| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <14851f8e-b6ac-42ff-9623-b7ac8d8893e2@huawei.com>
Date: Thu, 25 Dec 2025 20:06:54 +0800
From: "zhenglifeng (A)" <zhenglifeng1@...wei.com>
To: Sumit Gupta <sumitg@...dia.com>, <rafael@...nel.org>,
<viresh.kumar@...aro.org>, <lenb@...nel.org>, <robert.moore@...el.com>,
<corbet@....net>, <pierre.gondois@....com>, <rdunlap@...radead.org>,
<ray.huang@....com>, <gautham.shenoy@....com>, <mario.limonciello@....com>,
<perry.yuan@....com>, <ionela.voinescu@....com>, <zhanjie9@...ilicon.com>,
<linux-pm@...r.kernel.org>, <linux-acpi@...r.kernel.org>,
<linux-doc@...r.kernel.org>, <acpica-devel@...ts.linux.dev>,
<linux-kernel@...r.kernel.org>
CC: <linux-tegra@...r.kernel.org>, <treding@...dia.com>,
<jonathanh@...dia.com>, <vsethi@...dia.com>, <ksitaraman@...dia.com>,
<sanjayc@...dia.com>, <nhartman@...dia.com>, <bbasu@...dia.com>
Subject: Re: [PATCH v5 06/11] ACPI: CPPC: add APIs and sysfs interface for
perf_limited
On 2025/12/23 20:13, Sumit Gupta wrote:
> Add sysfs interface to read/write the Performance Limited register.
>
> The Performance Limited register indicates to the OS that an
> unpredictable event (like thermal throttling) has limited processor
> performance. It contains two sticky bits set by the platform:
> - Bit 0 (Desired_Excursion): Set when delivered performance is
> constrained below desired performance. Not used when Autonomous
> Selection is enabled.
> - Bit 1 (Minimum_Excursion): Set when delivered performance is
> constrained below minimum performance.
>
> These bits remain set until OSPM explicitly clears them. The write
> operation accepts a bitmask of bits to clear:
> - Write 1 to clear bit 0
> - Write 2 to clear bit 1
> - Write 3 to clear both bits
It's a bit odd that users write a 1 to and then read a 0 from the sysfs
file. I think it is better to seperate these two bits, as two sysfs files.
Then users can write '0' or 'clear' or others into them to clear each bit.
>
> This enables users to detect if platform throttling impacted a workload.
> Users clear the register before execution, run the workload, then check
> afterward - if set, hardware throttling occurred during that time window.
>
> The interface is exposed as:
> /sys/devices/system/cpu/cpuX/cpufreq/perf_limited
>
> Signed-off-by: Sumit Gupta <sumitg@...dia.com>
> ---
> drivers/acpi/cppc_acpi.c | 56 ++++++++++++++++++++++++++++++++++
> drivers/cpufreq/cppc_cpufreq.c | 31 +++++++++++++++++++
> include/acpi/cppc_acpi.h | 15 +++++++++
> 3 files changed, 102 insertions(+)
>
> diff --git a/drivers/acpi/cppc_acpi.c b/drivers/acpi/cppc_acpi.c
> index 9f28c20d902d..ffd866c1c00d 100644
> --- a/drivers/acpi/cppc_acpi.c
> +++ b/drivers/acpi/cppc_acpi.c
> @@ -1786,6 +1786,62 @@ int cppc_set_max_perf(int cpu, u32 max_perf)
> }
> EXPORT_SYMBOL_GPL(cppc_set_max_perf);
>
> +/**
> + * cppc_get_perf_limited - Get the Performance Limited register value.
> + * @cpu: CPU from which to get Performance Limited register.
> + * @perf_limited: Pointer to store the Performance Limited value.
> + *
> + * The returned value contains sticky status bits indicating platform-imposed
> + * performance limitations.
> + *
> + * Return: 0 for success, -EIO on failure, -EOPNOTSUPP if not supported.
> + */
> +int cppc_get_perf_limited(int cpu, u64 *perf_limited)
> +{
> + return cppc_get_reg_val(cpu, PERF_LIMITED, perf_limited);
> +}
> +EXPORT_SYMBOL_GPL(cppc_get_perf_limited);
> +
> +/**
> + * cppc_set_perf_limited() - Clear bits in the Performance Limited register.
> + * @cpu: CPU on which to write register.
> + * @bits_to_clear: Bitmask of bits to clear in the perf_limited register.
> + *
> + * The Performance Limited register contains two sticky bits set by platform:
> + * - Bit 0 (Desired_Excursion): Set when delivered performance is constrained
> + * below desired performance. Not used when Autonomous Selection is enabled.
> + * - Bit 1 (Minimum_Excursion): Set when delivered performance is constrained
> + * below minimum performance.
> + *
> + * These bits are sticky and remain set until OSPM explicitly clears them.
> + * This function only allows clearing bits (the platform sets them).
> + *
> + * Return: 0 for success, -EINVAL for invalid bits, -EIO on register
> + * access failure, -EOPNOTSUPP if not supported.
