| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <20210604203938.gxmkm3prrmkgc7fl@skbuf>
Date: Fri, 4 Jun 2021 23:39:38 +0300
From: Vladimir Oltean <olteanv@...il.com>
To: George McCollister <george.mccollister@...il.com>
Cc: netdev <netdev@...r.kernel.org>, Andrew Lunn <andrew@...n.ch>,
Vivien Didelot <vivien.didelot@...il.com>,
Florian Fainelli <f.fainelli@...il.com>,
"David S. Miller" <davem@...emloft.net>,
Jakub Kicinski <kuba@...nel.org>,
open list <linux-kernel@...r.kernel.org>
Subject: Re: [PATCH net-next] net: dsa: xrs700x: allow HSR/PRP supervision
dupes for node_table
On Fri, Jun 04, 2021 at 02:50:31PM -0500, George McCollister wrote:
> On Fri, Jun 4, 2021 at 1:55 PM Vladimir Oltean <olteanv@...il.com> wrote:
> >
> > On Fri, Jun 04, 2021 at 11:29:22AM -0500, George McCollister wrote:
> > > Add an inbound policy filter which matches the HSR/PRP supervision
> > > MAC range and forwards to the CPU port without discarding duplicates.
> > > This is required to correctly populate time_in[A] and time_in[B] in the
> > > HSR/PRP node_table. Leave the policy disabled by default and
> > > enable/disable it when joining/leaving hsr.
> > >
> > > Signed-off-by: George McCollister <george.mccollister@...il.com>
> > > ---
> >
> > What happens if duplicates are discarded for supervision frames and
> > time_in[A] or time_in[B] is not updated in the node table?
>
> It'll indicate an error condition that doesn't exist though everything
> will work just fine.
> It'll call hsr_nl_ringerror() and show only time_in[A] or time_in[B]
> updating in /sys/kernel/debug/hsr/hsr0/node_table.
I see.
> IEC 62439-3 specifies an SNMP MIB that contains the node_table. I've
> implemented Net-SNMP mibgroup code to provide the node table data for
> remote monitoring.
>
> Basically if time_in[A] and time_in[B] aren't both updating it means:
> For HSR there is a break in the ring.
> For PRP: A device has a cable connecting to a switch unplugged or a failed port.
>
> >
> > > drivers/net/dsa/xrs700x/xrs700x.c | 67 +++++++++++++++++++++++++++++++++++++++
> > > 1 file changed, 67 insertions(+)
> > >
> > > diff --git a/drivers/net/dsa/xrs700x/xrs700x.c b/drivers/net/dsa/xrs700x/xrs700x.c
> > > index fde6e99274b6..a79066174a77 100644
> > > --- a/drivers/net/dsa/xrs700x/xrs700x.c
> > > +++ b/drivers/net/dsa/xrs700x/xrs700x.c
> > > @@ -79,6 +79,9 @@ static const struct xrs700x_mib xrs700x_mibs[] = {
> > > XRS700X_MIB(XRS_EARLY_DROP_L, "early_drop", tx_dropped),
> > > };
> > >
> > > +static const u8 eth_hsrsup_addr[ETH_ALEN] = {
> > > + 0x01, 0x15, 0x4e, 0x00, 0x01, 0x00};
> > > +
> >
> > What if the user sets a different last address byte for supervision frames?
>
> Below I only actually use 40 bits in the policy. See comment in the code.
Yes, I didn't reach that far with reading.
> >
> > > static void xrs700x_get_strings(struct dsa_switch *ds, int port,
> > > u32 stringset, u8 *data)
> > > {
> > > @@ -329,6 +332,50 @@ static int xrs700x_port_add_bpdu_ipf(struct dsa_switch *ds, int port)
> > > return 0;
> > > }
> > >
> > > +/* Add an inbound policy filter which matches the HSR/PRP supervision MAC
> > > + * range and forwards to the CPU port without discarding duplicates.
> > > + * This is required to correctly populate the HSR/PRP node_table.
> > > + * Leave the policy disabled, it will be enabled as needed.
