| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <1621402253-27200-11-git-send-email-tanghui20@huawei.com>
Date: Wed, 19 May 2021 13:30:43 +0800
From: Hui Tang <tanghui20@...wei.com>
To: <davem@...emloft.net>, <kuba@...nel.org>
CC: <netdev@...r.kernel.org>, <linux-kernel@...r.kernel.org>,
Hui Tang <tanghui20@...wei.com>,
Lorenzo Bianconi <lorenzo@...nel.org>
Subject: [PATCH 10/20] net: marvell: remove leading spaces before tabs
There are a few leading spaces before tabs and remove it by running the
following commard:
$ find . -name '*.c' | xargs sed -r -i 's/^[ ]+\t/\t/'
$ find . -name '*.h' | xargs sed -r -i 's/^[ ]+\t/\t/'
Cc: Lorenzo Bianconi <lorenzo@...nel.org>
Signed-off-by: Hui Tang <tanghui20@...wei.com>
---
drivers/net/ethernet/marvell/skge.h | 2 +-
drivers/net/ethernet/marvell/sky2.c | 30 +++++++++++++++---------------
drivers/net/ethernet/marvell/sky2.h | 8 ++++----
3 files changed, 20 insertions(+), 20 deletions(-)
diff --git a/drivers/net/ethernet/marvell/skge.h b/drivers/net/ethernet/marvell/skge.h
index 6928abc..f722173 100644
--- a/drivers/net/ethernet/marvell/skge.h
+++ b/drivers/net/ethernet/marvell/skge.h
@@ -263,7 +263,7 @@ enum {
CHIP_ID_YUKON_LP = 0xb2, /* Chip ID for YUKON-LP */
CHIP_ID_YUKON_XL = 0xb3, /* Chip ID for YUKON-2 XL */
CHIP_ID_YUKON_EC = 0xb6, /* Chip ID for YUKON-2 EC */
- CHIP_ID_YUKON_FE = 0xb7, /* Chip ID for YUKON-2 FE */
+ CHIP_ID_YUKON_FE = 0xb7, /* Chip ID for YUKON-2 FE */
CHIP_REV_YU_LITE_A1 = 3, /* Chip Rev. for YUKON-Lite A1,A2 */
CHIP_REV_YU_LITE_A3 = 7, /* Chip Rev. for YUKON-Lite A3 */
diff --git a/drivers/net/ethernet/marvell/sky2.c b/drivers/net/ethernet/marvell/sky2.c
index 222c323..324c280 100644
--- a/drivers/net/ethernet/marvell/sky2.c
+++ b/drivers/net/ethernet/marvell/sky2.c
@@ -471,7 +471,7 @@ static void sky2_phy_init(struct sky2_hw *hw, unsigned port)
adv |= fiber_fc_adv[sky2->flow_mode];
} else {
reg |= GM_GPCR_AU_FCT_DIS;
- reg |= gm_fc_disable[sky2->flow_mode];
+ reg |= gm_fc_disable[sky2->flow_mode];
/* Forward pause packets to GMAC? */
if (sky2->flow_mode & FC_RX)
@@ -1656,16 +1656,16 @@ static void sky2_hw_up(struct sky2_port *sky2)
tx_init(sky2);
/*
- * On dual port PCI-X card, there is an problem where status
+ * On dual port PCI-X card, there is an problem where status
* can be received out of order due to split transactions
*/
if (otherdev && netif_running(otherdev) &&
- (cap = pci_find_capability(hw->pdev, PCI_CAP_ID_PCIX))) {
- u16 cmd;
+ (cap = pci_find_capability(hw->pdev, PCI_CAP_ID_PCIX))) {
+ u16 cmd;
cmd = sky2_pci_read16(hw, cap + PCI_X_CMD);
- cmd &= ~PCI_X_CMD_MAX_SPLIT;
- sky2_pci_write16(hw, cap + PCI_X_CMD, cmd);
+ cmd &= ~PCI_X_CMD_MAX_SPLIT;
+ sky2_pci_write16(hw, cap + PCI_X_CMD, cmd);
}
sky2_mac_init(hw, port);
@@ -1836,8 +1836,8 @@ static netdev_tx_t sky2_xmit_frame(struct sk_buff *skb,
