lists.openwall.net   lists  /  announce  owl-users  owl-dev  john-users  john-dev  passwdqc-users  yescrypt  popa3d-users  /  oss-security  kernel-hardening  musl  sabotage  tlsify  passwords  /  crypt-dev  xvendor  /  Bugtraq  Full-Disclosure  linux-kernel  linux-netdev  linux-ext4  linux-hardening  linux-cve-announce  PHC 
Open Source and information security mailing list archives
 
Hash Suite: Windows password security audit tool. GUI, reports in PDF.
[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <nhpeyezvodnww4m4hou3of5xy7lbvme5jydpprpmj3yzr7yarj@thiyvzume4bo>
Date: Fri, 18 Oct 2024 01:24:40 +0300
From: Dmitry Baryshkov <dmitry.baryshkov@...aro.org>
To: Alexey Klimov <alexey.klimov@...aro.org>
Cc: srinivas.kandagatla@...aro.org, a39.skl@...il.com, 
	linux-sound@...r.kernel.org, broonie@...nel.org, lgirdwood@...il.com, perex@...ex.cz, 
	tiwai@...e.com, alsa-devel@...a-project.org, linux-arm-msm@...r.kernel.org, 
	linux-kernel@...r.kernel.org, krzysztof.kozlowski@...aro.org, vkoul@...nel.org
Subject: Re: [PATCH v2] ASoC: codecs: lpass-rx-macro: fix RXn(rx,n) macro for
 DSM_CTL and SEC7 regs

On Wed, Oct 16, 2024 at 11:10:49PM +0100, Alexey Klimov wrote:
> Turns out some registers of pre-2.5 version of rxmacro codecs are not
> located at the expected offsets but 0xc further away in memory. So far
> the detected registers are CDC_RX_RX2_RX_PATH_SEC7 and
> CDC_RX_RX2_RX_PATH_DSM_CTL.
> 
> CDC_RX_RXn_RX_PATH_DSM_CTL(rx, n) macro incorrectly generates the address
> 0x540 for RX2 but it should be 0x54C and it also overwrites
> CDC_RX_RX2_RX_PATH_SEC7 which is located at 0x540.
> The same goes for CDC_RX_RXn_RX_PATH_SEC7(rx, n).
> 
> Fix this by introducing additional rxn_reg_stride2 offset. For 2.5 version
> and above this offset will be equal to 0.
> With such change the corresponding RXn() macros will generate the same
> values for 2.5 codec version for all RX paths and the same old values
> for pre-2.5 version for RX0 and RX1. However for the latter case with
> RX2 path it will also add rxn_reg_stride2 on top.
> 
> While at this, also remove specific if-check for INTERP_AUX from
> rx_macro_digital_mute() and rx_macro_enable_interp_clk(). These if-check
> was used to handle such special offset for AUX interpolator but since
> CDC_RX_RXn_RX_PATH_SEC7(rx, n) and CDC_RX_RXn_RX_PATH_DSM_CTL(rx, n)
> macros will generate the correst addresses of dsm register, they are no
> longer needed.
> 
> Cc: Srinivas Kandagatla <srinivas.kandagatla@...aro.org>
> Cc: Krzysztof Kozlowski <krzysztof.kozlowski@...aro.org>
> Signed-off-by: Alexey Klimov <alexey.klimov@...aro.org>
> ---
> 

Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@...aro.org>

-- 
With best wishes
Dmitry

Powered by blists - more mailing lists

Powered by Openwall GNU/*/Linux Powered by OpenVZ