[<prev] [next>] [<thread-prev] [day] [month] [year] [list]
Message-ID: <CAMpxmJUVm+N=1WArb9hnV1BtsTfL5kH+_NkF3+iLmR17SiZjzA@mail.gmail.com>
Date: Sun, 3 Jan 2021 16:28:32 +0100
From: Bartosz Golaszewski <bgolaszewski@...libre.com>
To: Jonathan Neuschäfer <j.neuschaefer@....net>
Cc: linux-doc <linux-doc@...r.kernel.org>,
Linus Walleij <linus.walleij@...aro.org>,
Jonathan Corbet <corbet@....net>,
linux-gpio <linux-gpio@...r.kernel.org>,
LKML <linux-kernel@...r.kernel.org>
Subject: Re: [PATCH] docs: gpio: intro: Improve HTML formatting
On Fri, Jan 1, 2021 at 9:43 PM Jonathan Neuschäfer
<j.neuschaefer@....net> wrote:
>
> Currently the HTML output for Documentation/driver-api/gpio/intro.rst
> doesn't look right. The lines that start with LOW or HIGH are formatted
> in bold, while the next line after each is not bold.
>
> With this patch, the HTML looks better.
>
> Signed-off-by: Jonathan Neuschäfer <j.neuschaefer@....net>
> ---
> Documentation/driver-api/gpio/intro.rst | 8 ++++----
> 1 file changed, 4 insertions(+), 4 deletions(-)
>
> diff --git a/Documentation/driver-api/gpio/intro.rst b/Documentation/driver-api/gpio/intro.rst
> index 74591489d0b55..94dd7185e76eb 100644
> --- a/Documentation/driver-api/gpio/intro.rst
> +++ b/Documentation/driver-api/gpio/intro.rst
> @@ -106,11 +106,11 @@ don't. When you need open drain signaling but your hardware doesn't directly
> support it, there's a common idiom you can use to emulate it with any GPIO pin
> that can be used as either an input or an output:
>
> - LOW: gpiod_direction_output(gpio, 0) ... this drives the signal and overrides
> - the pullup.
> + **LOW**: ``gpiod_direction_output(gpio, 0)`` ... this drives the signal and
> + overrides the pullup.
>
> - HIGH: gpiod_direction_input(gpio) ... this turns off the output, so the pullup
> - (or some other device) controls the signal.
> + **HIGH**: ``gpiod_direction_input(gpio)`` ... this turns off the output, so
> + the pullup (or some other device) controls the signal.
>
> The same logic can be applied to emulate open source signaling, by driving the
> high signal and configuring the GPIO as input for low. This open drain/open
> --
> 2.29.2
>
Applied, thanks!
Bartosz
Powered by blists - more mailing lists