) ? SPI_BIT(CPOL) : 0;
> @@ -404,7 +404,7 @@ static void cs_activate(struct atmel_spi *as, struct spi_device *spi)
>
> mr = spi_readl(as, MR);
> mr = SPI_BFINS(PCS, ~(1 << spi->chip_select), mr);
> - if (as->use_cs_gpios && spi->chip_select != 0)
> + if (asd->use_cs_gpio && spi->chip_select != 0)
> gpio_set_value(asd->npcs_pin, active);
> spi_writel(as, MR, mr);
> }
> @@ -433,7 +433,7 @@ static void cs_deactivate(struct atmel_spi *as, struct spi_device *spi)
> asd->npcs_pin, active ? " (low)" : "",
> mr);
>
> - if (!as->use_cs_gpios)
> + if (!asd->use_cs_gpio)
> spi_writel(as, CR, SPI_BIT(LASTXFER));
> else if (atmel_spi_is_v2(as) || spi->chip_select != 0)
> gpio_set_value(asd->npcs_pin, !active);
> @@ -1539,6 +1539,7 @@ static int atmel_spi_setup(struct spi_device *spi)
> unsigned int bits = spi->bits_per_word;
> unsigned int npcs_pin;
> int ret;
> + bool use_cs_gpio;
>
> as = spi_master_get_devdata(spi->master);
>
> @@ -1565,8 +1566,6 @@ static int atmel_spi_setup(struct spi_device *spi)
> csr |= SPI_BIT(CPOL);
> if (!(spi->mode & SPI_CPHA))
> csr |= SPI_BIT(NCPHA);
> - if (!as->use_cs_gpios)
> - csr |= SPI_BIT(CSAAT);
>
> /* DLYBS is mostly irrelevant since we manage chipselect using GPIOs.
> *
> @@ -1577,13 +1576,22 @@ static int atmel_spi_setup(struct spi_device *spi)
> csr |= SPI_BF(DLYBS, 0);
> csr |= SPI_BF(DLYBCT, 0);
>
> - /* chipselect must have been muxed as GPIO (e.g. in board setup) */
> npcs_pin = (unsigned long)spi->controller_data;
>
> - if (!as->use_cs_gpios)
> - npcs_pin = spi->chip_select;
> - else if (gpio_is_valid(spi->cs_gpio))
> + if (gpio_is_valid(spi->cs_gpio)) {
> + /* GPIO from DT */
> npcs_pin = spi->cs_gpio;
> + use_cs_gpio = true;
> + } else if (npcs_pin && gpio_is_valid(npcs_pin)) {
> + /* GPIO from platform data */
> + use_cs_gpio = true;
> + } else if (atmel_spi_is_v2(as)) {
> + /* internal chip-select */
> + npcs_pin = spi->chip_select;
> + use_cs_gpio = false;
> + } else {
> + return -EINVAL;
> + }
>
> asd = spi->controller_state;
> if (!asd) {
> @@ -1591,7 +1599,7 @@ static int atmel_spi_setup(struct spi_device *spi)
> if (!asd)
> return -ENOMEM;
>
> - if (as->use_cs_gpios) {
> + if (use_cs_gpio) {
> ret = gpio_request(npcs_pin, dev_name(&spi->dev));
> if (ret) {
> kfree(asd);
> @@ -1603,6 +1611,7 @@ static int atmel_spi_setup(struct spi_device *spi)
> }
>
> asd->npcs_pin = npcs_pin;
> + asd->use_cs_gpio = use_cs_gpio;
> spi->controller_state = asd;
> } else {
> atmel_spi_lock(as);
> @@ -1612,6 +1621,8 @@ static int atmel_spi_setup(struct spi_device *spi)
> atmel_spi_unlock(as);
> }
>
> + if (!asd->use_cs_gpio)
> + csr |= SPI_BIT(CSAAT);
> asd->csr = csr;
>
> dev_dbg(&spi->dev,
> @@ -1807,12 +1818,9 @@ static int atmel_spi_probe(struct platform_device *pdev)
>
> atmel_get_caps(as);
>
> - as->use_cs_gpios = true;
> if (atmel_spi_is_v2(as) &&
> - !of_get_property(pdev->dev.of_node, "cs-gpios", NULL)) {
> - as->use_cs_gpios = false;
> + !of_get_property(pdev->dev.of_node, "cs-gpios", NULL))
> master->num_chipselect = 4;
> - }
>
> as->use_dma = false;
> as->use_pdc = false;
>
--
Nicolas Ferre
Powered by blists - more mailing lists