[<prev] [next>] [<thread-prev] [day] [month] [year] [list]
Message-ID: <aTF7qbjbtYqZCR95@smile.fi.intel.com>
Date: Thu, 4 Dec 2025 14:16:41 +0200
From: Andy Shevchenko <andriy.shevchenko@...el.com>
To: Tomas Melin <tomas.melin@...sala.com>
Cc: Lars-Peter Clausen <lars@...afoo.de>,
Michael Hennerich <Michael.Hennerich@...log.com>,
Nuno Sa <nuno.sa@...log.com>, Jonathan Cameron <jic23@...nel.org>,
David Lechner <dlechner@...libre.com>,
Andy Shevchenko <andy@...nel.org>, Rob Herring <robh@...nel.org>,
Krzysztof Kozlowski <krzk+dt@...nel.org>,
Conor Dooley <conor+dt@...nel.org>, linux-iio@...r.kernel.org,
devicetree@...r.kernel.org, linux-kernel@...r.kernel.org
Subject: Re: [PATCH v2 2/2] iio: adc: ad9467: add support for ad9211
On Thu, Dec 04, 2025 at 02:14:49PM +0200, Andy Shevchenko wrote:
> On Thu, Dec 04, 2025 at 08:01:04AM +0000, Tomas Melin wrote:
> > The AD9211 is a 10-bit monolithic sampling analog-to-digital
> > converter optimized for high performance, low power, and ease
Also just noticed that this paragraph is visible shorter than the last one,
can you make them approximately the same line length?
> > of use. The product operates at up to a 300 MSPS conversion
Is it megasamples? Then MSps?
> > rate and is optimized for outstanding dynamic performance
> > in wideband carrier and broadband systems.
> > The scale table implemented here is not an exact match with the
> > datasheet as the table presented there is missing some information.
> > The reference presents these values as being linear,
> > but that does not add up. There is information missing in the table.
> > Implemented scale table matches values at the middle and at the ends,
> > smoothing the curve towards middle and end.
> > Impact on end result from deviation in scale factor affects only software
> > using it for scaling. All the possible hw-settings are also available with
> > this implementation.
>
>
> Some amendment in the headers would be nice to have,
> Reviewed-by: Andy Shevchenko <andriy.shevchenko@...el.com>
...
> + array_size.h
>
> > #include <linux/delay.h>
> > #include <linux/gpio/consumer.h>
> > #include <linux/of.h>
> > +#include <linux/units.h>
> >
>
> You can drop one blank line here.
--
With Best Regards,
Andy Shevchenko
Powered by blists - more mailing lists