| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <73ff1e23-75a9-c2ed-e4a5-3dc62a957a17@microchip.com>
Date: Tue, 22 Feb 2022 14:02:33 +0000
From: <Tudor.Ambarus@...rochip.com>
To: <michael@...le.cc>
CC: <p.yadav@...com>, <broonie@...nel.org>,
<miquel.raynal@...tlin.com>, <richard@....at>, <vigneshr@...com>,
<linux-mtd@...ts.infradead.org>, <linux-kernel@...r.kernel.org>,
<linux-spi@...r.kernel.org>, <Nicolas.Ferre@...rochip.com>,
<zhengxunli@...c.com.tw>, <jaimeliao@...c.com.tw>
Subject: Re: [PATCH 2/4] mtd: spi-nor: core: Allow specifying the byte order
in DTR mode
On 2/21/22 09:36, Michael Walle wrote:
> EXTERNAL EMAIL: Do not click links or open attachments unless you know the content is safe
>
> Am 2022-02-18 15:58, schrieb Tudor Ambarus:
>> Macronix swaps bytes on a 16-bit boundary when configured in Octal DTR.
>> The byte order of 16-bit words is swapped when read or write written in
>> 8D-8D-8D mode compared to STR modes. Swapping the bytes is a bad design
>> decision because this may affect the boot sequence if the entire boot
>> sequence is not handled in either 8D-8D-8D mode or 1-1-1 mode. Allow
>> operations to specify the byte order in DTR mode, so that controllers
>> can
>> swap the bytes back at run-time to fix the endianness, if they are
>> capable.
>>
>> The byte order in 8D-8D-8D mode can be retrieved at run-time by
>> checking
>> BFPT[DWORD(18)] BIT(31). When set to one, the "Byte order of 16-bit
>> words
>> is swapped when read in 8D-8D-8D mode compared to 1-1-1 mode.". It
>> doesn't
>> specify if this applies to both register and data operations. Macronix
>> is
>> the single user of this byte swap and it doesn't have clear rules, as
>> it
>> contains register operations that require data swap (RDPASS, WRPASS,
>> PASSULK, RDSFDP) and register operations that don't require data swap
>> (WRFBR). All these are not common and can be handled in 1-1-1 mode, so
>> we
>> can ignore them for now. All the other register operations are done on
>> one
>> byte length. The read register operations are actually in 8D-8D-8S
>> mode,
>> as they send the data value twice, on each half of the clock cycle. In
>> case
>> of a register write of one byte, the memory supports receiving the
>> register
>> value only on the first byte, thus it discards the value of the byte on
>> the
>> second half of the clock cycle. Swapping the bytes for one byte
>> register
>> writes is not required, and for one byte register reads it doesn't
>> matter.
>> Thus swap the bytes only for read or page program operations.
>>
>> Signed-off-by: Tudor Ambarus <tudor.ambarus@...rochip.com>
>> ---
>> drivers/mtd/spi-nor/core.c | 31 +++++++++++++++++++++++++------
>> drivers/mtd/spi-nor/core.h | 1 +
