Message-ID: <20180304060014-mutt-send-email-mst@kernel.org>
Date:   Sun, 4 Mar 2018 06:04:56 +0200
From:   "Michael S. Tsirkin" <mst@...hat.com>
To:     Siwei Liu <loseweigh@...il.com>
Cc:     Sridhar Samudrala <sridhar.samudrala@...el.com>,
        Stephen Hemminger <stephen@...workplumber.org>,
        David Miller <davem@...emloft.net>,
        Netdev <netdev@...r.kernel.org>, Jiri Pirko <jiri@...nulli.us>,
        virtio-dev@...ts.oasis-open.org,
        "Brandeburg, Jesse" <jesse.brandeburg@...el.com>,
        Alexander Duyck <alexander.h.duyck@...el.com>,
        Jakub Kicinski <kubakici@...pl>
Subject: Re: [PATCH v4 2/2] virtio_net: Extend virtio to use VF datapath when
 available

On Fri, Mar 02, 2018 at 03:56:31PM -0800, Siwei Liu wrote:
> On Fri, Mar 2, 2018 at 1:36 PM, Michael S. Tsirkin <mst@...hat.com> wrote:
> > On Fri, Mar 02, 2018 at 01:11:56PM -0800, Siwei Liu wrote:
> >> On Thu, Mar 1, 2018 at 12:08 PM, Sridhar Samudrala
> >> <sridhar.samudrala@...el.com> wrote:
> >> > This patch enables virtio_net to switch over to a VF datapath when a VF
> >> > netdev is present with the same MAC address. It allows live migration
> >> > of a VM with a direct attached VF without the need to setup a bond/team
> >> > between a VF and virtio net device in the guest.
> >> >
> >> > The hypervisor needs to enable only one datapath at any time so that
> >> > packets don't get looped back to the VM over the other datapath. When a VF
> >> > is plugged, the virtio datapath link state can be marked as down. The
> >> > hypervisor needs to unplug the VF device from the guest on the source host
> >> > and reset the MAC filter of the VF to initiate failover of datapath to
> >> > virtio before starting the migration. After the migration is completed,
> >> > the destination hypervisor sets the MAC filter on the VF and plugs it back
> >> > to the guest to switch over to VF datapath.
> >> >
> >> > When BACKUP feature is enabled, an additional netdev(bypass netdev) is
> >> > created that acts as a master device and tracks the state of the 2 lower
> >> > netdevs. The original virtio_net netdev is marked as 'backup' netdev and a
> >> > passthru device with the same MAC is registered as 'active' netdev.
> >> >
> >> > This patch is based on the discussion initiated by Jesse on this thread.
> >> > https://marc.info/?l=linux-virtualization&m=151189725224231&w=2
> >> >
> >> > Signed-off-by: Sridhar Samudrala <sridhar.samudrala@...el.com>
> >> > Signed-off-by: Alexander Duyck <alexander.h.duyck@...el.com>
> >> > Reviewed-by: Jesse Brandeburg <jesse.brandeburg@...el.com>
> >> > ---
> >> >  drivers/net/virtio_net.c | 683 ++++++++++++++++++++++++++++++++++++++++++++++-
> >> >  1 file changed, 682 insertions(+), 1 deletion(-)
> >> >
> >> > diff --git a/drivers/net/virtio_net.c b/drivers/net/virtio_net.c
> >> > index bcd13fe906ca..f2860d86c952 100644
> >> > --- a/drivers/net/virtio_net.c
> >> > +++ b/drivers/net/virtio_net.c
> >> > @@ -30,6 +30,8 @@
> >> >  #include <linux/cpu.h>
> >> >  #include <linux/average.h>
> >> >  #include <linux/filter.h>
> >> > +#include <linux/netdevice.h>
> >> > +#include <linux/pci.h>
> >> >  #include <net/route.h>
> >> >  #include <net/xdp.h>
> >> >
> >> > @@ -206,6 +208,9 @@ struct virtnet_info {
> >> >         u32 speed;
> >> >
> >> >         unsigned long guest_offloads;
> >> > +
> >> > +       /* upper netdev created when BACKUP feature enabled */
> >> > +       struct net_device *bypass_netdev;
> >> >  };
> >> >
> >> >  struct padded_vnet_hdr {
> >> > @@ -2236,6 +2241,22 @@ static int virtnet_xdp(struct net_device *dev, struct netdev_bpf *xdp)
> >> >         }
> >> >  }
> >> >
> >> > +static int virtnet_get_phys_port_name(struct net_device *dev, char *buf,
> >> > +                                     size_t len)
> >> > +{
> >> > +       struct virtnet_info *vi = netdev_priv(dev);
> >> > +       int ret;
> >> > +
> >> > +       if (!virtio_has_feature(vi->vdev, VIRTIO_NET_F_BACKUP))
> >> > +               return -EOPNOTSUPP;
> >> > +
> >> > +       ret = snprintf(buf, len, "_bkup");
> >> > +       if (ret >= len)
> >> > +               return -EOPNOTSUPP;
> >> > +
> >> > +       return 0;
> >> > +}
> >> > +
> >>
> >> What if the systemd/udevd is not new enough to enforce the
> >> n<phys_port_name> naming? Would virtio_bypass get a different name
> >> than the original virtio_net?
> >
> > You mean people using ethX names? Any hardware config change breaks
> > these, I don't think that can be helped.
> 
> I don't like the way to rely on .ndo_get_phys_port_name - it's fragile
> and it does not completely solve the problem it tries to address.
> Imagine what can end up with if getting an old udevd, or users already
> have exsiting explicit udev rules around phys_port_name. It does not
> give you the an ack in saying "yes, I know you're the bypass and
> you're the backup, please continue and I will give you both correct
> names", or an unacknowlegment saying "no, I don't know what these
> extra interfaces are, please go back and leave the VF device alone".
> We need new udev API for both feature negotiation and naming, or may
> even completely hide the lower interfaces.

Go ahead and try to make this happen, but I won't hold my
breath.

> >
> >> Should we detect this earlier and fall
> >> back to legacy mode without creating the bypass netdev and ensalving
> >> the VF?
> >
> > I don't think we can do this with existing kernel/userspace APIs.
> 
> That's why I ever said to make udev aware of this new type of combined
> device instead of doing hacks here and there around.
> 
> Regards,
> -Siwei

We can add new interfaces on top but the main purpose here is to
make old userspace do new tricks.

> >
> > --
> > MST

Powered by blists - more mailing lists