> + */
> +int cppc_set_perf_limited(int cpu, u64 bits_to_clear)
> +{
> + u64 current_val, new_val;
> + int ret;
> +
> + /* Only bits 0 and 1 are valid */
> + if (bits_to_clear & ~CPPC_PERF_LIMITED_MASK)
> + return -EINVAL;
> +
> + if (!bits_to_clear)
> + return 0;
> +
> + ret = cppc_get_perf_limited(cpu, ¤t_val);
> + if (ret)
> + return ret;
> +
> + /* Clear the specified bits */
> + new_val = current_val & ~bits_to_clear;
> +
> + return cppc_set_reg_val(cpu, PERF_LIMITED, new_val);
> +}
> +EXPORT_SYMBOL_GPL(cppc_set_perf_limited);
> +
> /**
> * cppc_set_enable - Set to enable CPPC on the processor by writing the
> * Continuous Performance Control package EnableRegister field.
> diff --git a/drivers/cpufreq/cppc_cpufreq.c b/drivers/cpufreq/cppc_cpufreq.c
> index 1e282dfabc76..1f8825006940 100644
> --- a/drivers/cpufreq/cppc_cpufreq.c
> +++ b/drivers/cpufreq/cppc_cpufreq.c
> @@ -1052,12 +1052,42 @@ static ssize_t store_max_perf(struct cpufreq_policy *policy, const char *buf,
> return count;
> }
>
> +/**
> + * show_perf_limited - Show Performance Limited register status
> + * @policy: cpufreq policy
> + * @buf: buffer to write the value to
> + *
> + * Read the Performance Limited register to check if platform throttling
> + * (thermal/power/current limits) occurred.
> + */
> +static ssize_t show_perf_limited(struct cpufreq_policy *policy, char *buf)
> +{
> + return cppc_cpufreq_sysfs_show_u64(policy->cpu,
> + cppc_get_perf_limited, buf);
> +}
> +
> +/**
> + * store_perf_limited - Clear Performance Limited register bits
> + * @policy: cpufreq policy
> + * @buf: buffer containing the bitmask of bits to clear
> + * @count: number of bytes in buf
> + *
> + * Write 1 to clear bit 0, 2 to clear bit 1, or 3 to clear both.
> + */
> +static ssize_t store_perf_limited(struct cpufreq_policy *policy,
> + const char *buf, size_t count)
> +{
> + return cppc_cpufreq_sysfs_store_u64(policy->cpu,
> + cppc_set_perf_limited, buf, count);
> +}
> +
> cpufreq_freq_attr_ro(freqdomain_cpus);
> cpufreq_freq_attr_rw(auto_select);
> cpufreq_freq_attr_rw(auto_act_window);
> cpufreq_freq_attr_rw(energy_performance_preference_val);
> cpufreq_freq_attr_rw(min_perf);
> cpufreq_freq_attr_rw(max_perf);
> +cpufreq_freq_attr_rw(perf_limited);
>
> static struct freq_attr *cppc_cpufreq_attr[] = {
> &freqdomain_cpus,
> @@ -1066,6 +1096,7 @@ static struct freq_attr *cppc_cpufreq_attr[] = {
> &energy_performance_preference_val,
> &min_perf,
> &max_perf,
> + &perf_limited,
> NULL,
> };
>
> diff --git a/include/acpi/cppc_acpi.h b/include/acpi/cppc_acpi.h
> index a49b50bddaf9..57e04326a4b6 100644
> --- a/include/acpi/cppc_acpi.h
> +++ b/include/acpi/cppc_acpi.h
> @@ -42,6 +42,11 @@
> #define CPPC_EPP_PERFORMANCE_PREF 0x00
> #define CPPC_EPP_ENERGY_EFFICIENCY_PREF 0xFF
>
> +#define CPPC_PERF_LIMITED_DESIRED_EXCURSION BIT(0)
> +#define CPPC_PERF_LIMITED_MINIMUM_EXCURSION BIT(1)
> +#define CPPC_PERF_LIMITED_MASK (CPPC_PERF_LIMITED_DESIRED_EXCURSION | \
> + CPPC_PERF_LIMITED_MINIMUM_EXCURSION)
> +
> /* Each register has the folowing format. */
> struct cpc_reg {
> u8 descriptor;
> @@ -177,6 +182,8 @@ extern int cppc_get_min_perf(int cpu, u64 *min_perf);
> extern int cppc_set_min_perf(int cpu, u32 min_perf);
> extern int cppc_get_max_perf(int cpu, u64 *max_perf);
> extern int cppc_set_max_perf(int cpu, u32 max_perf);
> +extern int cppc_get_perf_limited(int cpu, u64 *perf_limited);
> +extern int cppc_set_perf_limited(int cpu, u64 perf_limited);
> extern int amd_get_highest_perf(unsigned int cpu, u32 *highest_perf);
> extern int amd_get_boost_ratio_numerator(unsigned int cpu, u64 *numerator);
> extern int amd_detect_prefcore(bool *detected);
> @@ -285,6 +292,14 @@ static inline int cppc_set_max_perf(int cpu, u32 max_perf)
> {
> return -EOPNOTSUPP;
> }
> +static inline int cppc_get_perf_limited(int cpu, u64 *perf_limited)
> +{
> + return -EOPNOTSUPP;
> +}
> +static inline int cppc_set_perf_limited(int cpu, u64 perf_limited)
> +{
> + return -EOPNOTSUPP;
> +}
> static inline int amd_get_highest_perf(unsigned int cpu, u32 *highest_perf)
> {
> return -ENODEV;
Powered by blists - more mailing lists