>> include/linux/mtd/spi-nor.h | 17 +++++++++++++++++
>> 3 files changed, 43 insertions(+), 6 deletions(-)
>>
>> diff --git a/drivers/mtd/spi-nor/core.c b/drivers/mtd/spi-nor/core.c
>> index 04ea180118e3..453d8c54d062 100644
>> --- a/drivers/mtd/spi-nor/core.c
>> +++ b/drivers/mtd/spi-nor/core.c
>> @@ -106,6 +106,9 @@ void spi_nor_spimem_setup_op(const struct spi_nor
>> *nor,
>> op->dummy.dtr = true;
>> op->data.dtr = true;
>>
>> + if (spi_nor_protocol_is_dtr_bswap16(proto))
>> + op->data.dtr_bswap16 = true;
>> +
>> /* 2 bytes per clock cycle in DTR mode. */
>> op->dummy.nbytes *= 2;
>>
>> @@ -388,7 +391,7 @@ int spi_nor_read_sr(struct spi_nor *nor, u8 *sr)
>> SPI_MEM_OP_NO_DUMMY,
>> SPI_MEM_OP_DATA_IN(1, sr, 0));
>>
>> - if (nor->reg_proto == SNOR_PROTO_8_8_8_DTR) {
>> + if (spi_nor_protocol_is_octal_dtr(nor->reg_proto)) {
>> op.addr.nbytes = nor->params->rdsr_addr_nbytes;
>> op.dummy.nbytes = nor->params->rdsr_dummy;
>> /*
>> @@ -432,7 +435,7 @@ static int spi_nor_read_fsr(struct spi_nor *nor, u8
>> *fsr)
>> SPI_MEM_OP_NO_DUMMY,
>> SPI_MEM_OP_DATA_IN(1, fsr, 0));
>>
>> - if (nor->reg_proto == SNOR_PROTO_8_8_8_DTR) {
>> + if (spi_nor_protocol_is_octal_dtr(nor->reg_proto)) {
>> op.addr.nbytes = nor->params->rdsr_addr_nbytes;
>> op.dummy.nbytes = nor->params->rdsr_dummy;
>> /*
>> @@ -2488,7 +2491,7 @@ static int spi_nor_set_addr_width(struct spi_nor
>> *nor)
>> {
>> if (nor->addr_width) {
>> /* already configured from SFDP */
>> - } else if (nor->read_proto == SNOR_PROTO_8_8_8_DTR) {
>> + } else if (spi_nor_protocol_is_octal_dtr(nor->read_proto)) {
>> /*
>> * In 8D-8D-8D mode, one byte takes half a cycle to transfer. So
>> * in this protocol an odd address width cannot be used because
>> @@ -2701,6 +2704,19 @@ static void spi_nor_init_fixup_flags(struct
>> spi_nor *nor)
>> nor->flags |= SNOR_F_IO_MODE_EN_VOLATILE;
>> }
>>
>> +static void spi_nor_set_dtr_bswap16_ops(struct spi_nor *nor)
>> +{
>> + struct spi_nor_flash_parameter *params = nor->params;
>> + u32 mask = SNOR_HWCAPS_READ_8_8_8_DTR | SNOR_HWCAPS_PP_8_8_8_DTR;
>> +
>> + if ((params->hwcaps.mask & mask) == mask) {
>> + params->reads[SNOR_CMD_READ_8_8_8_DTR].proto |=
>> + SNOR_PROTO_IS_DTR_BSWAP16;
>> + params->page_programs[SNOR_CMD_PP_8_8_8_DTR].proto |=
>> + SNOR_PROTO_IS_DTR_BSWAP16;
>> + }
>> +}
>> +
>> /**
>> * spi_nor_late_init_params() - Late initialization of default flash
>> parameters.
>> * @nor: pointer to a 'struct spi_nor'
>> @@ -2721,6 +2737,9 @@ static void spi_nor_late_init_params(struct
>> spi_nor *nor)
>> spi_nor_init_flags(nor);
>> spi_nor_init_fixup_flags(nor);
>>
>> + if (nor->flags & SNOR_F_DTR_BSWAP16)
>> + spi_nor_set_dtr_bswap16_ops(nor);
>> +
>> /*
>> * NOR protection support. When locking_ops are not provided, we pick
>> * the default ones.
