[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <7f91482a93aa4d429ee574d730eeca6a@realtek.com>
Date: Thu, 18 Mar 2021 01:21:03 +0000
From: Jack Yu <jack.yu@...ltek.com>
To: Pierre-Louis Bossart <pierre-louis.bossart@...ux.intel.com>,
Brent Lu <brent.lu@...el.com>,
"alsa-devel@...a-project.org" <alsa-devel@...a-project.org>,
kent_chen@...ltek.com [陳建宏]
<kent_chen@...ltek.com>
CC: Oder Chiou <oder_chiou@...ltek.com>,
Liam Girdwood <lgirdwood@...il.com>,
Mark Brown <broonie@...nel.org>,
Jaroslav Kysela <perex@...ex.cz>,
"Takashi Iwai" <tiwai@...e.com>,
Cezary Rojewski <cezary.rojewski@...el.com>,
Jie Yang <yang.jie@...ux.intel.com>,
Kai Vehmanen <kai.vehmanen@...ux.intel.com>,
Guennadi Liakhovetski <guennadi.liakhovetski@...ux.intel.com>,
Rander Wang <rander.wang@...ux.intel.com>,
Yong Zhi <yong.zhi@...el.com>,
Libin Yang <libin.yang@...ux.intel.com>,
Ranjani Sridharan <ranjani.sridharan@...ux.intel.com>,
Sathyanarayana Nujella <sathyanarayana.nujella@...el.com>,
Dharageswari R <dharageswari.r@...el.com>,
Kuninori Morimoto <kuninori.morimoto.gx@...esas.com>,
Fred Oh <fred.oh@...ux.intel.com>,
Tzung-Bi Shih <tzungbi@...gle.com>,
"linux-kernel@...r.kernel.org" <linux-kernel@...r.kernel.org>
Subject: RE: [PATCH v3] ASoC: Intel: sof_rt5682: Add ALC1015Q-VB speaker amp support
> > This patch adds jsl_rt5682_rt1015p which supports the RT5682 headset
> > codec and ALC1015Q-VB speaker amplifier combination on JasperLake
> > platform.
> >
> > This driver also supports ALC1015Q-CG if running in auto-mode.
> > Following table shows the audio interface support of the two
> > amplifiers.
> >
> > | ALC1015Q-CG | ALC1015Q-VB
> > =====================================
> > I2C | Yes | No
> > Auto-mode | 48K, 64fs | 16k, 32fs
> > | 48k, 32fs
> > | 48k, 64fs
> >
> > Signed-off-by: Brent Lu <brent.lu@...el.com>
>
> The code is looks fine, but Jack Yu added a separate patch that makes
> RTL1019 equivalent to RTL1015, so should this patch also handle the
> RTL1019 case?
>
For rt1019 non-i2c mode (auto mode), it uses the sdb pin to enable amp, the same as rt1015 non-i2c mode,
therefore we propose rt1019(auto mode) to use rt1015p instead of adding a new driver for it.
Powered by blists - more mailing lists