| lists.openwall.net | lists / announce owl-users owl-dev john-users john-dev passwdqc-users yescrypt popa3d-users / oss-security kernel-hardening musl sabotage tlsify passwords / crypt-dev xvendor / Bugtraq Full-Disclosure linux-kernel linux-netdev linux-ext4 linux-hardening linux-cve-announce PHC | |
|
Open Source and information security mailing list archives
| ||
|
Message-ID: <Zszcps6bnCcdFa54@apocalypse>
Date: Mon, 26 Aug 2024 21:51:02 +0200
From: Andrea della Porta <andrea.porta@...e.com>
To: Bjorn Helgaas <helgaas@...nel.org>
Cc: Andrea della Porta <andrea.porta@...e.com>,
Michael Turquette <mturquette@...libre.com>,
Stephen Boyd <sboyd@...nel.org>, Rob Herring <robh@...nel.org>,
Krzysztof Kozlowski <krzk+dt@...nel.org>,
Conor Dooley <conor+dt@...nel.org>,
Florian Fainelli <florian.fainelli@...adcom.com>,
Broadcom internal kernel review list <bcm-kernel-feedback-list@...adcom.com>,
Linus Walleij <linus.walleij@...aro.org>,
Catalin Marinas <catalin.marinas@....com>,
Will Deacon <will@...nel.org>,
Derek Kiernan <derek.kiernan@....com>,
Dragan Cvetic <dragan.cvetic@....com>,
Arnd Bergmann <arnd@...db.de>,
Greg Kroah-Hartman <gregkh@...uxfoundation.org>,
Nicolas Ferre <nicolas.ferre@...rochip.com>,
Claudiu Beznea <claudiu.beznea@...on.dev>,
"David S. Miller" <davem@...emloft.net>,
Eric Dumazet <edumazet@...gle.com>,
Jakub Kicinski <kuba@...nel.org>, Paolo Abeni <pabeni@...hat.com>,
Saravana Kannan <saravanak@...gle.com>,
Bjorn Helgaas <bhelgaas@...gle.com>, linux-clk@...r.kernel.org,
devicetree@...r.kernel.org, linux-rpi-kernel@...ts.infradead.org,
linux-arm-kernel@...ts.infradead.org, linux-kernel@...r.kernel.org,
linux-gpio@...r.kernel.org, netdev@...r.kernel.org,
linux-pci@...r.kernel.org, linux-arch@...r.kernel.org,
Lee Jones <lee@...nel.org>, Andrew Lunn <andrew@...n.ch>,
Stefan Wahren <wahrenst@....net>
Subject: Re: [PATCH 03/11] PCI: of_property: Sanitize 32 bit PCI address
parsed from DT
Hi Bjorn,
On 10:24 Wed 21 Aug , Bjorn Helgaas wrote:
> On Tue, Aug 20, 2024 at 04:36:05PM +0200, Andrea della Porta wrote:
> > The of_pci_set_address() function parse devicetree PCI range specifier
>
> s/parse/parses/ ?
Ack.
>
> > assuming the address is 'sanitized' at the origin, i.e. without checking
> > whether the incoming address is 32 or 64 bit has specified in the flags.
> > In this way an address with no OF_PCI_ADDR_SPACE_MEM64 set in the flagss
>
> s/flagss/flags/
Ack.
>
> > could leak through and the upper 32 bits of the address will be set too,
> > and this violates the PCI specs stating that ion 32 bit address the upper
>
> s/ion/in/
Ack.
>
> > bit should be zero.
>
> I don't understand this code, so I'm probably missing something. It
> looks like the interesting path here is:
>
> of_pci_prop_ranges
> res = &pdev->resource[...];
> for (j = 0; j < num; j++) {
> val64 = res[j].start;
> of_pci_set_address(..., val64, 0, flags, false);
> + if (OF_PCI_ADDR_SPACE_MEM64)
> + prop[1] = upper_32_bits(val64);
> + else
> + prop[1] = 0;
>
> OF_PCI_ADDR_SPACE_MEM64 tells us about the size of the PCI bus
> address, but the address (val64) is a CPU physical address, not a PCI
> bus address, so I don't understand why of_pci_set_address() should use
> OF_PCI_ADDR_SPACE_MEM64 to clear part of the CPU address.
>
It all starts from of_pci_prop_ranges(), that is the caller of of_pci_set_address().
val64 (i.e. res[j].start) is the address part of a struct resource that has
its own flags. Those flags are directly translated to of_pci_range flags by
of_pci_get_addr_flags(), so any IORESOURCE_MEM_64 / IORESOURCE_MEM in the
resource flag will respectively become OF_PCI_ADDR_SPACE_MEM64 / OF_PCI_ADDR_SPACE_MEM32
in pci range.
