[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <DB3PR0402MB3916B318947B803BC5ADF4A6F5C50@DB3PR0402MB3916.eurprd04.prod.outlook.com>
Date: Thu, 8 Nov 2018 01:24:51 +0000
From: Anson Huang <anson.huang@....com>
To: Fabio Estevam <festevam@...il.com>
CC: Rob Herring <robh+dt@...nel.org>,
Mark Rutland <mark.rutland@....com>,
Shawn Guo <shawnguo@...nel.org>,
Sascha Hauer <s.hauer@...gutronix.de>,
Sascha Hauer <kernel@...gutronix.de>,
Fabio Estevam <fabio.estevam@....com>,
"open list:OPEN FIRMWARE AND FLATTENED DEVICE TREE BINDINGS"
<devicetree@...r.kernel.org>,
linux-kernel <linux-kernel@...r.kernel.org>,
"moderated list:ARM/FREESCALE IMX / MXC ARM ARCHITECTURE"
<linux-arm-kernel@...ts.infradead.org>,
dl-linux-imx <linux-imx@....com>
Subject: RE: [PATCH] ARM: dts: imx7d-sdb: add rev-a board support
Hi, Fabio
Best Regards!
Anson Huang
> -----Original Message-----
> From: Fabio Estevam [mailto:festevam@...il.com]
> Sent: 2018年11月7日 18:03
> To: Anson Huang <anson.huang@....com>
> Cc: Rob Herring <robh+dt@...nel.org>; Mark Rutland
> <mark.rutland@....com>; Shawn Guo <shawnguo@...nel.org>; Sascha
> Hauer <s.hauer@...gutronix.de>; Sascha Hauer <kernel@...gutronix.de>;
> Fabio Estevam <fabio.estevam@....com>; open list:OPEN FIRMWARE AND
> FLATTENED DEVICE TREE BINDINGS <devicetree@...r.kernel.org>; linux-kernel
> <linux-kernel@...r.kernel.org>; moderated list:ARM/FREESCALE IMX / MXC
> ARM ARCHITECTURE <linux-arm-kernel@...ts.infradead.org>; dl-linux-imx
> <linux-imx@....com>
> Subject: Re: [PATCH] ARM: dts: imx7d-sdb: add rev-a board support
>
> Hi Anson,
>
> On Wed, Nov 7, 2018 at 3:19 AM Anson Huang <anson.huang@....com>
> wrote:
>
> > +&fec2 {
> > + pinctrl-0 = <&pinctrl_enet2>;
> > + /delete-property/pinctrl-assert-gpios;
>
> "pinctrl-assert-gpios" does not exist in mainline, so not sure why you are
> deleting it.
Regarding the fec2 settings in imx7d-sdb.dts, originally it uses Rev-A board (but some nodes are
using Rev-B board), in this patch, I clean up all the settings in imx7d-sdb.dts using Rev-B board,
so below is added to imx7d-sdb.dts for Rev-B board, and in imx7d-sdb-reva.dts I have to
delete it, since Rev-A board has no this pin.
- pinctrl-0 = <&pinctrl_enet2>;
+ pinctrl-0 = <&pinctrl_enet2 &pinctrl_enet2_epdc0_en>;
+ pinctrl-assert-gpios = <&gpio1 4 GPIO_ACTIVE_LOW>;
Anson.
Powered by blists - more mailing lists