[<prev] [next>] [<thread-prev] [thread-next>] [day] [month] [year] [list]
Message-ID: <a5876695-4c10-4789-8dda-8591d71e882d@huawei.com>
Date: Mon, 11 Aug 2025 21:16:48 +0800
From: Jijie Shao <shaojijie@...wei.com>
To: Heiko Stübner <heiko@...ech.de>, <davem@...emloft.net>,
<edumazet@...gle.com>, <kuba@...nel.org>, <pabeni@...hat.com>,
<andrew+netdev@...n.ch>, <horms@...nel.org>, <Frank.Sae@...or-comm.com>,
<hkallweit1@...il.com>, <linux@...linux.org.uk>
CC: <shaojijie@...wei.com>, <shenjian15@...wei.com>, <liuyonglong@...wei.com>,
<chenhao418@...wei.com>, <jonathan.cameron@...wei.com>,
<shameerali.kolothum.thodi@...wei.com>, <salil.mehta@...wei.com>,
<netdev@...r.kernel.org>, <linux-kernel@...r.kernel.org>
Subject: Re: [PATCH net-next 1/2] net: phy: motorcomm: Add support for PHY
LEDs on YT8521
on 2025/8/7 17:50, Heiko Stübner wrote:
> Am Mittwoch, 16. Juli 2025, 12:00:40 Mitteleuropäische Sommerzeit schrieb Jijie Shao:
>> Add minimal LED controller driver supporting
>> the most common uses with the 'netdev' trigger.
>>
>> Signed-off-by: Jijie Shao <shaojijie@...wei.com>
> On a Qnap TS233 NAS using this phy, I get the expected device LEDs
> to light up (with appropriate config via sysfs), so
>
> Tested-by: Heiko Stuebner <heiko@...ech.de>
>
> (haven't found a v2 yet yesterday, so hopefully still the right thread
> to reply to ;-) )
>
> Thanks
> Heiko
Thank you for testing; I will resend this patch shortly.
>
>
>> ---
>> drivers/net/phy/motorcomm.c | 120 ++++++++++++++++++++++++++++++++++++
>> 1 file changed, 120 insertions(+)
>>
>> diff --git a/drivers/net/phy/motorcomm.c b/drivers/net/phy/motorcomm.c
>> index 0e91f5d1a4fd..e1a1c3a1c9d0 100644
>> --- a/drivers/net/phy/motorcomm.c
>> +++ b/drivers/net/phy/motorcomm.c
>> @@ -213,6 +213,23 @@
>> #define YT8521_RC1R_RGMII_2_100_NS 14
>> #define YT8521_RC1R_RGMII_2_250_NS 15
>>
>> +/* LED CONFIG */
>> +#define YT8521_MAX_LEDS 3
>> +#define YT8521_LED0_CFG_REG 0xA00C
>> +#define YT8521_LED1_CFG_REG 0xA00D
>> +#define YT8521_LED2_CFG_REG 0xA00E
>> +#define YT8521_LED_ACT_BLK_IND BIT(13)
>> +#define YT8521_LED_FDX_ON_EN BIT(12)
>> +#define YT8521_LED_HDX_ON_EN BIT(11)
>> +#define YT8521_LED_TXACT_BLK_EN BIT(10)
>> +#define YT8521_LED_RXACT_BLK_EN BIT(9)
>> +/* 1000Mbps */
>> +#define YT8521_LED_GT_ON_EN BIT(6)
>> +/* 100Mbps */
>> +#define YT8521_LED_HT_ON_EN BIT(5)
>> +/* 10Mbps */
>> +#define YT8521_LED_BT_ON_EN BIT(4)
>> +
>> #define YTPHY_MISC_CONFIG_REG 0xA006
>> #define YTPHY_MCR_FIBER_SPEED_MASK BIT(0)
>> #define YTPHY_MCR_FIBER_1000BX (0x1 << 0)
>> @@ -1681,6 +1698,106 @@ static int yt8521_config_init(struct phy_device *phydev)
>> return phy_restore_page(phydev, old_page, ret);
>> }
>>
>> +static const unsigned long supported_trgs = (BIT(TRIGGER_NETDEV_FULL_DUPLEX) |
>> + BIT(TRIGGER_NETDEV_HALF_DUPLEX) |
>> + BIT(TRIGGER_NETDEV_LINK) |
>> + BIT(TRIGGER_NETDEV_LINK_10) |
>> + BIT(TRIGGER_NETDEV_LINK_100) |
>> + BIT(TRIGGER_NETDEV_LINK_1000) |
>> + BIT(TRIGGER_NETDEV_RX) |
>> + BIT(TRIGGER_NETDEV_TX));
>> +