> > > + */
> > > +static int xrs700x_port_add_hsrsup_ipf(struct dsa_switch *ds, int port)
> > > +{
> > > + struct xrs700x *priv = ds->priv;
> > > + unsigned int val = 0;
> > > + int i = 0;
> > > + int ret;
> > > +
> > > + /* Compare 40 bits of the destination MAC address. */
> > > + ret = regmap_write(priv->regmap, XRS_ETH_ADDR_CFG(port, 1), 40 << 2);
> > > + if (ret)
> > > + return ret;
> > > +
> > > + /* match HSR/PRP supervision destination 01:15:4e:00:01:XX */
> > > + for (i = 0; i < sizeof(eth_hsrsup_addr); i += 2) {
> > > + ret = regmap_write(priv->regmap, XRS_ETH_ADDR_0(port, 1) + i,
> > > + eth_hsrsup_addr[i] |
> > > + (eth_hsrsup_addr[i + 1] << 8));
> > > + if (ret)
> > > + return ret;
> > > + }
> > > +
> > > + /* Mirror HSR/PRP supervision to CPU port */
> > > + for (i = 0; i < ds->num_ports; i++) {
> > > + if (dsa_is_cpu_port(ds, i))
> > > + val |= BIT(i);
> > > + }
> > > +
> > > + ret = regmap_write(priv->regmap, XRS_ETH_ADDR_FWD_MIRROR(port, 1), val);
> > > + if (ret)
> > > + return ret;
> > > +
> > > + /* Allow must be set prevent duplicate discard */
> > > + ret = regmap_write(priv->regmap, XRS_ETH_ADDR_FWD_ALLOW(port, 1), val);
> > > + if (ret)
> > > + return ret;
> > > +
> > > + return 0;
> > > +}
> > > +
> > > static int xrs700x_port_setup(struct dsa_switch *ds, int port)
> > > {
> > > bool cpu_port = dsa_is_cpu_port(ds, port);
> > > @@ -358,6 +405,10 @@ static int xrs700x_port_setup(struct dsa_switch *ds, int port)
> > > ret = xrs700x_port_add_bpdu_ipf(ds, port);
> > > if (ret)
> > > return ret;
> > > +
> > > + ret = xrs700x_port_add_hsrsup_ipf(ds, port);
> > > + if (ret)
> > > + return ret;
> > > }
> > >
> > > return 0;
> > > @@ -565,6 +616,14 @@ static int xrs700x_hsr_join(struct dsa_switch *ds, int port,
> > > XRS_PORT_FORWARDING);
> > > regmap_fields_write(priv->ps_forward, port, XRS_PORT_FORWARDING);
> > >
> > > + /* Enable inbound policy added by xrs700x_port_add_hsrsup_ipf()
> > > + * which allows HSR/PRP supervision forwarding to the CPU port without
> > > + * discarding duplicates.
> > > + */
> > > + regmap_update_bits(priv->regmap,
> > > + XRS_ETH_ADDR_CFG(partner->index, 1), 1, 1);
> > > + regmap_update_bits(priv->regmap, XRS_ETH_ADDR_CFG(port, 1), 1, 1);
> > > +
> > > hsr_pair[0] = port;
> > > hsr_pair[1] = partner->index;
> > > for (i = 0; i < ARRAY_SIZE(hsr_pair); i++) {
> > > @@ -611,6 +670,14 @@ static int xrs700x_hsr_leave(struct dsa_switch *ds, int port,
> > > XRS_PORT_FORWARDING);
> > > regmap_fields_write(priv->ps_forward, port, XRS_PORT_FORWARDING);
> > >
> > > + /* Disable inbound policy added by xrs700x_port_add_hsrsup_ipf()
> > > + * which allows HSR/PRP supervision forwarding to the CPU port without
> > > + * discarding duplicates.
> > > + */
> > > + regmap_update_bits(priv->regmap,
> > > + XRS_ETH_ADDR_CFG(partner->index, 1), 1, 0);
> > > + regmap_update_bits(priv->regmap, XRS_ETH_ADDR_CFG(port, 1), 1, 0);
> > > +
> > > hsr_pair[0] = port;
> > > hsr_pair[1] = partner->index;
> > > for (i = 0; i < ARRAY_SIZE(hsr_pair); i++) {
> > > --
> > > 2.11.0
> > >
Powered by blists - more mailing lists