u16 mss;
u8 ctrl;
- if (unlikely(tx_avail(sky2) < tx_le_req(skb)))
- return NETDEV_TX_BUSY;
+ if (unlikely(tx_avail(sky2) < tx_le_req(skb)))
+ return NETDEV_TX_BUSY;
len = skb_headlen(skb);
mapping = dma_map_single(&hw->pdev->dev, skb->data, len,
@@ -1866,9 +1866,9 @@ static netdev_tx_t sky2_xmit_frame(struct sk_buff *skb,
if (!(hw->flags & SKY2_HW_NEW_LE))
mss += ETH_HLEN + ip_hdrlen(skb) + tcp_hdrlen(skb);
- if (mss != sky2->tx_last_mss) {
+ if (mss != sky2->tx_last_mss) {
le = get_tx_le(sky2, &slot);
- le->addr = cpu_to_le32(mss);
+ le->addr = cpu_to_le32(mss);
if (hw->flags & SKY2_HW_NEW_LE)
le->opcode = OP_MSS | HW_OWNER;
@@ -1895,8 +1895,8 @@ static netdev_tx_t sky2_xmit_frame(struct sk_buff *skb,
/* Handle TCP checksum offload */
if (skb->ip_summed == CHECKSUM_PARTIAL) {
/* On Yukon EX (some versions) encoding change. */
- if (hw->flags & SKY2_HW_AUTO_TX_SUM)
- ctrl |= CALSUM; /* auto checksum */
+ if (hw->flags & SKY2_HW_AUTO_TX_SUM)
+ ctrl |= CALSUM; /* auto checksum */
else {
const unsigned offset = skb_transport_offset(skb);
u32 tcpsum;
@@ -2557,7 +2557,7 @@ static struct sk_buff *receive_new(struct sky2_port *sky2,
static struct sk_buff *sky2_receive(struct net_device *dev,
u16 length, u32 status)
{
- struct sky2_port *sky2 = netdev_priv(dev);
+ struct sky2_port *sky2 = netdev_priv(dev);
struct rx_ring_info *re = sky2->rx_ring + sky2->rx_next;
struct sk_buff *skb = NULL;
u16 count = (status & GMR_FS_LEN) >> 16;
@@ -5063,11 +5063,11 @@ static int sky2_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
if (!disable_msi && pci_enable_msi(pdev) == 0) {
err = sky2_test_msi(hw);
if (err) {
- pci_disable_msi(pdev);
+ pci_disable_msi(pdev);
if (err != -EOPNOTSUPP)
goto err_out_free_netdev;
}
- }
+ }
netif_napi_add(dev, &hw->napi, sky2_poll, NAPI_WEIGHT);
diff --git a/drivers/net/ethernet/marvell/sky2.h b/drivers/net/ethernet/marvell/sky2.h
index b2dddd8..ddec162 100644
--- a/drivers/net/ethernet/marvell/sky2.h
+++ b/drivers/net/ethernet/marvell/sky2.h
@@ -538,8 +538,8 @@ enum {
CHIP_ID_YUKON_EC_U = 0xb4, /* YUKON-2 EC Ultra */
CHIP_ID_YUKON_EX = 0xb5, /* YUKON-2 Extreme */
CHIP_ID_YUKON_EC = 0xb6, /* YUKON-2 EC */
- CHIP_ID_YUKON_FE = 0xb7, /* YUKON-2 FE */
- CHIP_ID_YUKON_FE_P = 0xb8, /* YUKON-2 FE+ */
+ CHIP_ID_YUKON_FE = 0xb7, /* YUKON-2 FE */
+ CHIP_ID_YUKON_FE_P = 0xb8, /* YUKON-2 FE+ */
CHIP_ID_YUKON_SUPR = 0xb9, /* YUKON-2 Supreme */
CHIP_ID_YUKON_UL_2 = 0xba, /* YUKON-2 Ultra 2 */
CHIP_ID_YUKON_OPT = 0xbc, /* YUKON-2 Optima */
@@ -2262,8 +2262,8 @@ struct sky2_port {
#define SKY2_FLAG_AUTO_SPEED 0x0002
#define SKY2_FLAG_AUTO_PAUSE 0x0004
- enum flow_control flow_mode;
- enum flow_control flow_status;
+ enum flow_control flow_mode;
+ enum flow_control flow_status;
#ifdef CONFIG_SKY2_DEBUG
struct dentry *debugfs;
--
2.8.1
Powered by blists - more mailing lists