| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-Id: <20181215025035.26977-1-vivien.didelot@gmail.com>
Date: Fri, 14 Dec 2018 21:50:28 -0500
From: Vivien Didelot <vivien.didelot@...il.com>
To: netdev@...r.kernel.org
Cc: Chris Healy <cphealy@...il.com>,
Vivien Didelot <vivien.didelot@...il.com>,
"John W . Linville" <linville@...driver.com>, f.fainelli@...il.com,
andrew@...n.ch
Subject: [PATCH 0/7] ethtool: add pretty dump for DSA mv88e6xxx drivers
This patch series adds support to pretty dump the registers of user
ports created by the kernel "dsa" subsystem.
The first patch adds the base support for "dsa" interfaces.
The second patch adds the boilerplate for the "mv88e6xxx" DSA driver,
all using 32 registers of 16 bits, the switch ID being available in
the port identification register 3. Support for other DSA drivers such
as "b53" or "ksz" can be added similarly later. Because the different
switches supported by mv88e6xxx have slightly different register layout,
we keep it simple and stupid by providing one dump function per switch.
The remaining patches add support for the switch models currently
supported by the mv88e6xxx driver. Here's an example of dump of the
32 registers of a 88E6352 port:
# ethtool -d lan3
88E6352 Switch Port Registers
------------------------------
00: Port Status 0x500f
Pause Enabled 0
My Pause 1
802.3 PHY Detected 1
Link Status Down
Duplex Half
Speed 10 Mbps
EEE Enabled 0
Transmitter Paused 0
Flow Control 0
Config Mode 0xf
01: Physical Control 0x0003
RGMII Receive Timing Control Default
RGMII Transmit Timing Control Default
200 BASE Mode 100
Flow Control's Forced value 0
Force Flow Control 0
Link's Forced value Down
Force Link 0
Duplex's Forced value Half
Force Duplex 0
Force Speed Not forced
02: Jamming Control 0x0000
03: Switch Identifier 0x3521
04: Port Control 0x0433
Source Address Filtering controls Disabled
Egress Mode Unmodified
Ingress & Egress Header Mode 0
IGMP and MLD Snooping 1
Frame Mode Normal
VLAN Tunnel 0
TagIfBoth 0
Initial Priority assignment Tag & IP Priority
Egress Flooding mode No unknown DA
Port State Forwarding
05: Port Control 1 0x0000
Message Port 0
Trunk Port 0
Trunk ID 0
FID[11:4] 0x000
06: Port Base VLAN Map (Header) 0x0060
FID[3:0] 0x000
VLANTable 5 6
07: Default VLAN ID & Priority 0x0000
Default Priority 0x0
Force to use Default VID 0
Default VLAN Identifier 0
08: Port Control 2 0x2080
Force good FCS in the frame 0
Jumbo Mode 10240
802.1QMode Disabled
Discard Tagged Frames 0
Discard Untagged Frames 0
Map using DA hits 1
ARP Mirror enable 0
Egress Monitor Source Port 0
Ingress Monitor Source Port 0
Use Default Queue Priority 0
Default Queue Priority 0x0
09: Egress Rate Control 0x0001
10: Egress Rate Control 2 0x0000
11: Port Association Vector 0x0001
12: Port ATU Control 0x0000
13: Override 0x0000
14: Policy Control 0x0000
15: Port Ether Type 0x9100
16: InDiscardsLo Frame Counter 0x0000
17: InDiscardsHi Frame Counter 0x0000
18: InFiltered/TcamCtr Frame Counter 0x0000
19: Rx Frame Counter 0x0000
20: Reserved 0x0000
21: Reserved 0x0000
22: LED Control 0x0022
23: Reserved 0x0000
24: Tag Remap 0-3 0x3210
25: Tag Remap 4-7 0x7654
26: Reserved 0x0000
27: Queue Counters 0x8000
28: Reserved 0x0000
29: Reserved 0x0000
30: Reserved 0x0000
31: Reserved 0x0000
Vivien Didelot (7):
ethtool: dsa: add pretty dump
ethtool: dsa: mv88e6xxx: add pretty dump
ethtool: dsa: mv88e6xxx: add pretty dump for 88E6185
ethtool: dsa: mv88e6xxx: add pretty dump for 88E6161
ethtool: dsa: mv88e6xxx: add pretty dump for 88E6352
ethtool: dsa: mv88e6xxx: add pretty dump for 88E6390
ethtool: dsa: mv88e6xxx: pretty dump others
Makefile.am | 2 +-
dsa.c | 685 ++++++++++++++++++++++++++++++++++++++++++++++++++++
ethtool.c | 1 +
internal.h | 3 +
4 files changed, 690 insertions(+), 1 deletion(-)
create mode 100644 dsa.c
--
2.19.2
Powered by blists - more mailing lists