| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <20241209161427.3580256-3-Tarun.Alle@microchip.com>
Date: Mon, 9 Dec 2024 21:44:27 +0530
From: Tarun Alle <Tarun.Alle@...rochip.com>
To: <arun.ramadoss@...rochip.com>, <UNGLinuxDriver@...rochip.com>,
<andrew@...n.ch>, <hkallweit1@...il.com>, <linux@...linux.org.uk>,
<davem@...emloft.net>, <edumazet@...gle.com>, <kuba@...nel.org>,
<pabeni@...hat.com>, <netdev@...r.kernel.org>, <linux-kernel@...r.kernel.org>
Subject: [PATCH net-next 2/2] net: phy: microchip_t1: Autonegotiaion support for LAN887x T1 phy
Adds auto-negotiation support for lan887x T1 phy.
Signed-off-by: Tarun Alle <Tarun.Alle@...rochip.com>
---
drivers/net/phy/microchip_t1.c | 147 +++++++++++++++++++++++++++------
1 file changed, 121 insertions(+), 26 deletions(-)
diff --git a/drivers/net/phy/microchip_t1.c b/drivers/net/phy/microchip_t1.c
index b17bf6708003..b8e65cb7d29e 100644
--- a/drivers/net/phy/microchip_t1.c
+++ b/drivers/net/phy/microchip_t1.c
@@ -268,6 +268,11 @@
/* End offset of samples */
#define SQI_INLIERS_END (SQI_INLIERS_START + SQI_INLIERS_NUM)
+#define LAN887X_VEND_CTRL_STAT_REG 0x8013
+#define LAN887X_AN_LOCAL_CFG_FAULT BIT(10)
+#define LAN887X_AN_LOCAL_SLAVE BIT(9)
+#define LAN887X_AN_LOCAL_MASTER BIT(8)
+
#define DRIVER_AUTHOR "Nisar Sayed <nisar.sayed@...rochip.com>"
#define DRIVER_DESC "Microchip LAN87XX/LAN937x/LAN887x T1 PHY driver"
@@ -1259,11 +1264,6 @@ static int lan887x_get_features(struct phy_device *phydev)
/* Enable twisted pair */
linkmode_set_bit(ETHTOOL_LINK_MODE_TP_BIT, phydev->supported);
- /* First patch only supports 100Mbps and 1000Mbps force-mode.
- * T1 Auto-Negotiation (Clause 98 of IEEE 802.3) will be added later.
- */
- linkmode_clear_bit(ETHTOOL_LINK_MODE_Autoneg_BIT, phydev->supported);
-
return 0;
}
@@ -1344,25 +1344,34 @@ static int lan887x_phy_setup(struct phy_device *phydev)
static int lan887x_100M_setup(struct phy_device *phydev)
{
+ static const struct lan887x_regwr_map phy_comm_cfg[] = {
+ {MDIO_MMD_PMAPMD, LAN887X_AFE_PORT_TESTBUS_CTRL4, 0x00b8},
+ {MDIO_MMD_PMAPMD, LAN887X_TX_AMPLT_1000T1_REG, 0x0038},
+ {MDIO_MMD_VEND1, LAN887X_INIT_COEFF_DFE1_100, 0x000f},
+ };
int ret;
/* (Re)configure the speed/mode dependent T1 settings */
- if (phydev->master_slave_set == MASTER_SLAVE_CFG_MASTER_FORCE ||
- phydev->master_slave_set == MASTER_SLAVE_CFG_MASTER_PREFERRED){
- static const struct lan887x_regwr_map phy_cfg[] = {
- {MDIO_MMD_PMAPMD, LAN887X_AFE_PORT_TESTBUS_CTRL4, 0x00b8},
- {MDIO_MMD_PMAPMD, LAN887X_TX_AMPLT_1000T1_REG, 0x0038},
- {MDIO_MMD_VEND1, LAN887X_INIT_COEFF_DFE1_100, 0x000f},
- };
-
- ret = lan887x_phy_config(phydev, phy_cfg, ARRAY_SIZE(phy_cfg));
+ if (phydev->autoneg == AUTONEG_DISABLE) {
+ if (phydev->master_slave_set == MASTER_SLAVE_CFG_MASTER_FORCE ||
+ phydev->master_slave_set ==
+ MASTER_SLAVE_CFG_MASTER_PREFERRED) {
+ ret = lan887x_phy_config(phydev, phy_comm_cfg,
+ ARRAY_SIZE(phy_comm_cfg));
+ } else {
+ static const struct lan887x_regwr_map phy_cfg[] = {
+ {MDIO_MMD_PMAPMD, LAN887X_AFE_PORT_TESTBUS_CTRL4,
+ 0x0038},
+ {MDIO_MMD_VEND1, LAN887X_INIT_COEFF_DFE1_100,
+ 0x0014},
+ };
+
+ ret = lan887x_phy_config(phydev, phy_cfg,
+ ARRAY_SIZE(phy_cfg));
+ }
} else {
- static const struct lan887x_regwr_map phy_cfg[] = {
- {MDIO_MMD_PMAPMD, LAN887X_AFE_PORT_TESTBUS_CTRL4, 0x0038},
- {MDIO_MMD_VEND1, LAN887X_INIT_COEFF_DFE1_100, 0x0014},
- };
-
- ret = lan887x_phy_config(phydev, phy_cfg, ARRAY_SIZE(phy_cfg));
+ ret = lan887x_phy_config(phydev, phy_comm_cfg,
+ ARRAY_SIZE(phy_comm_cfg));
}
if (ret < 0)
return ret;
@@ -1384,8 +1393,16 @@ static int lan887x_1000M_setup(struct phy_device *phydev)
if (ret < 0)
return ret;
- return phy_set_bits_mmd(phydev, MDIO_MMD_PMAPMD, LAN887X_DSP_PMA_CONTROL,
- LAN887X_DSP_PMA_CONTROL_LNK_SYNC);
+ if (phydev->autoneg == AUTONEG_ENABLE)
