[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID:
<MN0PR12MB59539C6540FA6B673A1A7FF8B722A@MN0PR12MB5953.namprd12.prod.outlook.com>
Date: Thu, 22 Jun 2023 18:43:02 +0000
From: "Pandey, Radhey Shyam" <radhey.shyam.pandey@....com>
To: Maxim Kochetkov <fido_max@...ox.ru>, "netdev@...r.kernel.org"
<netdev@...r.kernel.org>
CC: "David S. Miller" <davem@...emloft.net>, Eric Dumazet
<edumazet@...gle.com>, Jakub Kicinski <kuba@...nel.org>, Paolo Abeni
<pabeni@...hat.com>, "Simek, Michal" <michal.simek@....com>, Andrew Lunn
<andrew@...n.ch>, Robert Hancock <robert.hancock@...ian.com>,
"linux-arm-kernel@...ts.infradead.org"
<linux-arm-kernel@...ts.infradead.org>, "linux-kernel@...r.kernel.org"
<linux-kernel@...r.kernel.org>
Subject: RE: [PATCH v2 1/1] net: axienet: Move reset before DMA detection
> -----Original Message-----
> From: Maxim Kochetkov <fido_max@...ox.ru>
> Sent: Thursday, June 22, 2023 11:22 PM
> To: netdev@...r.kernel.org
> Cc: Maxim Kochetkov <fido_max@...ox.ru>; Pandey, Radhey Shyam
> <radhey.shyam.pandey@....com>; David S. Miller
> <davem@...emloft.net>; Eric Dumazet <edumazet@...gle.com>; Jakub
> Kicinski <kuba@...nel.org>; Paolo Abeni <pabeni@...hat.com>; Simek,
> Michal <michal.simek@....com>; Andrew Lunn <andrew@...n.ch>; Robert
> Hancock <robert.hancock@...ian.com>; linux-arm-
> kernel@...ts.infradead.org; linux-kernel@...r.kernel.org
> Subject: [PATCH v2 1/1] net: axienet: Move reset before DMA detection
>
> DMA detection will fail if axinet was started before (by boot loader,
:%s/axinet/axienet/g
> boot ROM, etc). In this state axinet will not start properly.
> XAXIDMA_TX_CDESC_OFFSET + 4 register (MM2S_CURDESC_MSB) is used to
> detect
> 64 DMA capability here. But datasheet says: When DMACR.RS is 1
> (axinet is in enabled state), CURDESC_PTR becomes Read Only (RO) and
> is used to fetch the first descriptor. So iowrite32()/ioread32() trick
> to this register to detect DMA will not work.
> So move axinet reset before DMA detection.
>
> Fixes: 04cc2da39698 ("net: axienet: reset core on initialization prior to MDIO
Is this fixes tag correct ? I think the failure is introduced after
f735c40ed93c net: axienet: Autodetect 64-bit DMA capability?
> access")
> Signed-off-by: Maxim Kochetkov <fido_max@...ox.ru>
> ---
> drivers/net/ethernet/xilinx/xilinx_axienet_main.c | 10 +++++-----
> 1 file changed, 5 insertions(+), 5 deletions(-)
>
> diff --git a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
> b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
> index 3e310b55bce2..734822321e0a 100644
> --- a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
> +++ b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
> @@ -2042,6 +2042,11 @@ static int axienet_probe(struct platform_device
> *pdev)
> goto cleanup_clk;
> }
>
> + /* Reset core now that clocks are enabled, prior to accessing MDIO
> */
> + ret = __axienet_device_reset(lp);
> + if (ret)
> + goto cleanup_clk;
> +
> /* Autodetect the need for 64-bit DMA pointers.
> * When the IP is configured for a bus width bigger than 32 bits,
> * writing the MSB registers is mandatory, even if they are all 0.
> @@ -2096,11 +2101,6 @@ static int axienet_probe(struct platform_device
> *pdev)
> lp->coalesce_count_tx = XAXIDMA_DFT_TX_THRESHOLD;
> lp->coalesce_usec_tx = XAXIDMA_DFT_TX_USEC;
>
> - /* Reset core now that clocks are enabled, prior to accessing MDIO
> */
> - ret = __axienet_device_reset(lp);
> - if (ret)
> - goto cleanup_clk;
> -
> ret = axienet_mdio_setup(lp);
> if (ret)
> dev_warn(&pdev->dev,
> --
> 2.40.1
Powered by blists - more mailing lists