[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-Id: <20241112075242.174010-2-linchengming884@gmail.com>
Date: Tue, 12 Nov 2024 15:52:42 +0800
From: Cheng Ming Lin <linchengming884@...il.com>
To: tudor.ambarus@...aro.org,
pratyush@...nel.org,
mwalle@...nel.org,
miquel.raynal@...tlin.com,
richard@....at,
vigneshr@...com,
linux-mtd@...ts.infradead.org,
linux-kernel@...r.kernel.org
Cc: alvinzhou@...c.com.tw,
leoyu@...c.com.tw,
Cheng Ming Lin <chengminglin@...c.com.tw>,
stable@...r.kernel.org
Subject: [PATCH v2 1/1] mtd: spi-nor: core: replace dummy buswidth from addr to data
From: Cheng Ming Lin <chengminglin@...c.com.tw>
The default dummy cycle for Macronix SPI NOR flash in Octal Output
Read Mode(1-1-8) is 20.
Currently, the dummy buswidth is set according to the address bus width.
In the 1-1-8 mode, this means the dummy buswidth is 1. When converting
dummy cycles to bytes, this results in 20 x 1 / 8 = 2 bytes, causing the
host to read data 4 cycles too early.
Since the protocol data buswidth is always greater than or equal to the
address buswidth. Setting the dummy buswidth to match the data buswidth
increases the likelihood that the dummy cycle-to-byte conversion will be
divisible, preventing the host from reading data prematurely.
Fixes: 0e30f47232ab5 ("mtd: spi-nor: add support for DTR protocol")
Cc: stable@...r.kernel.org
Reviewd-by: Pratyush Yadav <pratyush@...nel.org>
Signed-off-by: Cheng Ming Lin <chengminglin@...c.com.tw>
---
drivers/mtd/spi-nor/core.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/mtd/spi-nor/core.c b/drivers/mtd/spi-nor/core.c
index f9c189ed7353..c7aceaa8a43f 100644
--- a/drivers/mtd/spi-nor/core.c
+++ b/drivers/mtd/spi-nor/core.c
@@ -89,7 +89,7 @@ void spi_nor_spimem_setup_op(const struct spi_nor *nor,
op->addr.buswidth = spi_nor_get_protocol_addr_nbits(proto);
if (op->dummy.nbytes)
- op->dummy.buswidth = spi_nor_get_protocol_addr_nbits(proto);
+ op->dummy.buswidth = spi_nor_get_protocol_data_nbits(proto);
if (op->data.nbytes)
op->data.buswidth = spi_nor_get_protocol_data_nbits(proto);
--
2.25.1
Powered by blists - more mailing lists