[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <aUVPSyoDE35eL4iQ@hu-vishsain-blr.qualcomm.com>
Date: Fri, 19 Dec 2025 18:42:43 +0530
From: Vishnu Saini <vishnu.saini@....qualcomm.com>
To: Krzysztof Kozlowski <krzk@...nel.org>
Cc: Bjorn Andersson <andersson@...nel.org>,
Konrad Dybcio <konradybcio@...nel.org>, Rob Herring <robh@...nel.org>,
Krzysztof Kozlowski <krzk+dt@...nel.org>,
Conor Dooley <conor+dt@...nel.org>, linux-arm-msm@...r.kernel.org,
devicetree@...r.kernel.org, linux-kernel@...r.kernel.org,
prahlad.valluru@....qualcomm.com,
Prahlad Valluru <vvalluru@....qualcomm.com>
Subject: Re: [PATCH v2 1/2] arm64: dts: qcom: monaco: add lt8713sx bridge
with displayport
On Fri, Dec 19, 2025 at 01:16:41PM +0100, Krzysztof Kozlowski wrote:
> On 19/12/2025 12:32, Vishnu Saini wrote:
> > Monaco-evk has LT8713sx which act as DP to 3 DP output
> > converter. Edp PHY from monaco soc is connected to lt8713sx
> > as input and output of lt8713sx is connected to 3 mini DP ports.
> >
> > Two ports are available in mainboard and one port
> > is available on Mezz board.
> >
> > lt8713sx is connected to soc over i2c0 and with reset gpio
> > connected to pin6 of ioexpander5.
> >
> > Enable the edp nodes from monaco and enable lontium lt8713sx
> > bridge node.
>
>
> And how much time did you give to maintainers to respond to your
> comments before sending v2?
>
> You gave yourself 1 month. To the community you give 7 minutes.
>
> That's just unacceptable.
Apologies again maintainers, i will be more careful next time.
> NAK.
>
> Best regards,
> Krzysztof
Powered by blists - more mailing lists