linux-kernel - [PATCH 2/2] phy: ti-pipe3: configure usb3 phy to be used as pcie phy

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives

Hash Suite: Windows password security audit tool. GUI, reports in PDF.

[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]

Date:   Tue, 19 Dec 2017 15:15:40 +0530
From:   Kishon Vijay Abraham I <kishon@...com>
To:     Rob Herring <robh+dt@...nel.org>,
        Mark Rutland <mark.rutland@....com>, <kishon@...com>
CC:     <devicetree@...r.kernel.org>, <linux-pci@...r.kernel.org>,
        <linux-kernel@...r.kernel.org>, <nsekhar@...com>
Subject: [PATCH 2/2] phy: ti-pipe3: configure usb3 phy to be used as pcie phy

DRA72 uses USB3 PHY for the 2nd lane of PCIE. The configuration
required to make USB3 PHY used for the 2nd lane of PCIe is done
here.

Signed-off-by: Kishon Vijay Abraham I <kishon@...com>
---
 drivers/phy/ti/phy-ti-pipe3.c | 47 +++++++++++++++++++++++++++++++++++++------
 1 file changed, 41 insertions(+), 6 deletions(-)

diff --git a/drivers/phy/ti/phy-ti-pipe3.c b/drivers/phy/ti/phy-ti-pipe3.c
index 68ce4a082b9b..d5a7cc435fb7 100644
--- a/drivers/phy/ti/phy-ti-pipe3.c
+++ b/drivers/phy/ti/phy-ti-pipe3.c
@@ -56,6 +56,12 @@
 
 #define SATA_PLL_SOFT_RESET	BIT(18)
 
+#define PHY_RX_ANA_PRGRAMMABILITY_REG	0xC
+#define MEM_EN_PLLBYP			BIT(7)
+
+#define PHY_TX_TEST_CONFIG		0x2C
+#define MEM_ENTESTCLK			BIT(31)
+
 #define PIPE3_PHY_PWRCTL_CLK_CMD_MASK	0x003FC000
 #define PIPE3_PHY_PWRCTL_CLK_CMD_SHIFT	14
 
@@ -110,6 +116,10 @@
 #define PLL_IDLE_TIME	100	/* in milliseconds */
 #define PLL_LOCK_TIME	100	/* in milliseconds */
 
+#define PIPE3_PHY_DISABLE_SYNC_POWER	BIT(4)
+
+#define CONFIGURE_AS_PCIE		BIT(0)
+
 struct pipe3_dpll_params {
 	u16	m;
 	u8	n;
@@ -141,6 +151,7 @@ struct ti_pipe3 {
 	unsigned int		power_reg; /* power reg. index within syscon */
 	unsigned int		pcie_pcs_reg; /* pcs reg. index in syscon */
 	bool			sata_refclk_enabled;
+	u32			flags;
 };
 
 static struct pipe3_dpll_map dpll_map_usb[] = {
@@ -233,11 +244,22 @@ static int ti_pipe3_power_on(struct phy *x)
 	rate = rate / 1000000;
 	mask = OMAP_CTRL_PIPE3_PHY_PWRCTL_CLK_CMD_MASK |
 		  OMAP_CTRL_PIPE3_PHY_PWRCTL_CLK_FREQ_MASK;
-	val = PIPE3_PHY_TX_RX_POWERON << PIPE3_PHY_PWRCTL_CLK_CMD_SHIFT;
+	val = PIPE3_PHY_TX_RX_POWERON;
+	if (phy->flags & CONFIGURE_AS_PCIE)
+		val |= PIPE3_PHY_DISABLE_SYNC_POWER;
+	val <<= PIPE3_PHY_PWRCTL_CLK_CMD_SHIFT;
 	val |= rate << OMAP_CTRL_PIPE3_PHY_PWRCTL_CLK_FREQ_SHIFT;
 
 	ret = regmap_update_bits(phy->phy_power_syscon, phy->power_reg,
 				 mask, val);
+
+	if (phy->flags & CONFIGURE_AS_PCIE) {
+		ret = regmap_update_bits(phy->phy_power_syscon, phy->power_reg,
+					 mask, val);
+		if (ret < 0)
+			return ret;
+	}
+
 	return ret;
 }
 
@@ -335,6 +357,19 @@ static int ti_pipe3_init(struct phy *x)
 	int ret = 0;
 
 	ti_pipe3_enable_clocks(phy);
+
+	if (phy->flags & CONFIGURE_AS_PCIE) {
+		val = ti_pipe3_readl(phy->phy_rx,
+				     PHY_RX_ANA_PRGRAMMABILITY_REG);
+		val |= MEM_EN_PLLBYP;
+		ti_pipe3_writel(phy->phy_rx, PHY_RX_ANA_PRGRAMMABILITY_REG,
+				val);
+		val = ti_pipe3_readl(phy->phy_tx, PHY_TX_TEST_CONFIG);
+		val |= MEM_ENTESTCLK;
+		ti_pipe3_writel(phy->phy_tx, PHY_TX_TEST_CONFIG, val);
+		return 0;
+	}
+
 	/*
 	 * Set pcie_pcs register to 0x96 for proper functioning of phy
 	 * as recommended in AM572x TRM SPRUHZ6, section 18.5.2.2, table
@@ -395,7 +430,8 @@ static int ti_pipe3_exit(struct phy *x)
 		return 0;
 
 	/* PCIe doesn't have internal DPLL */
-	if (!of_device_is_compatible(phy->dev->of_node, "ti,phy-pipe3-pcie")) {
+	if (!of_device_is_compatible(phy->dev->of_node, "ti,phy-pipe3-pcie") &&
+	    !(phy->flags & CONFIGURE_AS_PCIE)) {
 		/* Put DPLL in IDLE mode */
 		val = ti_pipe3_readl(phy->pll_ctrl_base, PLL_CONFIGURATION2);
 		val |= PLL_IDLE;
@@ -589,12 +625,8 @@ static int ti_pipe3_get_tx_rx_base(struct ti_pipe3 *phy)
 {
 	struct resource *res;
 	struct device *dev = phy->dev;
-	struct device_node *node = dev->of_node;
 	struct platform_device *pdev = to_platform_device(dev);
 
-	if (!of_device_is_compatible(node, "ti,phy-pipe3-pcie"))
-		return 0;
-
 	res = platform_get_resource_byname(pdev, IORESOURCE_MEM,
 					   "phy_rx");
 	phy->phy_rx = devm_ioremap_resource(dev, res);
@@ -666,6 +698,9 @@ static int ti_pipe3_probe(struct platform_device *pdev)
 	if (ret)
 		return ret;
 
+	if (of_property_read_bool(node, "ti,configure-as-pcie"))
+		phy->flags |= CONFIGURE_AS_PCIE;
+
 	platform_set_drvdata(pdev, phy);
 	pm_runtime_enable(dev);
 
-- 
2.11.0