| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <8d44098e7b8ca5d4c13733267836d5a147539277.1644874828.git.sylv@sylv.io>
Date: Mon, 14 Feb 2022 22:44:55 +0100
From: Marcello Sylvester Bauer <sylv@...v.io>
To: Guenter Roeck <linux@...ck-us.net>,
Jean Delvare <jdelvare@...e.com>,
Jonathan Corbet <corbet@....net>
Cc: linux-kernel@...r.kernel.org, linux-hwmon@...r.kernel.org,
Patrick Rudolph <patrick.rudolph@...ements.com>,
Marcello Sylvester Bauer <sylv@...v.io>,
linux-doc@...r.kernel.org
Subject: [PATCH v3 3/4] pmbus: Add support for pli1209bc
PLI1209BC is a Digital Supervisor from Vicor Corporation.
Signed-off-by: Marcello Sylvester Bauer <sylv@...v.io>
---
Documentation/hwmon/pli1209bc.rst | 73 +++++++++++++++++++
drivers/hwmon/pmbus/Kconfig | 9 +++
drivers/hwmon/pmbus/Makefile | 1 +
drivers/hwmon/pmbus/pli1209bc.c | 115 ++++++++++++++++++++++++++++++
4 files changed, 198 insertions(+)
create mode 100644 Documentation/hwmon/pli1209bc.rst
create mode 100644 drivers/hwmon/pmbus/pli1209bc.c
diff --git a/Documentation/hwmon/pli1209bc.rst b/Documentation/hwmon/pli1209bc.rst
new file mode 100644
index 000000000000..a3f686d03cf2
--- /dev/null
+++ b/Documentation/hwmon/pli1209bc.rst
@@ -0,0 +1,73 @@
+Kernel driver pli1209bc
+=======================
+
+Supported chips:
+
+ * Digital Supervisor PLI1209BC
+
+ Prefix: 'pli1209bc'
+
+ Addresses scanned: 0x50 - 0x5F
+
+ Datasheet: https://www.vicorpower.com/documents/datasheets/ds-PLI1209BCxyzz-VICOR.pdf
+
+Authors:
+ - Marcello Sylvester Bauer <sylv@...v.io>
+
+Description
+-----------
+
+The Vicor PLI1209BC is an isolated digital power system supervisor thatprovides
+a communication interface between a host processor and one Bus Converter Module
+(BCM). The PLI communicates with a system controller via a PMBus compatible
+interface over an isolated UART interface. Through the PLI, the host processor
+can configure, set protection limits, and monitor the BCM.
+
+Sysfs entries
+-------------
+
+======================= ========================================================
+in1_label "vin2"
+in1_input Input voltage.
+in1_rated_min Minimum rated input voltage.
+in1_rated_max Maximum rated input voltage.
+in1_max Maximum input voltage.
+in1_max_alarm Input voltage high alarm.
+in1_crit Critical input voltage.
+in1_crit_alarm Input voltage critical alarm.
+
+in2_label "vout2"
+in2_input Output voltage.
+in2_rated_min Minimum rated output voltage.
+in2_rated_max Maximum rated output voltage.
+in2_alarm Output voltage alarm
+
+curr1_label "iin2"
+curr1_input Input current.
+curr1_max Maximum input current.
+curr1_max_alarm Maximum input current high alarm.
+curr1_crit Critical input current.
+curr1_crit_alarm Input current critical alarm.
+
+curr2_label "iout2"
+curr2_input Output current.
+curr2_crit Critical output current.
+curr2_crit_alarm Output current critical alarm.
+curr2_max Maximum output current.
+curr2_max_alarm Output current high alarm.
+
+power1_label "pin2"
+power1_input Input power.
+power1_alarm Input power alarm.
+
+power2_label "pout2"
+power2_input Output power.
+power2_rated_max Maximum rated output power.
+
+temp1_input Die temperature.
+temp1_alarm Die temperature alarm.
+temp1_max Maximum die temperature.
+temp1_max_alarm Die temperature high alarm.
+temp1_crit Critical die temperature.
+temp1_crit_alarm Die temperature critical alarm.
+======================= ========================================================
diff --git a/drivers/hwmon/pmbus/Kconfig b/drivers/hwmon/pmbus/Kconfig
index c96f7b7338bd..831db423bea0 100644
--- a/drivers/hwmon/pmbus/Kconfig
+++ b/drivers/hwmon/pmbus/Kconfig
@@ -310,6 +310,15 @@ config SENSORS_PIM4328
This driver can also be built as a module. If so, the module will
be called pim4328.
+config SENSORS_PLI1209BC
+ tristate "Vicor PLI1209BC"
+ help
+ If you say yes here you get hardware monitoring support for Vicor
+ PLI1209BC Digital Supervisor.
+
+ This driver can also be built as a module. If so, the module will
+ be called pli1209bc.