>> @@ -2899,8 +2918,8 @@ static int spi_nor_octal_dtr_enable(struct
>> spi_nor *nor, bool enable)
>> if (!nor->params->octal_dtr_enable)
>> return 0;
>>
>> - if (!(nor->read_proto == SNOR_PROTO_8_8_8_DTR &&
>> - nor->write_proto == SNOR_PROTO_8_8_8_DTR))
>> + if (!(spi_nor_protocol_is_octal_dtr(nor->read_proto) &&
>> + spi_nor_protocol_is_octal_dtr(nor->write_proto)))
>> return 0;
>>
>> if (!(nor->flags & SNOR_F_IO_MODE_EN_VOLATILE))
>> @@ -2968,7 +2987,7 @@ static int spi_nor_init(struct spi_nor *nor)
>> spi_nor_try_unlock_all(nor);
>>
>> if (nor->addr_width == 4 &&
>> - nor->read_proto != SNOR_PROTO_8_8_8_DTR &&
>> + !spi_nor_protocol_is_octal_dtr(nor->read_proto) &&
>> !(nor->flags & SNOR_F_4B_OPCODES)) {
>> /*
>> * If the RESET# pin isn't hooked up properly, or the system
>> diff --git a/drivers/mtd/spi-nor/core.h b/drivers/mtd/spi-nor/core.h
>> index 2afb610853a9..7c077d41c335 100644
>> --- a/drivers/mtd/spi-nor/core.h
>> +++ b/drivers/mtd/spi-nor/core.h
>> @@ -29,6 +29,7 @@ enum spi_nor_option_flags {
>> SNOR_F_IO_MODE_EN_VOLATILE = BIT(14),
>> SNOR_F_SOFT_RESET = BIT(15),
>> SNOR_F_SWP_IS_VOLATILE = BIT(16),
>> + SNOR_F_DTR_BSWAP16 = BIT(17),
>> };
>>
>> struct spi_nor_read_command {
>> diff --git a/include/linux/mtd/spi-nor.h b/include/linux/mtd/spi-nor.h
>> index fc90fce26e33..6e9660475c5b 100644
>> --- a/include/linux/mtd/spi-nor.h
>> +++ b/include/linux/mtd/spi-nor.h
>> @@ -168,6 +168,11 @@
>> SNOR_PROTO_DATA_MASK)
>>
>> #define SNOR_PROTO_IS_DTR BIT(24) /* Double Transfer Rate */
>> +/*
>> + * Byte order of 16-bit words is swapped when read or written in DTR
>> mode
>> + * compared to STR mode.
>> + */
>> +#define SNOR_PROTO_IS_DTR_BSWAP16 BIT(25)
>>
>> #define SNOR_PROTO_STR(_inst_nbits, _addr_nbits, _data_nbits) \
>> (SNOR_PROTO_INST(_inst_nbits) | \
>> @@ -201,6 +206,18 @@ static inline bool spi_nor_protocol_is_dtr(enum
>> spi_nor_protocol proto)
>> return !!(proto & SNOR_PROTO_IS_DTR);
>> }
>>
>> +static inline bool spi_nor_protocol_is_octal_dtr(enum spi_nor_protocol
>> proto)
>> +{
>> + return ((proto & SNOR_PROTO_8_8_8_DTR) == SNOR_PROTO_8_8_8_DTR);
>
> This looks wrong what if there are 0's in SNOR_PROTO_8_8_8_DTR? If this
> happens to be the same as SNOR_PROTO_MASK (which doesn't exist) this
> deserves a comment.
I'm not sure I understand the comment. SNOR_PROTO_8_8_8_DTR has value 0x80808.
This method is added to cover the classical 8D-8D-8D mode and the 8D-8D-8D mode
with bytes swapped. This method will return true for both cases.
>
>> +}
>> +
>> +static inline bool spi_nor_protocol_is_dtr_bswap16(enum
>> spi_nor_protocol proto)
>> +{
>> + u32 mask = SNOR_PROTO_IS_DTR | SNOR_PROTO_IS_DTR_BSWAP16;
>> +
>> + return ((proto & mask) == mask);
>
> isn't "return proto & SNOR_PROTO_IS_DTR_BSWAP16;" enough here?
Byte swap can be done only on DTR modes. SNOR_PROTO_IS_DTR_BSWAP16
without SNOR_PROTO_IS_DTR doesn't make sense. This method includes
this sanity check.
Cheers,
ta
>
>> +}
>> +
>> static inline u8 spi_nor_get_protocol_inst_nbits(enum spi_nor_protocol
>> proto)
>> {
>> return ((unsigned long)(proto & SNOR_PROTO_INST_MASK)) >>
>
> -michael
Powered by blists - more mailing lists