linux-kernel - Re: [PATCH v10 2/5] dt-bindings: display: mediatek: control dpi pins mode to avoid leakage

Open Source and information security mailing list archives

Message-ID: <20200228055207.GA6324@ravnborg.org>
Date:   Fri, 28 Feb 2020 06:52:07 +0100
From:   Sam Ravnborg <sam@...nborg.org>
To:     Jitao Shi <jitao.shi@...iatek.com>
Cc:     Rob Herring <robh+dt@...nel.org>,
        Mark Rutland <mark.rutland@....com>,
        Matthias Brugger <matthias.bgg@...il.com>,
        Daniel Vetter <daniel@...ll.ch>,
        David Airlie <airlied@...ux.ie>,
        dri-devel@...ts.freedesktop.org, linux-kernel@...r.kernel.org,
        devicetree@...r.kernel.org, srv_heupstream@...iatek.com,
        huijuan.xie@...iatek.com, stonea168@....com,
        cawa.cheng@...iatek.com, linux-mediatek@...ts.infradead.org,
        yingjoe.chen@...iatek.com, eddie.huang@...iatek.com,
        linux-arm-kernel@...ts.infradead.org
Subject: Re: [PATCH v10 2/5] dt-bindings: display: mediatek: control dpi pins
 mode to avoid leakage

Hi Jitao.

On Fri, Feb 28, 2020 at 01:21:25PM +0800, Jitao Shi wrote:
> Add property "pinctrl-names" to swap pin mode between gpio and dpi mode. Set
> the dpi pins to gpio mode and output-low to avoid leakage current when dpi
> disabled.
> 
> Signed-off-by: Jitao Shi <jitao.shi@...iatek.com>
> ---
>  .../devicetree/bindings/display/mediatek/mediatek,dpi.txt  | 7 +++++++

When this has landed it would be great if you could follow-up with a
conversion to DT Schema of this file (.yaml).

	Sam

>  1 file changed, 7 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt b/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt
> index 58914cf681b8..77ca32a32399 100644
> --- a/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt
> +++ b/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt
> @@ -17,6 +17,10 @@ Required properties:
>    Documentation/devicetree/bindings/graph.txt. This port should be connected
>    to the input port of an attached HDMI or LVDS encoder chip.
>  
> +Optional properties:
> +- pinctrl-names: Contain "gpiomode" and "dpimode".
> +  pinctrl-names see Documentation/devicetree/bindings/pinctrlpinctrl-bindings.txt
> +
>  Example:
>  
>  dpi0: dpi@...1d000 {
> @@ -27,6 +31,9 @@ dpi0: dpi@...1d000 {
>  		 <&mmsys CLK_MM_DPI_ENGINE>,
>  		 <&apmixedsys CLK_APMIXED_TVDPLL>;
>  	clock-names = "pixel", "engine", "pll";
> +	pinctrl-names = "active", "idle";
> +	pinctrl-0 = <&dpi_pin_func>;
> +	pinctrl-1 = <&dpi_pin_idle>;
>  
>  	port {
>  		dpi0_out: endpoint {
> -- 
> 2.21.0
> _______________________________________________
> dri-devel mailing list
> dri-devel@...ts.freedesktop.org
> https://lists.freedesktop.org/mailman/listinfo/dri-devel

lists.openwall.net		lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC
Open Source and information security mailing list archives