[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <9e48a247-1f2c-795d-3991-f820cf66ee05@linaro.org>
Date: Sat, 6 May 2023 11:03:48 +0200
From: Konrad Dybcio <konrad.dybcio@...aro.org>
To: Dang Huynh <danct12@...eup.net>, Andy Gross <agross@...nel.org>,
Bjorn Andersson <andersson@...nel.org>,
Rob Herring <robh+dt@...nel.org>,
Krzysztof Kozlowski <krzysztof.kozlowski+dt@...aro.org>
Cc: linux-arm-msm@...r.kernel.org, devicetree@...r.kernel.org,
linux-kernel@...r.kernel.org
Subject: Re: [PATCH v2 1/2] arm64: dts: qcom: Add Fxtec Pro1X (QX1050) DTS
On 6.05.2023 03:42, Dang Huynh wrote:
>>> + qcom,board-id = <34 0>;
>>
>> Does the bootloader refuse to boot without these? Some newer
>> ones don't need it.
>>
>> In case they are compulsory, you'll have to add the pro1x to the
>> relevant allOf:if:then: block in bindings.
>>
> Tested, nope.
>
>>> +&usb_dwc3 {
>>> + maximum-speed = "high-speed";
>>
>> Do you know whether the phone supports usb3? Usually if that's
>> the case, you will get usb3 in fastboot.
>>
>> You'll need an actual usb3 cable to check that though, many claim
>> that but then don't have the necessary wires connected.
> I asked around, they said yes but without anything to test on hand, I'm not
> sure.
>
> Should I remove it or something?
No, you may get weird behavior. Keep it high-speed for now.
Konrad
>
> Other than that, I've fixed the other issues with the series.
>
> Best regards,
> Dang
>
>
Powered by blists - more mailing lists