[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <3d6eacb8-ed8d-d4ac-1c36-6224ab88a5dc@partner.samsung.com>
Date: Wed, 10 Jul 2019 12:16:48 +0200
From: Kamil Konieczny <k.konieczny@...tner.samsung.com>
To: Viresh Kumar <viresh.kumar@...aro.org>
Cc: Bartlomiej Zolnierkiewicz <b.zolnierkie@...sung.com>,
Marek Szyprowski <m.szyprowski@...sung.com>,
Chanwoo Choi <cw00.choi@...sung.com>,
Krzysztof Kozlowski <krzk@...nel.org>,
Kukjin Kim <kgene@...nel.org>,
Kyungmin Park <kyungmin.park@...sung.com>,
Mark Rutland <mark.rutland@....com>,
MyungJoo Ham <myungjoo.ham@...sung.com>,
Nishanth Menon <nm@...com>, Rob Herring <robh+dt@...nel.org>,
Stephen Boyd <sboyd@...nel.org>,
Viresh Kumar <vireshk@...nel.org>, devicetree@...r.kernel.org,
linux-arm-kernel@...ts.infradead.org, linux-kernel@...r.kernel.org,
linux-pm@...r.kernel.org, linux-samsung-soc@...r.kernel.org
Subject: Re: [PATCH 1/3] opp: core: add regulators enable and disable
On 09.07.2019 07:40, Viresh Kumar wrote:
> On 08-07-19, 16:11, k.konieczny@...tner.samsung.com wrote:
>> From: Kamil Konieczny <k.konieczny@...tner.samsung.com>
>>
>> Add enable regulators to dev_pm_opp_set_regulators() and disable
>> regulators to dev_pm_opp_put_regulators(). This prepares for
>> converting exynos-bus devfreq driver to use dev_pm_opp_set_rate().
>>
>> Signed-off-by: Kamil Konieczny <k.konieczny@...tner.samsung.com>
>> ---
>> drivers/opp/core.c | 13 +++++++++++++
>> 1 file changed, 13 insertions(+)
>>
>> diff --git a/drivers/opp/core.c b/drivers/opp/core.c
>> index 0e7703fe733f..947cac452854 100644
>> --- a/drivers/opp/core.c
>> +++ b/drivers/opp/core.c
>> @@ -1580,8 +1580,19 @@ struct opp_table *dev_pm_opp_set_regulators(struct device *dev,
>> if (ret)
>> goto free_regulators;
>>
>> + for (i = 0; i < opp_table->regulator_count; i++) {
>> + ret = regulator_enable(opp_table->regulators[i]);
>> + if (ret < 0)
>> + goto disable;
>> + }
>
> I am wondering on why is this really required as this isn't done for
> any other platform, probably because the regulators are enabled by
> bootloader and are always on.
It was not enabled for historical reasons, from design point regualtors
should be enabled before use.
--
Best regards,
Kamil Konieczny
Samsung R&D Institute Poland
Powered by blists - more mailing lists