[<prev] [next>] [<thread-prev] [day] [month] [year] [list]
Message-ID: <CAHtARFHovpNRx-hdZCAYD9zjUf0WWdRvQ8PkqPNjNpbUwPRqow@mail.gmail.com>
Date: Tue, 28 Aug 2018 10:33:03 -0700
From: adam radford <aradford@...il.com>
To: rdunlap@...radead.org
Cc: frank.kammer@....thm.de,
linux-kernel <linux-kernel@...r.kernel.org>,
linux-scsi <linux-scsi@...r.kernel.org>
Subject: Re: Bug in /drivers/scsi/3w-9xxx.h
Frank,
host->max_id (max scsi target ID's) is set to TW_MAX_UNITS_9650SE for
your adapter, which is 32.
The firmware srl (spec revision level) for your 9650 adapter doesn't
support luns > (0 .. 16).
You could run in this mode but it hasn't been tested, and I don't
recall what the ramifications may be (if any).
-Adam
On Tue, Aug 28, 2018 at 10:02 AM Randy Dunlap <rdunlap@...radead.org> wrote:
>
> [add linux-scsi list]
>
> On 08/28/2018 05:23 AM, Frank Kammer wrote:
> > Hello,
> >
> > I have a 3ware 9650SE RAID-Controller with 20 LUNs. Using an unpachted
> > kernel (no matter which version, e.g., 4.12.14) , only 17 LUNs are shown.
> >
> > The problem is that the driver was once written for a 3ware 9550SE
> > RAID-Controlle that supports only 16 LUNs.
> > There are some changes in driver to allow 32 LUNs, but one change is
> > forgotten:
> >
> > In drivers/scsi/3w-9xxx.h, one must replace the following:
> >
> > 467c467
> > < #define TW_MAX_LUNS(srl) (srl < TW_FW_SRL_LUNS_SUPPORTED ? 1 : 16)
> > ---
> >> #define TW_MAX_LUNS(srl) (srl < TW_FW_SRL_LUNS_SUPPORTED ? 1 : 32)
> >
> > Best regards,
> > Frank Kammer
> >
>
>
> --
> ~Randy
Powered by blists - more mailing lists