+
config SENSORS_PM6764TR
tristate "ST PM6764TR"
help
diff --git a/drivers/hwmon/pmbus/Makefile b/drivers/hwmon/pmbus/Makefile
index e5935f70c9e0..7ce74e3b8552 100644
--- a/drivers/hwmon/pmbus/Makefile
+++ b/drivers/hwmon/pmbus/Makefile
@@ -34,6 +34,7 @@ obj-$(CONFIG_SENSORS_MP2888) += mp2888.o
obj-$(CONFIG_SENSORS_MP2975) += mp2975.o
obj-$(CONFIG_SENSORS_MP5023) += mp5023.o
obj-$(CONFIG_SENSORS_PM6764TR) += pm6764tr.o
+obj-$(CONFIG_SENSORS_PLI1209BC) += pli1209bc.o
obj-$(CONFIG_SENSORS_PXE1610) += pxe1610.o
obj-$(CONFIG_SENSORS_Q54SJ108A2) += q54sj108a2.o
obj-$(CONFIG_SENSORS_STPDDC60) += stpddc60.o
diff --git a/drivers/hwmon/pmbus/pli1209bc.c b/drivers/hwmon/pmbus/pli1209bc.c
new file mode 100644
index 000000000000..5f8847307e55
--- /dev/null
+++ b/drivers/hwmon/pmbus/pli1209bc.c
@@ -0,0 +1,115 @@
+// SPDX-License-Identifier: GPL-2.0+
+/*
+ * Hardware monitoring driver for Vicor PLI1209BC Digital Supervisor
+ *
+ * Copyright (c) 2022 9elements GmbH
+ */
+
+#include <linux/i2c.h>
+#include <linux/module.h>
+#include <linux/pmbus.h>
+#include "pmbus.h"
+
+/*
+ * The capability command is only supported at page 0. Probing the device while
+ * the page register is set to 1 will falsely enable PEC support. Disable
+ * capability probing accordingly, since the PLI1209BC does not have any
+ * additional capabilities.
+ */
+static struct pmbus_platform_data pli1209bc_plat_data = {
+ .flags = PMBUS_NO_CAPABILITY,
+};
+
+static int pli1209bc_read_word_data(struct i2c_client *client, int page,
+ int phase, int reg)
+{
+ int data;
+
+ switch (reg) {
+ /* PMBUS_READ_POUT uses a direct format with R=0 */
+ case PMBUS_READ_POUT:
+ data = pmbus_read_word_data(client, page, phase, reg);
+ if (data < 0)
+ return data;
+ data = sign_extend32(data, 15) * 10;
+ return clamp_val(data, -32768, 32767) & 0xffff;
+ default:
+ return -ENODATA;
+ }
+}
+
+static struct pmbus_driver_info pli1209bc_info = {
+ .pages = 2,
+ .format[PSC_VOLTAGE_IN] = direct,
+ .format[PSC_VOLTAGE_OUT] = direct,
+ .format[PSC_CURRENT_IN] = direct,
+ .format[PSC_CURRENT_OUT] = direct,
+ .format[PSC_POWER] = direct,
+ .format[PSC_TEMPERATURE] = direct,
+ .m[PSC_VOLTAGE_IN] = 1,
+ .b[PSC_VOLTAGE_IN] = 0,
+ .R[PSC_VOLTAGE_IN] = 1,
+ .m[PSC_VOLTAGE_OUT] = 1,
+ .b[PSC_VOLTAGE_OUT] = 0,
+ .R[PSC_VOLTAGE_OUT] = 1,
+ .m[PSC_CURRENT_IN] = 1,
+ .b[PSC_CURRENT_IN] = 0,
+ .R[PSC_CURRENT_IN] = 3,
+ .m[PSC_CURRENT_OUT] = 1,
+ .b[PSC_CURRENT_OUT] = 0,
+ .R[PSC_CURRENT_OUT] = 2,
+ .m[PSC_POWER] = 1,
+ .b[PSC_POWER] = 0,
+ .R[PSC_POWER] = 1,
+ .m[PSC_TEMPERATURE] = 1,
+ .b[PSC_TEMPERATURE] = 0,
+ .R[PSC_TEMPERATURE] = 0,
+ /*
+ * Page 0 sums up all attributes except voltage readings.
+ * The pli1209 digital supervisor only contains a single BCM, making
+ * page 0 redundant.
+ */
+ .func[1] = PMBUS_HAVE_VIN | PMBUS_HAVE_VOUT
+ | PMBUS_HAVE_IIN | PMBUS_HAVE_IOUT
+ | PMBUS_HAVE_PIN | PMBUS_HAVE_POUT
+ | PMBUS_HAVE_TEMP | PMBUS_HAVE_STATUS_TEMP
+ | PMBUS_HAVE_STATUS_IOUT | PMBUS_HAVE_STATUS_INPUT,
+ .read_word_data = pli1209bc_read_word_data,
+};
+
+static int pli1209bc_probe(struct i2c_client *client)
+{
+ client->dev.platform_data = &pli1209bc_plat_data;
+ return pmbus_do_probe(client, &pli1209bc_info);
+}
+
+static const struct i2c_device_id pli1209bc_id[] = {
+ {"pli1209bc", 0},
+ {}
+};
+
+MODULE_DEVICE_TABLE(i2c, pli1209bc_id);
+
+#ifdef CONFIG_OF
+static const struct of_device_id pli1209bc_of_match[] = {
+ { .compatible = "vicor,pli1209bc" },
+ { },
+};
+MODULE_DEVICE_TABLE(of, pli1209bc_of_match);
+#endif
+
+static struct i2c_driver pli1209bc_driver = {
+ .driver = {
+ .name = "pli1209bc",
+ .of_match_table = of_match_ptr(pli1209bc_of_match),
+ },
+ .probe_new = pli1209bc_probe,
+ .id_table = pli1209bc_id,
+};
+
+module_i2c_driver(pli1209bc_driver);
+
+MODULE_AUTHOR("Marcello Sylvester Bauer <sylv@...v.io>");
+MODULE_DESCRIPTION("PMBus driver for Vicor PLI1209BC");
+MODULE_LICENSE("GPL");
+MODULE_IMPORT_NS(PMBUS);
--
2.34.1
Powered by blists - more mailing lists