[<prev] [next>] [thread-next>] [day] [month] [year] [list]
Message-Id: <20230622192245.116864-1-fido_max@inbox.ru>
Date: Thu, 22 Jun 2023 22:22:45 +0300
From: Maxim Kochetkov <fido_max@...ox.ru>
To: netdev@...r.kernel.org
Cc: Maxim Kochetkov <fido_max@...ox.ru>,
Robert Hancock <robert.hancock@...ian.com>,
Radhey Shyam Pandey <radhey.shyam.pandey@....com>,
"David S. Miller" <davem@...emloft.net>,
Eric Dumazet <edumazet@...gle.com>,
Jakub Kicinski <kuba@...nel.org>,
Paolo Abeni <pabeni@...hat.com>,
Michal Simek <michal.simek@....com>,
Andre Przywara <andre.przywara@....com>,
linux-arm-kernel@...ts.infradead.org,
linux-kernel@...r.kernel.org
Subject: [PATCH v4 1/1] net: axienet: Move reset before 64-bit DMA detection
64-bit DMA detection will fail if axienet was started before (by boot
loader, boot ROM, etc). In this state axienet will not start properly.
XAXIDMA_TX_CDESC_OFFSET + 4 register (MM2S_CURDESC_MSB) is used to detect
64-bit DMA capability here. But datasheet says: When DMACR.RS is 1
(axienet is in enabled state), CURDESC_PTR becomes Read Only (RO) and
is used to fetch the first descriptor. So iowrite32()/ioread32() trick
to this register to detect 64-bit DMA will not work.
So move axienet reset before 64-bit DMA detection.
Fixes: f735c40ed93c ("net: axienet: Autodetect 64-bit DMA capability")
Signed-off-by: Maxim Kochetkov <fido_max@...ox.ru>
Reviewed-by: Robert Hancock <robert.hancock@...ian.com>
Reviewed-by: Radhey Shyam Pandey <radhey.shyam.pandey@....com>
---
drivers/net/ethernet/xilinx/xilinx_axienet_main.c | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
index 3e310b55bce2..734822321e0a 100644
--- a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
+++ b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
@@ -2042,6 +2042,11 @@ static int axienet_probe(struct platform_device *pdev)
goto cleanup_clk;
}
+ /* Reset core now that clocks are enabled, prior to accessing MDIO */
+ ret = __axienet_device_reset(lp);
+ if (ret)
+ goto cleanup_clk;
+
/* Autodetect the need for 64-bit DMA pointers.
* When the IP is configured for a bus width bigger than 32 bits,
* writing the MSB registers is mandatory, even if they are all 0.
@@ -2096,11 +2101,6 @@ static int axienet_probe(struct platform_device *pdev)
lp->coalesce_count_tx = XAXIDMA_DFT_TX_THRESHOLD;
lp->coalesce_usec_tx = XAXIDMA_DFT_TX_USEC;
- /* Reset core now that clocks are enabled, prior to accessing MDIO */
- ret = __axienet_device_reset(lp);
- if (ret)
- goto cleanup_clk;
-
ret = axienet_mdio_setup(lp);
if (ret)
dev_warn(&pdev->dev,
--
2.40.1
Powered by blists - more mailing lists