>> +static int yt8521_led_hw_is_supported(struct phy_device *phydev, u8 index,
>> + unsigned long rules)
>> +{
>> + if (index >= YT8521_MAX_LEDS)
>> + return -EINVAL;
>> +
>> + /* All combinations of the supported triggers are allowed */
>> + if (rules & ~supported_trgs)
>> + return -EOPNOTSUPP;
>> +
>> + return 0;
>> +}
>> +
>> +static int yt8521_led_hw_control_set(struct phy_device *phydev, u8 index,
>> + unsigned long rules)
>> +{
>> + u16 val = 0;
>> +
>> + if (index >= YT8521_MAX_LEDS)
>> + return -EINVAL;
>> +
>> + if (test_bit(TRIGGER_NETDEV_LINK, &rules)) {
>> + val |= YT8521_LED_BT_ON_EN;
>> + val |= YT8521_LED_HT_ON_EN;
>> + val |= YT8521_LED_GT_ON_EN;
>> + }
>> +
>> + if (test_bit(TRIGGER_NETDEV_LINK_10, &rules))
>> + val |= YT8521_LED_BT_ON_EN;
>> +
>> + if (test_bit(TRIGGER_NETDEV_LINK_100, &rules))
>> + val |= YT8521_LED_HT_ON_EN;
>> +
>> + if (test_bit(TRIGGER_NETDEV_LINK_1000, &rules))
>> + val |= YT8521_LED_GT_ON_EN;
>> +
>> + if (test_bit(TRIGGER_NETDEV_FULL_DUPLEX, &rules))
>> + val |= YT8521_LED_HDX_ON_EN;
>> +
>> + if (test_bit(TRIGGER_NETDEV_HALF_DUPLEX, &rules))
>> + val |= YT8521_LED_FDX_ON_EN;
>> +
>> + if (test_bit(TRIGGER_NETDEV_TX, &rules) ||
>> + test_bit(TRIGGER_NETDEV_RX, &rules))
>> + val |= YT8521_LED_ACT_BLK_IND;
>> +
>> + if (test_bit(TRIGGER_NETDEV_TX, &rules))
>> + val |= YT8521_LED_TXACT_BLK_EN;
>> +
>> + if (test_bit(TRIGGER_NETDEV_RX, &rules))
>> + val |= YT8521_LED_RXACT_BLK_EN;
>> +
>> + return ytphy_write_ext(phydev, YT8521_LED0_CFG_REG + index, val);
>> +}
>> +
>> +static int yt8521_led_hw_control_get(struct phy_device *phydev, u8 index,
>> + unsigned long *rules)
>> +{
>> + int val;
>> +
>> + if (index >= YT8521_MAX_LEDS)
>> + return -EINVAL;
>> +
>> + val = ytphy_read_ext(phydev, YT8521_LED0_CFG_REG + index);
>> + if (val < 0)
>> + return val;
>> +
>> + if (val & YT8521_LED_TXACT_BLK_EN)
>> + set_bit(TRIGGER_NETDEV_TX, rules);
>> +
>> + if (val & YT8521_LED_RXACT_BLK_EN)
>> + set_bit(TRIGGER_NETDEV_RX, rules);
>> +
>> + if (val & YT8521_LED_FDX_ON_EN)
>> + set_bit(TRIGGER_NETDEV_FULL_DUPLEX, rules);
>> +
>> + if (val & YT8521_LED_HDX_ON_EN)
>> + set_bit(TRIGGER_NETDEV_HALF_DUPLEX, rules);
>> +
>> + if (val & YT8521_LED_GT_ON_EN)
>> + set_bit(TRIGGER_NETDEV_LINK_1000, rules);
>> +
>> + if (val & YT8521_LED_HT_ON_EN)
>> + set_bit(TRIGGER_NETDEV_LINK_100, rules);
>> +
>> + if (val & YT8521_LED_BT_ON_EN)
>> + set_bit(TRIGGER_NETDEV_LINK_10, rules);
>> +
>> + return 0;
>> +}
>> +
>> static int yt8531_config_init(struct phy_device *phydev)
>> {
>> struct device_node *node = phydev->mdio.dev.of_node;
>> @@ -2920,6 +3037,9 @@ static struct phy_driver motorcomm_phy_drvs[] = {
>> .soft_reset = yt8521_soft_reset,
>> .suspend = yt8521_suspend,
>> .resume = yt8521_resume,
>> + .led_hw_is_supported = yt8521_led_hw_is_supported,
>> + .led_hw_control_set = yt8521_led_hw_control_set,
>> + .led_hw_control_get = yt8521_led_hw_control_get,
>> },
>> {
>> PHY_ID_MATCH_EXACT(PHY_ID_YT8531),
>>
>
>
>
>
Powered by blists - more mailing lists