[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <CAOMZO5DiTbEsVXTCfE8fJ=4+yU4oXR1gex7Bj-k=FowKHWJaxw@mail.gmail.com>
Date: Thu, 8 Nov 2018 00:20:45 -0200
From: Fabio Estevam <festevam@...il.com>
To: Yongcai Huang <anson.huang@....com>
Cc: Rob Herring <robh+dt@...nel.org>,
Mark Rutland <mark.rutland@....com>,
Shawn Guo <shawnguo@...nel.org>,
Sascha Hauer <s.hauer@...gutronix.de>,
Sascha Hauer <kernel@...gutronix.de>,
Fabio Estevam <fabio.estevam@....com>,
"open list:OPEN FIRMWARE AND FLATTENED DEVICE TREE BINDINGS"
<devicetree@...r.kernel.org>,
linux-kernel <linux-kernel@...r.kernel.org>,
"moderated list:ARM/FREESCALE IMX / MXC ARM ARCHITECTURE"
<linux-arm-kernel@...ts.infradead.org>,
NXP Linux Team <linux-imx@....com>
Subject: Re: [PATCH] ARM: dts: imx7d-sdb: add rev-a board support
Hi Anson,
On Wed, Nov 7, 2018 at 11:24 PM Anson Huang <anson.huang@....com> wrote:
> Regarding the fec2 settings in imx7d-sdb.dts, originally it uses Rev-A board (but some nodes are
> using Rev-B board), in this patch, I clean up all the settings in imx7d-sdb.dts using Rev-B board,
> so below is added to imx7d-sdb.dts for Rev-B board, and in imx7d-sdb-reva.dts I have to
> delete it, since Rev-A board has no this pin.
>
> - pinctrl-0 = <&pinctrl_enet2>;
> + pinctrl-0 = <&pinctrl_enet2 &pinctrl_enet2_epdc0_en>;
> + pinctrl-assert-gpios = <&gpio1 4 GPIO_ACTIVE_LOW>;
"pinctrl-assert-gpios" only exists in the NXP vendor kernel, so you
cannot use such property in mainline.
Powered by blists - more mailing lists