What is advertised as 32 bit at the origin (val64) should not become a 64
bit PCI address at the output of of_pci_set_address(), so the upper 32 bit
portion should be dropped.
This is explicitly stated in [1] (see page 5), where a space code of 0b10
implies that the upper 32 bit of the address must be zeroed out.
Please note that of_pci_prop_ranges() will be called only in case
CONFIG_PCI_DYNAMIC_OF_NODES is enabled to populate ranges for pci bridges and
pci endpoint for which a quirk is declared, so I would say not a very
often recurring use case.
[1] - https://www.devicetree.org/open-firmware/bindings/pci/pci2_1.pdf
> Add blank lines between paragraphs.
Ack.
>
> > This could cause mapping translation mismatch on PCI devices (e.g. RP1)
> > that are expected to be addressed with a 64 bit address while advertising
> > a 32 bit address in the PCI config region.
> > Add a check in of_pci_set_address() to set upper 32 bits to zero in case
> > the address has no 64 bit flag set.
>
> Is this an indication of a DT error? Have you seen this cause a
> problem? If so, what does it look like to a user? I.e., how could a
> user find this patch if they saw a problem?
Not neccessarily a DT error, but an inconsistent representation of addresses
wrt the specs. I incidentally encountered this on RaspberryPi 5, where
the PCI config space for the RP1 endpoint shows 32 bit BARs (basically an
offset from zero) but the effective address to which the CPU can access the
device is 64 bit nonetheless (0x1f_00000000). I believe this is backed by
some non standard hw wiring.
Without this patch the range translation chain is broken, like this:
pcie@...000: <0x2000000 0x00 0x00 0x1f 0x00 0x00 0xfffffffc>;
~~~ chain breaks here ~~~
pci@0 : <0x82000000 0x1f 0x00 0x82000000 0x1f 0x00 0x00 0x600000>;
dev@0,0 : <0x01 0x00 0x00 0x82010000 0x1f 0x00 0x00 0x400000>;
rp1@0 : <0xc0 0x40000000 0x01 0x00 0x00 0x00 0x400000>;
while with the patch applied the chain correctly become:
pcie@...000: <0x2000000 0x00 0x00 0x1f 0x00 0x00 0xfffffffc>;
pci@0 : <0x82000000 0x00 0x00 0x82000000 0x00 0x00 0x00 0x600000>;
dev@0,0 : <0x01 0x00 0x00 0x82010000 0x00 0x00 0x00 0x400000>;
rp1@0 : <0xc0 0x40000000 0x01 0x00 0x00 0x00 0x400000>;
I'm not advocating here that this patch is fixing the behaviour on Rpi5, this
is just a nice side effect of the correct address representation. I think we can
also probably fix it by patching the pcie node in the devicetree like this:
pcie@...000: <0x2000000 0xi1f 0x00 0x1f 0x00 0x00 0xfffffffc>;
but this is of course just a 1:1 mapping, while the address will still be at
least 'virtually' unconsistent, showing 64 bit address wihile the 32 bit flag is
set.
The net symptoms to the user would be, in the case of the RP1, a platform driver
of one of its sub-peripheral that fails to be probed.
Many thanks,
Andrea
>
> > Signed-off-by: Andrea della Porta <andrea.porta@...e.com>
> > ---
> > drivers/pci/of_property.c | 5 ++++-
> > 1 file changed, 4 insertions(+), 1 deletion(-)
> >
> > diff --git a/drivers/pci/of_property.c b/drivers/pci/of_property.c
> > index 5a0b98e69795..77865facdb4a 100644
> > --- a/drivers/pci/of_property.c
> > +++ b/drivers/pci/of_property.c
> > @@ -60,7 +60,10 @@ static void of_pci_set_address(struct pci_dev *pdev, u32 *prop, u64 addr,
> > prop[0] |= flags | reg_num;
> > if (!reloc) {
> > prop[0] |= OF_PCI_ADDR_FIELD_NONRELOC;
> > - prop[1] = upper_32_bits(addr);
> > + if (FIELD_GET(OF_PCI_ADDR_FIELD_SS, flags) == OF_PCI_ADDR_SPACE_MEM64)
> > + prop[1] = upper_32_bits(addr);
> > + else
> > + prop[1] = 0;
> > prop[2] = lower_32_bits(addr);
> > }
> > }
> > --
> > 2.35.3
> >
Powered by blists - more mailing lists