+ ret = phy_set_bits_mmd(phydev, MDIO_MMD_VEND1,
+ LAN887X_REG_REG26,
+ LAN887X_REG_REG26_HW_INIT_SEQ_EN);
+ else
+ ret = phy_set_bits_mmd(phydev, MDIO_MMD_PMAPMD,
+ LAN887X_DSP_PMA_CONTROL,
+ LAN887X_DSP_PMA_CONTROL_LNK_SYNC);
+
+ return ret;
}
static int lan887x_link_setup(struct phy_device *phydev)
@@ -1407,6 +1424,11 @@ static int lan887x_phy_reset(struct phy_device *phydev)
{
int ret, val;
+ /* Disable aneg */
+ ret = genphy_c45_an_disable_aneg(phydev);
+ if (ret < 0)
+ return ret;
+
/* Clear 1000M link sync */
ret = phy_clear_bits_mmd(phydev, MDIO_MMD_PMAPMD, LAN887X_DSP_PMA_CONTROL,
LAN887X_DSP_PMA_CONTROL_LNK_SYNC);
@@ -1435,23 +1457,68 @@ static int lan887x_phy_reset(struct phy_device *phydev)
5000, 10000, true);
}
+/* LAN887X Errata: 100M master issue. Dual speed in Aneg is not supported. */
+static int lan887x_config_advert(struct phy_device *phydev)
+{
+ linkmode_and(phydev->advertising, phydev->advertising,
+ phydev->supported);
+
+ if (linkmode_test_bit(ETHTOOL_LINK_MODE_1000baseT1_Full_BIT,
+ phydev->advertising)) {
+ linkmode_clear_bit(ETHTOOL_LINK_MODE_100baseT1_Full_BIT,
+ phydev->advertising);
+ phydev->speed = SPEED_1000;
+ } else if (linkmode_test_bit(ETHTOOL_LINK_MODE_100baseT1_Full_BIT,
+ phydev->advertising)) {
+ linkmode_clear_bit(ETHTOOL_LINK_MODE_1000baseT1_Full_BIT,
+ phydev->advertising);
+ phydev->speed = SPEED_100;
+ } else {
+ return -EINVAL;
+ }
+
+ return 0;
+}
+
static int lan887x_phy_reconfig(struct phy_device *phydev)
{
int ret;
- linkmode_zero(phydev->advertising);
+ if (phydev->autoneg == AUTONEG_ENABLE)
+ ret = genphy_c45_an_config_aneg(phydev);
+ else
+ ret = genphy_c45_pma_setup_forced(phydev);
+ if (ret < 0)
+ return ret;
- ret = genphy_c45_pma_setup_forced(phydev);
+ /* For link to comeup, (re)configure the speed/mode
+ * dependent T1 settings
+ */
+ ret = lan887x_link_setup(phydev);
if (ret < 0)
return ret;
- return lan887x_link_setup(phydev);
+ /* Autoneg to be re-started only after all settings are done */
+ if (phydev->autoneg == AUTONEG_ENABLE) {
+ ret = genphy_c45_restart_aneg(phydev);
+ if (ret < 0)
+ return ret;
+ }
+
+ return 0;
}
static int lan887x_config_aneg(struct phy_device *phydev)
{
int ret;
+ /* Reject the not support advertisement settings */
+ if (phydev->autoneg == AUTONEG_ENABLE) {
+ ret = lan887x_config_advert(phydev);
+ if (ret < 0)
+ return ret;
+ }
+
/* LAN887x Errata: speed configuration changes require soft reset
* and chip soft reset
*/
@@ -2058,6 +2125,34 @@ static int lan887x_get_sqi(struct phy_device *phydev)
return FIELD_GET(T1_DCQ_SQI_MSK, rc);
}
+static int lan887x_read_status(struct phy_device *phydev)
+{
+ int rc;
+
+ phydev->master_slave_state = MASTER_SLAVE_STATE_UNKNOWN;
+
+ rc = genphy_c45_read_status(phydev);
+ if (rc < 0)
+ return rc;
+
+ if (phydev->autoneg == AUTONEG_ENABLE) {
+ /* Fetch resolved mode */
+ rc = phy_read_mmd(phydev, MDIO_MMD_AN,
+ LAN887X_VEND_CTRL_STAT_REG);
+ if (rc < 0)
+ return rc;
+
+ if (rc & LAN887X_AN_LOCAL_MASTER)
+ phydev->master_slave_state = MASTER_SLAVE_STATE_MASTER;
+ else if (rc & LAN887X_AN_LOCAL_SLAVE)
+ phydev->master_slave_state = MASTER_SLAVE_STATE_SLAVE;
+ else if (rc & LAN887X_AN_LOCAL_CFG_FAULT)
+ phydev->master_slave_state = MASTER_SLAVE_STATE_ERR;
+ }
+
+ return 0;
+}
+
static struct phy_driver microchip_t1_phy_driver[] = {
{
PHY_ID_MATCH_MODEL(PHY_ID_LAN87XX),
@@ -2106,7 +2201,7 @@ static struct phy_driver microchip_t1_phy_driver[] = {
.get_strings = lan887x_get_strings,
.suspend = genphy_suspend,
.resume = genphy_resume,
- .read_status = genphy_c45_read_status,
+ .read_status = lan887x_read_status,
.cable_test_start = lan887x_cable_test_start,
.cable_test_get_status = lan887x_cable_test_get_status,
.config_intr = lan887x_config_intr,
--
2.34.1
Powered by blists - more mailing lists