| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Date: Wed, 6 Jun 2018 14:48:54 +0530
From: Keerthy <j-keerthy@...com>
To: <linus.walleij@...aro.org>
CC: <j-keerthy@...com>, <linux-kernel@...r.kernel.org>,
<linux-gpio@...r.kernel.org>, <t-kristo@...com>
Subject: [PATCH 2/2] gpio: davinci: Do not assume continuous IRQ numbering
Currently the driver assumes that the interrupts are continuous
and does platform_get_irq only once and assumes the rest are continuous,
instead call platform_get_irq for all the interrupts and store them
in an array for later use.
Signed-off-by: Keerthy <j-keerthy@...com>
---
Tested for GPIO Interrupts on da850-lcdk and keystone-k2g-evm boards.
drivers/gpio/gpio-davinci.c | 49 ++++++++++++++++++++++++++++++---------------
1 file changed, 33 insertions(+), 16 deletions(-)
diff --git a/drivers/gpio/gpio-davinci.c b/drivers/gpio/gpio-davinci.c
index 861f35b..375578c 100644
--- a/drivers/gpio/gpio-davinci.c
+++ b/drivers/gpio/gpio-davinci.c
@@ -42,6 +42,7 @@ struct davinci_gpio_regs {
#define BINTEN 0x8 /* GPIO Interrupt Per-Bank Enable Register */
#define MAX_LABEL_SIZE 20
+#define MAX_INT_PER_BANK 32
static void __iomem *gpio_base;
static unsigned int offset_array[5] = {0x10, 0x38, 0x60, 0x88, 0xb0};
@@ -55,7 +56,7 @@ static inline struct davinci_gpio_regs __iomem *irq2regs(struct irq_data *d)
return g;
}
-static int davinci_gpio_irq_setup(struct platform_device *pdev, int bank_irq);
+static int davinci_gpio_irq_setup(struct platform_device *pdev, int *bank_irq);
/*--------------------------------------------------------------------------*/
@@ -168,7 +169,8 @@ static int davinci_gpio_probe(struct platform_device *pdev)
{
static int ctrl_num, bank_base;
int gpio, bank, ret = 0;
- unsigned ngpio, nbank, bank_irq;
+ unsigned int ngpio, nbank, nirq;
+ int bank_irq[MAX_INT_PER_BANK], i;
struct davinci_gpio_controller *chips;
struct davinci_gpio_platform_data *pdata;
struct device *dev = &pdev->dev;
@@ -197,6 +199,16 @@ static int davinci_gpio_probe(struct platform_device *pdev)
if (WARN_ON(ARCH_NR_GPIOS < ngpio))
ngpio = ARCH_NR_GPIOS;
+ /*
+ * If there are unbanked interrupts then the number of
+ * interrupts is equal to number of gpios else all are banked so
+ * number of interrupts is equal to number of banks(each with 16 gpios)
+ */
+ if (pdata->gpio_unbanked)
+ nirq = pdata->gpio_unbanked;
+ else
+ nirq = DIV_ROUND_UP(ngpio, 16);
+
nbank = DIV_ROUND_UP(ngpio, 32);
chips = devm_kzalloc(dev,
nbank * sizeof(struct davinci_gpio_controller),
@@ -209,10 +221,13 @@ static int davinci_gpio_probe(struct platform_device *pdev)
if (IS_ERR(gpio_base))
return PTR_ERR(gpio_base);
- bank_irq = platform_get_irq(pdev, 0);
- if (bank_irq < 0) {
- dev_dbg(dev, "IRQ not populated\n");
- return bank_irq;
+ for (i = 0; i < nirq; i++) {
+ bank_irq[i] = platform_get_irq(pdev, i);
+ if (bank_irq[i] < 0) {
+ dev_info(dev, "IRQ not populated, err = %d\n",
+ bank_irq[i]);
+ return bank_irq[i];
+ }
}
snprintf(label, MAX_LABEL_SIZE, "davinci_gpio.%d", ctrl_num++);
@@ -458,7 +473,7 @@ static struct irq_chip *keystone_gpio_get_irq_chip(unsigned int irq)
* (dm6446) can be set appropriately for GPIOV33 pins.
*/
-static int davinci_gpio_irq_setup(struct platform_device *pdev, int bank_irq)
+static int davinci_gpio_irq_setup(struct platform_device *pdev, int *bank_irq)
{
unsigned gpio, bank;
int irq;
@@ -492,6 +507,7 @@ static int davinci_gpio_irq_setup(struct platform_device *pdev, int bank_irq)
dev_err(dev, "Error %ld getting gpio clock\n", PTR_ERR(clk));
return PTR_ERR(clk);
}
+
ret = clk_prepare_enable(clk);
if (ret)
return ret;
@@ -531,12 +547,12 @@ static int davinci_gpio_irq_setup(struct platform_device *pdev, int bank_irq)
if (pdata->gpio_unbanked) {
/* pass "bank 0" GPIO IRQs to AINTC */
chips->chip.to_irq = gpio_to_irq_unbanked;
- chips->base_irq = bank_irq;
+ chips->base_irq = bank_irq[0];
chips->gpio_unbanked = pdata->gpio_unbanked;
binten = GENMASK(pdata->gpio_unbanked / 16, 0);
/* AINTC handles mask/unmask; GPIO handles triggering */
- irq = bank_irq;
+ irq = bank_irq[0];
irq_chip = gpio_get_irq_chip(irq);
irq_chip->name = "GPIO-AINTC";
irq_chip->irq_set_type = gpio_irq_type_unbanked;
@@ -547,10 +563,11 @@ static int davinci_gpio_irq_setup(struct platform_device *pdev, int bank_irq)
writel_relaxed(~0, &g->set_rising);
/* set the direct IRQs up to use that irqchip */
- for (gpio = 0; gpio < pdata->gpio_unbanked; gpio++, irq++) {
- irq_set_chip(irq, irq_chip);
- irq_set_handler_data(irq, chips);
- irq_set_status_flags(irq, IRQ_TYPE_EDGE_BOTH);
+ for (gpio = 0; gpio < pdata->gpio_unbanked; gpio++) {
+ irq_set_chip(bank_irq[gpio], irq_chip);
+ irq_set_handler_data(bank_irq[gpio], chips);
+ irq_set_status_flags(bank_irq[gpio],
+ IRQ_TYPE_EDGE_BOTH);
}
goto done;
@@ -560,7 +577,7 @@ static int davinci_gpio_irq_setup(struct platform_device *pdev, int bank_irq)
* Or, AINTC can handle IRQs for banks of 16 GPIO IRQs, which we
* then chain through our own handler.
*/
- for (gpio = 0, bank = 0; gpio < ngpio; bank++, bank_irq++, gpio += 16) {
+ for (gpio = 0, bank = 0; gpio < ngpio; bank++, gpio += 16) {
/* disabled by default, enabled only as needed
* There are register sets for 32 GPIOs. 2 banks of 16
* GPIOs are covered by each set of registers hence divide by 2
@@ -587,8 +604,8 @@ static int davinci_gpio_irq_setup(struct platform_device *pdev, int bank_irq)
irqdata->bank_num = bank;
irqdata->chip = chips;
- irq_set_chained_handler_and_data(bank_irq, gpio_irq_handler,
- irqdata);
+ irq_set_chained_handler_and_data(bank_irq[bank],
+ gpio_irq_handler, irqdata);
binten |= BIT(bank);
}
--
1.9.1
Powered by blists - more mailing lists