[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-Id: <20230816173116.1176-4-wsa+renesas@sang-engineering.com>
Date: Wed, 16 Aug 2023 19:31:15 +0200
From: Wolfram Sang <wsa+renesas@...g-engineering.com>
To: linux-renesas-soc@...r.kernel.org
Cc: Wolfram Sang <wsa+renesas@...g-engineering.com>,
Johan Hovold <johan@...nel.org>, linux-kernel@...r.kernel.org
Subject: [PATCH v2 3/3] gnss: ubx: add support for the reset gpio
Tested with a Renesas KingFisher board. Because my GNSS device is hooked
up via UART and I2C simultaneously, I could verify functionality by
opening/closing the GNSS device using UART and see if the corresponding
I2C device was visible on the bus.
Signed-off-by: Wolfram Sang <wsa+renesas@...g-engineering.com>
---
Changes since v1:
* proper reverse order in ubx_set_standby (Thanks, Geert!)
* simplified the comment when initiall asserting the GPIO (Thanks, Geert!)
drivers/gnss/ubx.c | 13 +++++++++++++
1 file changed, 13 insertions(+)
diff --git a/drivers/gnss/ubx.c b/drivers/gnss/ubx.c
index 9b76b101ba5e..e7d151cbc8c3 100644
--- a/drivers/gnss/ubx.c
+++ b/drivers/gnss/ubx.c
@@ -7,6 +7,7 @@
#include <linux/errno.h>
#include <linux/gnss.h>
+#include <linux/gpio/consumer.h>
#include <linux/init.h>
#include <linux/kernel.h>
#include <linux/module.h>
@@ -18,6 +19,7 @@
struct ubx_data {
struct regulator *vcc;
+ struct gpio_desc *reset_gpio;
};
static int ubx_set_active(struct gnss_serial *gserial)
@@ -29,6 +31,8 @@ static int ubx_set_active(struct gnss_serial *gserial)
if (ret)
return ret;
+ gpiod_set_value_cansleep(data->reset_gpio, 0);
+
return 0;
}
@@ -37,6 +41,8 @@ static int ubx_set_standby(struct gnss_serial *gserial)
struct ubx_data *data = gnss_serial_get_drvdata(gserial);
int ret;
+ gpiod_set_value_cansleep(data->reset_gpio, 1);
+
ret = regulator_disable(data->vcc);
if (ret)
return ret;
@@ -90,6 +96,13 @@ static int ubx_probe(struct serdev_device *serdev)
if (ret < 0 && ret != -ENODEV)
goto err_free_gserial;
+ /* Start with reset asserted */
+ data->reset_gpio = devm_gpiod_get_optional(&serdev->dev, "reset", GPIOD_OUT_HIGH);
+ if (IS_ERR(data->reset_gpio)) {
+ ret = PTR_ERR(data->reset_gpio);
+ goto err_free_gserial;
+ }
+
ret = gnss_serial_register(gserial);
if (ret)
goto err_free_gserial;
--
2.35.1
Powered by blists - more mailing lists